体视显微镜

用体视显微镜及活体循环检测系统动态观察活体基底动脉管径；颅骨开窗，在立体定向仪控制下，用激光多普勒血流计动态测量动物顶叶皮层rCBF。

Basilar artery diameter was measured using stereomicroscope and dynamic loop detection . rCBF was observed using laser Doppler flowmetry under control of stereotactic instrument .

采用体视显微镜、Tafel曲线、电化学阻抗谱和电化学噪声等方法对镀镍层以及复合镀镍层进行了研究。

Nickel and composite nickel coating are compared by methods of stereomicroscope , Tafel curve , electrochemical impedance spectroscopy ( EIS ), electrochemical noise , etc.

基于体视显微镜（StereoLightMicroscope，SLM）的显微立体视觉已经在微操作领域应用。

Micro stereovision with a stereo light microscope is applied in the area of micromanipulation .

方法：①采用体视显微镜观察EGCG对HL-60细胞生长的抑制作用；

Methods : ① The growth inhibition of EGCG treated HL-60 cells was observed under light microscopy ;

通过体视显微镜加上两路CCD视频信号模拟人的双眼，经过同步控制器的处理后，实现了立体视频的合成。

The authors apply the stereomicroscope and two CCD to simulate the eyes of human beings . The stereo video frequency signal was composed through the process of synchronous controller .

显微立体视觉是立体视觉技术在微观领域的应用，体视显微镜和CCD传感器构成了显微立体视觉系统的主体。

Micro stereo vision ( MSV ) is the application of stereo vision techniques in microcosmic domain . Stereo microscope and CCD sensors make the main components of a MSV system .

通常显微立体视觉系统以体视显微镜为基础，通过CCD传感器采集图像，再经图像采集卡将图像数字化成为PC机能够读取的格式。

Stereo microscope and CCD sensors make the main components of a MSV system . The image information collected by CCD sensors is transformed as digital image information by image capture card .

采用扫描电镜（SEM）和体视显微镜观察单颗粒金刚石切削混凝土沟槽表面形貌和切屑形态，并结合混凝土的特性及断裂力学性能，分析研究了混凝土材料的切削加工机理。

The topographies of cutting grooves and cutting chips were observed by means of scanning electronic microscope , and sawing mechanism of concrete was analyzed , based on the properties and fracture mechanics of concrete .

用体视显微镜（5～25倍）观察足三里新鲜标本层次和断面结构及ABS铸型、淋巴灌注标本。

The tissues in different layers and sections of the fresh sample taken from Zusanli acupoint were observed with microscope ( X5 ~ 25 ), using ABS mold and lymph perfusion methods .

显微双目立体视觉主要由体视显微镜和CCD图像传感器构成，基于计算机双目立体视觉原理，显微双目立体视觉在显微领域中用于三维微观定位和测量。

Binocular stereo micro vision ( BSMV ) based on the working principle of binocular computer stereo vision and mainly composed of stereo light microscope ( SLM ) and CCD image sensors is used for three-dimensional positioning and measurement in micro-domain .

0.5%碱性品红溶液中染色24h后，将充填体连续纵向剖开为四部分，体视显微镜下观察各剖面充填体边缘的微渗漏情况，并以扫描电镜观察树脂-牙本质界面的结合状态。

After dye penetration for 24 h with 0.5 % basic fuchsin solution , the restorations were then serially multi-sectioned . Microleakage was scored on each section under stereomicroscopy and the resin-dentin interface was also examined with SEM .

利用光学显微镜和体视显微镜对卷柏科Selaginellaceae中国产29种和泰国产1种植物的叶形态进行了宏观和微观观察。

Leaf morphology of 29 Chinese species and one Thailand species of the Selaginellaceae was observed under light microscope and stereoscope .

以不同的浸渍方式制备了Pt/γ-Al2O3催化剂，通过体视显微镜观察其分布型式，用5%CO/He脉冲化学吸附法研究了Pt在催化剂颗粒中的分散度。

Pt / γ - Al 2O 3 catalysts were prepared by different impregnation methods . The catalysts ' distribution models were observed by stereomicroscope . The metal dispersion on the surface of alumina was studied by 5 % CO / He pulse chemisorption .

