老化试验

该系统适于额定电压10kV以下金属氧化物避雷器比例单元、氧化锌电阻片的交流加速老化试验。

It can be used ageing test of MOA varistor and prorated units of 10 kV and below .

通过经验公式对硫化橡胶老化试验数据进行拟合，然后根据经验公式的拟合值，用EXCEL中的图表工具作出硫化橡胶的老化动力学变化曲线，以期反映硫化橡胶的动力学变化规律。

The ageing test date of vulcanizate was fitted by experimental formula , than according to the fit value from experimental formula , the ageing dynamics curves of vulcanizate were plotted by the chart tools in EXCEL 2000 in order to show the dynamics varying regular of vulcanizate .

包装废PE改性沥青旋转薄膜烘箱老化试验

The Rotating Film Oven Test of the Modified Asphalt by Waste-PE in Packaging

ABS颜色稳定性的老化试验

Ageing Tests for Colour Stability of ABS

LCD模块老化试验台的研制

Aging Test Machine for LCD Module

低水泥浇注料中纯铝酸钙水泥和SiO2微粉的老化试验

Aging experiment of pure calcium aluminate cement and silica fume in low cement castables

烘箱加热模拟老化试验结果表明，RA抗车辙剂对沥青混合料的抗老化性能有所提高，但高温生产会削弱其抗老化性能。

Heat oven to simulate aging test results show that RA anti-rutting agent improve the anti-aging properties of asphalt mixture .

MOA老化试验监控系统的设计

Design of Supervisory Control System of MOA Accelerated Ageing

静态热老化试验、脱氯化氢试验、红外及热失重分析结果表明，钙锌皂单独使用时，其热稳定性很差；加入水滑石后，PVC的长期热稳定性得到明显的改善。

The results of static thermal aging method , dehydrochlorination method and FT-IR analysis showed that the thermal stabilization of single Ca / Zn soap was very poor .

SH为新型高分子固化材料。本文通过SH固化沙体的室内老化试验，初步研究了SH的耐老化特征。

This paper presents preliminary results of resistances to aging of SH , a new Polymer solidified material , by using an aging test of the SH-fixated sands .

根据新的IEC规范，介绍了相关光纤氢老化试验的程序和各种结构的光缆在不同应用环境下氢损效应评价必要性的导则。

The necessary guidance for the test procedure for hydrogen ageing of optical fibers and evaluation of hydrogen loss in individual cable constructions under different applications is described with reference to new IEC standards .

通过海洋大气环境户外暴晒老化试验和盐雾加速老化试验，试验研究了不同硬段含量的聚天冬氨酸酯（PAE）聚脲涂层的耐海洋环境老化性能。

Polyurea coatings with different contents of hard segment polyaspartic ester ( PAE ) were investigated through aging tests of marine environment outdoor exposure and salt fog testing .

介绍了对J－71胶及其配套胶膜J－47A，和对J－71胶胶接接头分别进行湿热老化试验、耐海水性能试验情况。

It introduces moist heat aging and sea - water proof tests carried out respectively on J - 71 adhesive and its complementary pliofilm J - 47A and J - 71 bonded joint .

PAP-D型铝塑复合防潮材料湿热加速老化试验研究

Research on Acceleration and Aging Test for PAP-D Composite Materials under Humid and Hot Condition

方法在相同条件下对两种硅橡胶材料进行了热老化试验，对其老化性能加以评价。结果热老化后，SY-1硅橡胶的扯断强度性能变化百分比与MDX4-4210硅橡胶无显著差异（P>0.05）；

Methods Under the same condition , to test the heat ageing property of two kind of silicon rubber and evaluate them .

第1种方法为样品于室温条件下在去离子水中浸泡3d；第2种方法为样品在70℃的水中浸泡10h，或者经过人工加速老化试验制备产物。

In the first case , the sample was soaked in water at the room temperature for 3 days and in the second case the sample was either soaked in 70 ℃ water for 10 hours or subjected to accelerated aging under artificial environment .

