常压烧结

  • 网络sintered;pressureless sintering;SSIC
常压烧结常压烧结
  1. 通过常压烧结制备了Al2O3/Y-TZP复相陶瓷,研究了Al2O3含量对材料力学性能及耐磨性的影响。

    Al_2O_3 / Y-TZP composites were prepared by pressureless sintering . Effects of material composition on mecha ?

  2. 烧结助剂对Sialon常压烧结的影响

    Influence of sintering aids on pressureless sintering of Sialon ceramics

  3. 常压烧结制备Al2O3/TiCN复合陶瓷材料

    Preparation of al_2o_3 / ticn composites by normal pressure sintering

  4. 常压烧结Ca3Co2O6系热电材料及其性能研究

    Research of Ca_3Co_2O_6 System Thermoelectric Materials and Its Property by Normal Pressure Sintering

  5. 常压烧结制备Al2O3/SiC纳米复合陶瓷及其显微结构的研究

    Microstructure and fabrication of Al_2O_3 / SiC nano - ceramics produced by pressureless sintering

  6. 微波烧结和常压烧结对Al2O3-ZrO2陶瓷磨损行为的影响

    Influences of Microwave and Conventional Sintering on the Wear Behavior of Al_2O_3-ZrO_2 Ceramics

  7. 采用连续成型工艺压制纳米ZnO素坯,常压烧结制备了高密度纳米ZnO陶瓷。

    Higher density ZnO nano-ceramic was prepared by sintering in air , with continuous compaction green body as raw material .

  8. 使用Nb箔作中间层对常压烧结SiC陶瓷进行了真空扩散连接。

    Pressureless-sintered ( PLS ) SiC was bonded to SiC through Nb foil interlayer by vaccum diffusion method .

  9. 常压烧结Sialon材料高温性能的研究

    Study on high temperature properties of free pressure sintered sialon material

  10. 配料Z值对常压烧结Sialon结构与性能的影响

    Effect of the value of feeding Z on the construction and properties of pressureless sintered Sialon ceramics

  11. 常压烧结和高压合成Nd(2-x)CexCuO4的结构特征与导电性质

    Structural characters and the conductivity of nd_ ( 2-x ) ce_xcuo_4 samples prepared under atmosphere and high pressure

  12. C含量对ZrB2-SiC复相陶瓷常压烧结及其性能的影响

    Effect of Carbon Contents on the Pressureless Sintering of ZrB_2-SiC Composite Ceramics

  13. Sialon陶瓷的常压烧结

    The pressureless sintering of Sialon ceramics

  14. 常压烧结与微波烧结ZTA陶瓷性能

    Properties of ZTA Ceramics Made with Microwave and Conventional Sintering Method

  15. 本论文研究了BeO陶瓷的常压烧结技术。

    The conventional sintering of BeO ceramics was studied .

  16. 一步常压烧结制备AlON陶瓷材料

    One-Step Synthesis of AlON Ceramic Materials under Pressureless Sintering

  17. 本文采用常压烧结工艺制备ZrO2增韧莫来石陶瓷(ZTM)。

    ZrO 2 toughened mullite ceramics ( ZTM ) were fabricated by pressureless technique .

  18. 研究了常压烧结Y2O3-ZrO2陶瓷不同冷却方式对其力学性能及t&m相变的影响。

    Effect of four different cooling modes on t & m transformation and mechanical properties of Y_2O_3-ZrO_2 ceramics were studied .

  19. 纳米ZrO2(4Y)两次成型常压烧结致密特性及其电导率

    The Densification and Conductivity of Nano ZrO_2 ( 4Y ) by Airpressure Sintering Using Continuous Compacting

  20. 本文中分别采用聚合合成法和柠檬酸法合成NaxCo2O4前驱粉体,以常压烧结制备其块体材料。

    The synthesis of the Na_xCo_2O_4 thermoelectric oxide powders were attempted by using the polymerized complex method and citric acid complex method , both of that are a kind of sol-gel method .

  21. 热压和常压烧结PZN-PZT陶瓷的温度稳定性

    Temperature Stability of PZT-PZT Ceramics Prepared by Hot-pressing and Conventional Sintering Techniques

  22. 用常压烧结方法,在1200℃~1350℃烧结不同含B量的掺硼氧化锌(ZBO)靶材。

    Boron-doped zinc oxide ( ZBO ) target material was developed by sintering of ZnO and B_2O_3 powders at a temperature ranging from 1200 ℃~ 1350 ℃ .

  23. 本研究利用主导曲线模型分析平均粒径约50nm的α-Al2O3粉末之常压烧结致密化过程。

    Nanocrystalline a-Al2O3 powder was used in this work to test the feasibility of using master curve model to describe its sintering behaviors .

  24. 常压烧结ZrB2-SiC复相材料的抗氧化行为研究

    Oxidation Behaviors of the Pressureless Sintered ZrB_2-SiC Composites

  25. 与常压烧结相比,真空热压烧结不但可以使Cu/WCpFGM的微观组织结构得到明显改善,而且还可以使Cu/WCp复合材料的硬度和电导率得到显著提高。

    Compared with pressureless sintering , vacuum hot pressing sintering can not only improve the microstructure of Cu / WCp FGM , but also improve the hardness and conductivity of the composite materials Cu / WC obviously .

  26. 在空气中900~1200℃的高温下,研究了添加Y2O3常压烧结AlN陶瓷的氧化行为。

    The oxidation behavior of aluminum nitride ceramics sintered under normal pressure , containing Y 2O 3 as a sintering aid was investigated . Samples were exposed to air at temperatures from 900 ℃ to 1000 ℃ .

  27. 为了解决这一问题,作者研究了填料成分、烧结温度、烧结时间等工艺条件对Sialon陶瓷常压烧结密度的影响,分析了烧结过程的物理化学机制和致密化机制。

    In order to solve this problem the effect of packing powder compositions , sintering temperature and sintering time on the densities of pressureless sintered Sialon ceramics were studied . The physical and chemical mechanisms of sintering process were discussed .

  28. PZN-PZT常压烧结陶瓷具有优良的压电性能,PZN-PZT颗粒粒径在0.5~4μm之间,颗粒形态不太规整。

    PZN PZT ceramics synthesized by the traditional sintered method contain well piezoelectric properties . The diameters of PZN PZT powders are between 0.5 ~ 4 μ m , and the shape is irregular .

  29. 碳热还原-常压烧结法制备多孔氮化硅陶瓷

    Porous silicon nitride ceramics prepared by carbothermal reduction – pressureless sintering method

  30. 纳米钨合金粉末常压烧结的致密化和晶粒长大

    Densification and grain growth of nano-structured tungsten alloy powder during pressureless sintering