蒸压灰砂砖

  • 网络autoclaved sand-lime brick;Autoclaved lime-sand brick
蒸压灰砂砖蒸压灰砂砖
  1. 新的蒸压灰砂砖国家标准简介

    Introduction to a New National Standard for Autoclaved Sand-Lime Brick

  2. 蒸压灰砂砖砌体弯曲抗拉强度试验研究

    Study on autoclaved sand-lime brick masonry by bending tensile strength test

  3. 研究表明,当成型压力从20MPa升至40MPa时,蒸压灰砂砖抗压强度可提高90.3%,耐盐酸腐蚀能力也有所提高。

    The results show , when molding pressure changes from 20 MPa to 40 MPa , autoclaved lime_sand bricks get a strength increase of 90.3 percent . Hydrochloric acid stability is also enhanced .

  4. 长沙地区蒸压灰砂砖砌体力学性能研究

    Research of the autoclaved sand - lime brick in Changsha aera

  5. 蒸压灰砂砖产品性能和砌体力学性能试验研究

    Product and mechanics performance test research for autoclave sand-lime brick

  6. 蒸压灰砂砖应用技术研究

    The Appliance Technical Research on Autoclaved Lime - sand Brick

  7. 浅议蒸压灰砂砖砌体裂缝的控制措施

    Controllable measures of cracks in streaming and pressing brick wall

  8. 蒸压灰砂砖砌体结构设计与施工规程

    Specification for designing and construction of masonry constructed of autoclaved sand-lime bricks

  9. 碳化对蒸压灰砂砖的微观性能影响研究

    Studies on the Effect of Carbonization on the Microcosmic Performance of Lime-Sand Brick

  10. 铜尾矿生产蒸压灰砂砖的研究

    Study on Autoclaving Lime Sand Brick Using Copper Tailing

  11. 铜尾矿生产蒸压灰砂砖及混凝土路面砖应用技术研究

    Study on the application technology for autoclaved lime-sand bricks and concrete paving tiles by copper tailings

  12. 蒸压灰砂砖和混凝土砌块墙体开裂分析及防治

    Analysis and prevention of wall crack of autoclave sand - lime bricks and concrete building blocks

  13. 中低压化工设备施工及验收规范蒸压灰砂砖砌体结构设计与施工规程

    Code for construction and acceptance of low and medium pressure chemical equipment Specification for designing and construction of masonry constructed of autoclaved sand-lime bricks

  14. 研究成型压力对蒸压灰砂砖抗压强度和耐盐酸腐蚀能力的影响。

    In this paper , the effect of molding pressure on the strength and hydrochloric acid stability of autoclaved lime_ stone sand brick is studied .

  15. 本文主要介绍了以铜尾矿砂为原料生产蒸压灰砂砖和混凝土路面砖的中试情况,并做了技术经济分析。

    Pilot test for manufacturing autoclaved lime-sand bricks and concrete paving tiles by copper tailings was introduced in the paper , its techno-economic analysis was also made by the author .

  16. 对GB11945-1999《蒸压灰砂砖》国家标准的特点、产品分等分级、外观抽样检验方案及物理力学性能指标等方面的规定作了编制说明;

    The compiling instructions are made on the features of the national standard for 《 Autoclaved Sand-Lime Brick 》( GB11945-1999 ), the gradations and classifications of the products , the sample survey scheme for appearance and stipulations for indices of physical and mechanical properties ;

  17. 通过对长沙地区大量的蒸压灰砂砖及灰砂空心砖抗剪强度的试验研究,其结果为:灰砂砖砌体抗剪强度高于粘土砖,也高于规范计算值。

    The shear strength property of autoclaved lime sand brick in changsha has been studied for a number of tests . It shows that its strength is higher than that of clay brick and the value is higher than that specified of design specification too .

  18. 分析比较了蒸压灰砂砖和蒸压加气混凝土砌块与红砖的特性,对蒸压灰砂砖和加气混凝土砌块墙体开裂的机理作了探讨,提出了相应的防裂漏措施。

    It analyzes and compares the features of autoclave sand-lime bricks and autoclave-aerated concrete building blocks and the features of common bricks , researches the mechanism of wall crack of autoclave sand-lime bricks and concrete building blocks and puts forward corresponding measures to prevent crack .

  19. 试验结果表明,长沙地区蒸压灰砂空心砖砌体抗剪强度高于烧结普通红砖砌体;

    Based on these results it is possible to make optimum combination of these factors , The test results shows that this shear strength is higher than that of the common fired red brick masonry ;

  20. 蒸压粉煤灰砖及蒸压灰砂砖生产技术及发展

    Production technology and development status of autoclaved fly ash brick and sand-lime brick in China

  21. 主要介绍了国内外蒸压粉煤灰砖及蒸压灰砂砖的发展现状、生产工艺流程、生产装备、生产技术关键及其生产和应用中存在的相关问题。

    The paper describes the development status , process , equipment , technology and problems for autoclaved fly ash brick and sand-lime brick at home and overseas .

  22. 根据蒸压材料工艺学原理,使用石材厂的石粉泥浆为原料制备蒸压灰砂砖。

    Based on the principle of autoclaved process , autoclaved sand-lime brick have been made using stone powder slurries from stone processing factories .