在此评价方法中建立了单一快速试验环境和复合快速试验环境下FRP名义力学性能衰减模型，在分析快速和自然老化试验结果对应关系时提出并计算了单一和复合加速因子。

The models of nominal mechanical performance of FRP under single and compound accelerated experiments were established for the evaluation method . The single and compound accelerated factors were proposed and calculated when analyzed the relationship between the results of the accelerated and outdoor exposure experiments .

采用NR塑性保持率的测定方法、橡胶热空气老化试验方法、热分析技术及扫描电镜分析等，研究了促进剂TMTD对粘土填充NR胶料抗热氧老化性能的影响。

The effect of TMTD on the heat and oxygen aging of clay filled NR compound was investigated by using determination for plasticity retention of NR , test method of hot air aging , thermal analysis and SEM .

通过旋转薄膜烘箱老化试验（RTFOT）和荧光紫外老化试验（QUV）对阻燃SBS改性沥青的老化性能进行了试验评价。

The rolling thin film oven test ( RTFOT ) and fluorescence ultraviolet aging test ( QUV ) were adopted to evaluate aging property of flame retarded SBS modified asphalt .

分析了老化试验的作用，选取Arrhenius模型作为高温加速老化模型，搭建了高温老化试验平台，最后通过实验验证了高温老化的作用。

The effect of the ageing is analyzed , then the Arrhenius model is selected as high-temperature accelerated ageing model , next a high-temperature aging platform is established , finally , the effect of the high-temperature ageing is verified through experiments .

通过快速冻融试验、耐碱性试验、浸水试验、湿热暴露试验、人工加速老化试验，研究了腐蚀环境对纤维增强复合材料（FRP）的复合体及粘结剂力学性能的影响。

Based on the fast freeze-thaw test , the alkaline resistance test , the water immersion test , the wet-thermal exposure test and artificial accelerated aging test , the influence of the corroding environment on the mechanical behavior of fiber reinforced polymer ( FRP ) laminates and adhesive was studied .

介绍了中国先进研究堆（CARR）应急供电系统的功能、组成，包括1E级蓄电池组、不间断电源（UPS）的容量确定、1E级开关柜的老化试验和抗震试验。

This paper presents the function and component of the emergency power supply system for China Advanced Research Reactor ( CARR ), 1 E class battery set , determination of THE rated power of UPS , aging test and seismic test of 1 E class switchboard .

根据70℃下加速老化试验中粘接性能的变化和界面区域迁移组分含量的变化，研究了NEPE推进剂中硝酸酯、功能助剂的迁移对粘接性能的影响。

According to the change of the bonding properties and the content of migrating ingredients at the interface during the accelerated ageing test ( 70 ℃), the effect of migration of nitrate ester and function additive in the NEPE propellant on the bond properties was investigated .

快速紫外线（QUV）老化试验和氙灯老化试验均兼顾了热、紫外线、氧和湿度的环境因素，能较准确地预测异型材的长期耐候性；

Quick ultraviolet ( QUV ) test and xenon lamp test can estimate it more accurately because they considered more adverse factors , such as heat , UV , oxygen and moisture .

采用沥青薄膜烘箱试验（TFOT）和紫外线老化试验，对壳牌90号重交通道路石油沥青，以及掺加添加剂后沥青的针入度、软化点、延度和粘度等指标进行了试验研究。

Employing the rolling thin film oven test and ultraviolet radiation aging test , the pene - tration index , soft point , ductility and viscosity of AH-90 asphalt and other additives modified asphalt were investigated .

电路老化试验箱恒温控制系统的设计

Design of constant temperature control system in circuit aging test chamber

催化转化器老化试验相关性研究

Study on the Correlation Between Two Aging Tests for Catalytic Converter

常见温湿度老化试验方法及试验后的评判

The temperature and humidity aging test methods and evaluation after test

橡胶加速老化试验及贮存期推算方法

Accelerated Aging Test of Rubber and Calculation of its Storage Life

GB/T14831-1993胶乳制品蒸汽老化试验方法

Rubber latex products & Test method for resistance to steam ageing