测量控制系统

  • 网络measurement control system
测量控制系统测量控制系统
  1. 双Fabry-Perot干涉纳米测量控制系统的设计

    Design of a Nano Measurement Control System Based on Dual Fabry Perot Interferometer

  2. 系统设计采用虚拟仪器技术,以PXI模块化仪器为基础组成测量控制系统实现对苯乙腈生产自动控制;

    System design using virtual instrument technology based on PXI modular instruments for the measurement control system to achieve automatic control of the production of benzene acetonitrile ;

  3. 基于GPS的FAST望远镜馈源平台自动测量控制系统

    Automatic GPS-based surveying and control system for FAST radio telescope

  4. 基于DSP的傅里叶光谱仪测量控制系统

    The Measure and Control System of Fourier Spectrum Based on DSP

  5. 基于DSP的新型pH值和离子浓度测量控制系统

    Control System of a Novel Instrument for pH and Ionic Concentration Based on DSP

  6. 通过NationalInstrument虚拟仪器软件和相应的计算机硬件设备构成高温超导磁体实验的测量控制系统。

    This paper presents a data acquisition system of the high temperature superconductor magnet measured on the computer and virtual instrument software of National Instrument .

  7. 采用STD总线工业控制计算机的漆包机测量控制系统

    The Measurement and Control System of Enameled Wire Machine Based on the STD Bus Industrial Computer

  8. 介绍了一种改善CCD信噪比的方法,设计了基于半导体制冷器的CCD制冷及温度测量控制系统。

    A method of improving CCD SNR is introduced . CCD refrigeration system based on semiconductor refrigeration device and temperature survey control system are introduced .

  9. 破片迎风面积测量控制系统,整个控制系统由面阵CCD相机、力矩电机,编码器、单片机主控单元等组成。

    The controlling system of measuring fragment frontal area consists of a CCD camera , a absolutely moment motor , photoelectricity coder and a computer control cell .

  10. FWM树脂粘度测量控制系统的研究

    Study on measurement and control system of FWM resin viscosity

  11. 其整个测量控制系统采用试金PC工一卡通计算机总线式控制器,实现了对试验力、变形、位移零点和增益的数字化调整,操作方便,具有极高的可靠性。

    Entire control system assay the PCI card computer bus controller , achieved on the test load , deformation , displacement digital zero and gain adjustment , easy to operate , offers high reliability .

  12. 本文具体介绍了MG-1型埋设犁埋设深度的实时测量控制系统,阐述了该系统的信号采集、埋深计算、数据标定和现场数据分析等。

    In this paper , the real time detecting and controlling system of MG 1 burying depth has been introduced in detail . The signal collecting 、 burying depth calculation 、 data calibration and data analysis are described too .

  13. 设计了基于DSP和FPGA的非圆齿轮极坐标测量控制系统,主要包括伺服电机控制电路、光栅信号采集电路、AD转换电路、数据通讯电路和保护电路。

    Designed polar coordinate control system of non-circular gear based on DSP and FPGA , mainly including the servo motor control electric circuit , raster signal acquisition circuit , AD converter circuit , data communicating circuits and protecting circuits .

  14. MG-1型埋设犁实时测量控制系统

    The real time detecting and controlling system by a mg 1 burying plough

  15. 本文介绍了基于霍尔传感器,采用单片机C8051F060控制的直流电机转速测量控制系统的工作原理及软硬件设计方法。

    This paper presents operating principle of rotating speed tachometer based on Hall sensor consisting of a microcontroller C8051F060 , software and hardware configurations and their design method .

  16. 从PROFIBUS现场总线的存取协议出发,着重研究测量控制系统的数据传输时间并从单主站的测量控制周期的分析中得出了提高现场总线实时性的两个结论。

    Beginning with the PROFIBUS field bus access protocol , this paper studies the time of data transmission of survey controlling system , and obtains two conclusions of increasing the timeliness of the field bus through the way of analyzing the survey controlling cycle of the single master station .

  17. 典型破片迎风面积测量控制系统研究

    Research on the Controlling System of Measuring Typical Fragment Frontal Area

  18. 测长、称重测量控制系统的设计与应用

    The design and applications of length measuring and weighs control system

  19. 齿轮检测过程中的微机测量控制系统

    The Computer Control System in the Process of the Gear Check

  20. 虚拟仪器技术在发动机台架试验测量控制系统中的应用

    Application of Virtual Instrument in Engine Test bed Measure and Control System

  21. 熔铝炉炉压测量控制系统改造

    Innovation on Pressure Measurement Controlling System for Aluminum Melting Furnace

  22. 这些领域都需要高精度、高分辨率的角度测量控制系统。

    These areas need high-accuracy and high-distinguishability design of angle measuring system .

  23. 光谱和能级寿命自动测量控制系统设计

    The design of automatic measurement and control system in spectrum and life-energy

  24. 光电准直经纬仪的测量控制系统

    The measuring and controlling system of photoelectricity and collimation theodolite

  25. 抛弃式海洋环境参数测量控制系统设计

    The Design of Expendable Marine Environment Measurement and Control System

  26. 计算机测量控制系统的自诊断方法

    Some Methods of Self-detection by Computer Measurement & Control System

  27. 南水北调中干线工程施工测量控制系统

    Construction surveying control system for middle route of South-to-North Water Diversion Project

  28. 高精密角度分度测量控制系统的研究

    Research on Highly Precise Angle - differentiated Measuring and Auto - controlling System

  29. 基于数据融合的某型导弹智能温度测量控制系统

    Intelligent Temperature Measuring and Control Systemof a Certain Missile Basing on Data Fusion

  30. 激光供电在串补测量控制系统中的应用

    Application of laser power supply technology in series compensation control and measurement system