为了观察测量PTA的位移输出，设计了由体视显微镜和CCD组成的观测装置，它可以在观察微机构工作的同时作出计量和记录。

To observe and measure micro displacement output of micro actuators , we design a special apparatus composed by CCD and stereoscopic microscope . Using this device , we can not only observe micro actuators , but also measure their deformations and record them .

体视显微镜下剪开牙乳头，将准备好的微孔滤膜置入，在DMEM中37℃培养箱中孵育24小时，制备好的重组体用于移植。

Cut under a stereomicroscope dental papilla , the prepared microporous membrane was inserted , and placed in DMEM were incubated at 37 ℃ in an incubator 24 hours of prepared recombinant was used for transplantation .

结果表明：当木薯淀粉为30g，马铃薯淀粉为20g时，在体视显微镜下，材料的泡孔大而且气泡分散均匀，材料的缓冲性最好。

The results showed that : At 30 grams tapioca starch , 20 grams potato starch , the products had big and evenly distributed bubble , and best performance of the buffer under the stereomicroscope .

本文收集6～11周胚胎手446例，足409例，Bouin液固定后在体视显微镜下测量手、足长度。

This article collects 446 embryo hands and 409 embryo feet . Their length were measured under stereoscopic microscope after fixing in Bouin 's fluid .

采用体视显微镜、扫描电镜等分析手段对K18合金增压器涡轮铸造叶片的断裂形貌与断裂机制等进行了分析。

By means of stereomicroscopy and scanning electronic microscopy ( SEM ), the fracture mode and mechanism of the broken K18 superalloy cast blade in a supercharger turbo were investigated .

分别计算各组胚胎的孵出率，存活率，畸形率和心率；体视显微镜观察形态学变化，AO染色和Alcian-Blue染色后观察斑马鱼胚胎及幼鱼颅面部软骨发育异常和细胞凋亡情况。

Hatching rate , survival rate , malformation rate and heart rate of each group were determined ; morphological changes were studied with stereomicroscope ; abnormal craniofacial development and apoptosis were observed by Alcian-Blue Stain and AO stain .

利用体视显微镜、金相显微镜、扫描电子显微镜观察分析了机械镀Zn-Al复合镀层的表面形貌和断口结构，对其孔隙率、结合强度、耐腐蚀性等性能进行检测，并分析添加铝对镀层性能的影响。

Surface morphology and structure of fracture surface of mechanical Zn-Al plating were studied using stereomicroscopy , metalloscopy and scanning electronic microscopy . The porosity , bonding strength and corrosion resistance were detected and the influence of adding Al on its cladding performance was analyzed .

观察了油田抽油机井破断油管断口部位的宏观形貌，并且在XTL-Ⅱ型体视显微镜和S-2500型扫描电镜上分析了断口的微观形貌特征。

This paper observes and distinguishes the macro-appearance of the oil tubing fractures of Daqing oil fields , and observes and analyzes the micro-appearance of the fractures deep under XTL - ⅱ type stereomicroscope and S - 2 500 type scanning electron microscope .

用体视显微镜和透射电镜观察内耳前庭器的形态

Morphological Investigation of Vestibular Apparatus by Stereo and Transmission Electron Microscopy

连续变倍体视显微镜共用前置物镜的设计

Design of a common-shared front objective in a novel zoom stereomicroscope

采用体视显微镜，考察了其对小鼠胃粘膜的影响。

Observe the gastric mucosal injury in mice by using stereomicroscope .

1×～6.3×连续变倍体视显微镜物镜的光学设计

Optical design of the 1 ×~ 6.3 × zoom stereo microscope objective

光学补偿式连续变倍体视显微镜的光学设计

The optical design of zoom stereomicroscope using optical compensation

连续变倍体视显微镜的设计及性能扩展

The Design of Zoom Stereomicroscope and its Function Expand

小型体视显微镜光路转折和角镜复制浅谈

Elementary Introduction to Turn of Optical Path of small Stereomicroscope and Angle-mirror 's Duplication

方法：用体视显微镜对10例成人固定尸体耳廓标本进行追踪观察。

Method : The external ears of 10 adult cadavers were observed with stereoscopy .

方法选用50具新鲜尸体，经乳胶灌注后，在体视显微镜下观察。

Methods A total of 50 fresh corpses injected with emulsion were studied by microscope .