余热

样机的性能COP最大可达0.3016，平均值为0.2331，试验证明轿车发动机余热吸附式制冷是可行的。

Prototypical performance COP may reach 0.3016 , the mean value is 0.2331 . the experiments proved the car engine afterheat adsorption refrigeration is feasible .

并为中国氦冷固体增殖实验包层模块冷却剂丧失事故（LOCA）分析开发了一维喷放和余热排除计算模型。

A1-D flow discharge model for coolant blow-down and1-D heat transfer model for afterheat removal aiming at TBM LOCA analysis are developed .

把烤盘关掉，让余热把混合物再煨一下。

Turn the hotplate off and allow the residual heat to keep the mixture simmering .

PLC在余热发电工程中的应用

The PLC 's Application in the Spare - heat Generating Engineering

T&溶液温度，K；低温余热利用及其开发

T - temperature , K ; Low temperature exhaust heat and its exploitation

重油催化装置CO余热锅炉技术改造及效果

Technical Revamp and Effect Analysis of CO Waste Heat Boiler of Residual Oil FCC Unit

卷制余热弹簧试样的σb、δ及ψ都略低于重新加热淬火+回火试样，差别不明显；

σ b , δ and ψ are all a little lower than that of heat quenching spring and tempering sample .

DCS系统在硫酸余热发电过程中的应用

Application of DCS in Power Generating With the Redundant Heat from Sulphuric Acid Production

关于DG型硫酸余热锅炉设计、运行中的一些技术问题

Some Technical Problems ln Design And Run About the sulfuric Acid Surplus-heat DG Boiler

结合余热锅炉省煤器的工况条件，用扫描电镜及EDS、X射线等方法分析省煤器炉管腐蚀原因。

Corrosion analysis of economizer tube is investigated by SEM and EDS , X-ray etc with the condition of boiler economizer .

首先模拟H型钢喷水冷却时的温度场，根据模拟结果对H型钢的边部和腰部采用不同的冷却强度进行在线余热淬火。

Firstly , the spray cooling temperature field for H-beam was simulated . Then different cooling rates were adopted for edge and waist parts of the beams according to the simulated results .

高性能工业余热利用方式的CPL技术

High-performance CPL Technology for the Utilization of Industrial Residual Heat

某水泥厂余热电站FICIRC~（TM）循环流化床锅炉结焦原因的分析

Analysis of the FI CIRC ~ ( TM ) Fluidized Bed Boiler Slagging in Waste Heat Power Station in Cement Plant

小型化工厂某台50t余热锅炉的设计

Design Of a 50 t Heat Recovery Boiler for Small Chemical Factory

9F级自然循环余热锅炉的安装和调试

Installation and Adjustment of Natural Circulation Waste Heat Boilers of the 9F Class

本论文针对采用MODBUS协议的燃机和使用OMRONPLC控制器的余热锅炉系统间的数据通信交换展开研究工作。

In this paper , using MODBUS protocol for the use of gas and OMRON PLC controller of the waste heat boiler systems to exchange data communications to start the research .

研究表明：高效烟气余热回收、低空气系数、良好的火焰特性使高风温无焰燃烧锅炉的燃料节约率达55%，同时CO2排放可减少55%；

Analysis shows that high efficient heat-recirculation and low air excess ratio and good flame behavior lay out a high heat transfer performance with more than 55 % reduction of fuel savings and CO 2 to the environment .

由沼气发动机驱动的热泵（BHP）除能够保证一般热泵功能外，还能够充分回收利用沼气发动机的余热。

Biogas engine-driven heat pump ( BHP ) not only has the same functions of compression heat pump , but also can utilize the waste heat recovery from biogas engine .

ECS-100系统在转炉中压余热锅炉的设计与应用

Design and application of ECS-100 system in medium-pressure waste-heat boiler of converting furnace

350MW级燃气-蒸汽联合循环电站余热锅炉配置

Heat Recovery Steam Generator Choice of 350 MW Class Combined Cycle Power Plant

另外汽轮机DEH（电液调节控制系统），目前都是由汽轮机配套厂家来完成，相对于余热发电DCS控制系统是一个独立的孤岛。

In addition , Steam turbine electrohydraulic control system ( DEH ), it is completed by turbine manufacturers . It is an independent " island " to the waste heat power generation DCS control system .

选用JR型氨合成塔内件，能提高合成生产强度，有利于提高合成余热回收率。

Use of Model JR converter internals leads to an increase in the productivity of the converter , favorable to improvement on recovery of waste heat from the synthesis section .

氨水碱化烘干法在张家港电厂9F余热锅炉停炉保养中的应用

Application of Liquid Ammonia Alkalinization Drying Method in the Shut-Down Period Maintenance of 9F Heat Recovery Boiler of 395 MW Gas-Steam Combined Cycle Unit

460MPa级轧后余热处理钢筋

460 MPa Grade Bar by Remained Heat Treated

另外，CEFR又是世界上首次在堆内采用非能动手段来排出堆芯余热的池式快堆。

At the same time , CEFR is the first pool-type LMFBR ( Liquid Metal Fast Breeder Reactor ) using dacay heat removel system to .

泽布吕赫LNG接收终端气化-160℃的LNG热源是相邻热电厂的透平余热，综合利用热电厂与LNG接收终端的能量，取得了非常好的节能效果。

The turbine exhaust of the adjacent CHP plant is used as heating source of Zeebrugge receiving terminal to gasify LNG of - 160 ℃ . The efficient energy conservation has been achieved by comprehensive utilization of energy between CHP plant and LNG receiving terminal .

首批引进的重型（390MW级）燃气&蒸汽联合循环发电机组填补了国内空白，其配套的余热锅炉也采用引进技术。

The first imported groups of 390 MW class GTCC filled a civil blank . HRSG are introduced into the imported and advanced technology as one of the main machines .

AC600二次侧非能动应急堆芯余热排出系统实验装置是一座大型非能动安全系统实验研究装置。

The secondary side passive emergency Core residual heat removal system ( ECRHR System ) test facility is a large scale passive safety system experimental test rig , which is designed base on the thermal hydraulic simulating theory and criteria .

荆门分公司0.8Mt/年DCC-Ⅱ装置吸收-稳定系统解吸塔采用中间再沸器节能技术改造，以回收稳定汽油余热，降低解吸塔底再沸器热负荷。

The desorption tower in absorption and stabilization System of 0.8mt/Y DCC unit in Jingmen General Petrochemical Works was revamped with middle reboiler technology . The purpose of revamp was to decrease the quantity of heat of the bottom reboiler and reuse the heat of stabilization gasoline .

应用遗传算法优化设计热管式余热锅炉

Optimization Design of Heat Pipe Waste Heat Boiler With Genetic Algorithm