酸洗

suān xǐ
  • pickling;acid pickling;dipping;scouring
酸洗酸洗
酸洗[suān xǐ]
  1. 本文介绍了一种新型的YZ-1型氮氧化物抑制剂,可用于铜件酸洗抛光时抑制氮氧化物的生成。

    A modern YZ-1 type inhibitor of nitric oxides is investigated , which can be used for brass articles in bright acid dipping to inhibit formation of nitrogen oxides .

  2. 抑制氮氧化物产生的铜件酸洗工艺

    Acid Dipping Process for Copper and Brass Article Capable of Inhibiting Formation of Nitrogen Oxides

  3. 介绍了酸洗线的工艺过程以及PLC的控制特点。

    The control characteristics of PLC and technology process of acid pickling are presented .

  4. PC钢棒在生产过程中采用机械弯曲除锈,不需酸洗。

    The production processes of the PC bar use the mechanical bending derusting without pickling .

  5. 纯积分PI算法在推拉式酸洗机组自动穿带中的应用

    Application of the integral algorithm in the Automatic Thread process of push pull pickling lines

  6. 水热处理Hβ沸石经酸洗后醚化活性进一步提高,叔碳烯烃的转化率达5917%。

    Acid-leaching of the steamed H β zeolite could improve its etherification activity and the conversion of tert-olefins could reach 59.17 % .

  7. NOx废气净化技术与不锈钢酸洗废气处理对策

    Purification Technology of Waste Industrial Gases Containing NO_x and Its Application in Treatment of Waste Gases From Stainless Steel Pickling Line

  8. 酸洗槽的温度控制是采用数字PID控制方式,通过调节石墨热交换器的蒸汽流量来实现的,投产后使用效果一直不理想。

    It is achieved by adjusting the steam flux of graphite heat exchanger . The effect is always unstable after in use .

  9. 酸洗槽的工艺段控制采用PID控制方式,投产后使用效果不是很理想。

    The process control of the pickling tank uses PID control ; the result is not very satisfactory when put into production .

  10. 酸洗机组No.3纠偏系统缺陷分析及功能优化

    Defect analysis and function optimization for No.3 CPC system of pickling line

  11. 应用MBR处理电厂锅炉酸洗废水的研究

    Research on applying MBR to treat the acid pickling wastewater for boilers in the power plant

  12. 研究了酸洗对煤粉燃烧过程中NO和SO2生成的影响。

    Experiments have been carried out to investigate the effects of acid washing on the generation of NO and SO2 in the coal combustion .

  13. HEDP在中央空调酸洗中除锈效果的研究

    Researches on the rust-removing effect of HEDP in central air-conditioner acid pickling Technology

  14. 酸洗对Ni-Ti合金力学性能的不良影响及消除

    Unfavored Influence and Elimination of Acid Etching on the Mechanical Properties of Ni & Ti Alloy

  15. 结果表明,交替洗脱法筛选出的特异性配体的回收率和ELISA信号值均优于酸洗脱法;

    Compared with the acid screening method , the modified strategy yielded higher peptide recovery and the selected phage clones showed higher signals of enzyme-linked immunosorbent assay ( ELISA ) .

  16. 在2℃以下饲养种酵母8~12h,用5%稀磷酸进行酸洗。

    8 ~ 12 h raise of yeast seed under 2 ℃ and washing by 5 % diluted phosphoric acid ;

  17. 按正交试验方法从生产线收集易于在线检测的钢板厚度、卷取温度、酸液温度、酸液流量四个工艺参数的数据,采用BP神经网络模型来预测酸洗结束时间。

    While easily online detected parameters , such as plate thickness , coiling temperature , acid temperature and flow , were selected using orthogonal test method to predict the acid endpoint based on BP neural network .

  18. 研究表明:经过HCl+HF酸洗去灰处理后的两种煤,NO生成量明显降低,SO2生成量有所增加;

    The experimental results show that two coals that were disposed by HCl + HF acid washing which NO generation obviously reduce , while the generation of SO2 increase ;

  19. 研究结果表明,经酸洗处理后,硬质合金基体含Co量对金刚石薄膜成核、生长没有太大影响。但对其附着强度有很大影响。

    The results show that the influence of Co content of carbide substrate on the forming nucleation and growth of diamond film is not great after acid picking treatment , but the influence on adhesive strength is too much .

  20. 醪垢的清洗方法有化学清洗法(碱煮法、酸洗法)、CIP清洗法、高压水射流清洗法。

    The cleaning methods of mash scale cover chemical cleaning ( soda boiling and pickling process ), CIP cleaning , and high pressure water washing .

  21. 通过正交试验设计方法研制了DY-1新型酸洗缓蚀剂。

    By using orthogonal experimental approach , a new restrainer DY-1 is developed .

  22. 新型不锈钢盐酸酸洗缓蚀剂BMAT缓蚀机理

    Inhibition mechanism of new inhibitor BMAT on stainless steel in chlorhydric acid

  23. 用失重法研究了N-甲基-2-巯基咪唑(MMI)在5%盐酸中对铜的酸洗缓蚀性能。

    The corrosion inhibition property of 2 mercapto N methy imidazole ( MMI ) for copper in 5 % HCl was studied using weight loss method .

  24. 为了净化酸洗及化学抛光过程中逸出的NOx气体,作者提出了用H2O2溶液代替常用的NaOH作为吸收液来氧化吸收NOx气体。

    In order to absorb NO_X gas evolved during the operation of etching and chemical polishing , it is suggested to use H_2O_2 as absorbing solution to oxidize and absorb NO_X gas , instead of the conventional NaOH solution .

  25. 汽车钢板酸洗用YH-2缓蚀剂的研制和应用

    Development and Application of YH-2 Inhibitor in Automotive Sheet Steel Pickling

  26. 多功能酸洗缓蚀剂Lan-926与Lan-826缓蚀性能的对比研究

    The comparative study of corrosion inhibitive effect between pickling inhibitor Lan-926 and Lan-826

  27. BMAT对盐酸酸洗中不锈钢-碳-钢电偶腐蚀的抑制作用

    Inhibition of BMAT on galvanic corrosion of stainless steel carbon steel in hydrochloric acid picking

  28. 分别对SiC颗粒进行高温氧化、酸洗和高温氧化后再酸洗等表面处理,采用粉末冶金工艺制备了SiC颗粒增强的6066Al基复合材料。

    The surface treatment of oxidation , acid-washing and acid-washing after oxidation were carried out on SiC particles , then 6066 aluminum alloy reinforced by SiC particles was fabricated by powder metallurgy route .

  29. KH-911酸雾抑制缓蚀剂在钢管酸洗生产中的应用

    Application of KH-911 acid mist inhibitor in steel Tubb acid pickling production

  30. 在酸洗脱液中微波辐射(最低能量档)3分钟.完全除去经PAP法染色后的垂体前叶切片上的抗体复合物;

    With this technique three minute microwave irradiation ( at the lowest power setting ) in acid elution solution completely removed the antibody complexes from anterior pituitary sections stained by the PAP method .