解理面

钛酸钡单晶沿垂直解理面方向的超高压电响应的研究

Ultrahigh piezoelectric response along some special cleavage plane in BaTiO_3 single-crystals

是指组成翡翠的矿物晶面及解理面在翠面的片状闪光。

Refers to the mineral composition of emerald crystal surface and cleavage plane of When the composition of the mineral particles thick jade , particularly evident .

加荷速率增加导致动态断裂韧性试样断口的解理面比K（Ic）试样增多。

The increase of loading velocity causes that the cleavage facets of fracture surface of K_ ( Id ) specimens are more than those of K_ ( IC ) .

Si（111）解理面L（2,3）VV俄歇谱的谱形分析

A line shape analysis of sil_ ( 2,3 ) vv Auger spectrum on the cleaved ( 111 ) surface

通过控制蒸发源电流、源和样品间距及扩散时间，室温下在C60单晶（111）解理面上制备出Rb3C60。

Rb 3C 60 thin film was prepared on the ( 111 ) surface of C 60 single crystal .

通过全片层γTiAl基合金SEM原位拉伸实验以及对裂纹前方滑移面及解理面上的应力进行有限元计算，研究了片层界面在形核中的作用。

The twofold effects of lamellar interface on crack nucleation in fully lamellar TiAl based alloys were investigated through in situ SEM technique and stress analysis on cleavage planes using finite element method .

PSE在滑石解离面的主要吸附机理是PSE的硅醇基与滑石解理面上的氧原子形成氢键；

While there are only a few chemical bonds on the talc cross section , the main interaction between PSE and surface of talc on the cleavage plane is hydrogen bond .

矿物解理面状态、Nocardia表面基团的桥连作用和静电力是导致选择性吸附的关键。

According to the experiments , it can be concluded that the state of mineral cleavage plane , the bridging function of the group on the surface of Nocardia and the electrostatic force are important factors .

当数纳米厚Rb3C60薄膜在C60单晶（111）解理面形成后，室温条件下进一步沉积Rb至样品表面不产生fcc到bct或bcc结构相变。

After the Rb 3C 60 thin film with a thickness of nanometers has formed on the surface layers of the C 60 single crystal , the excess depositions of Rb do not induce the bulk-like fcc to bct or bcc structure transitions at room temperature .

硅外延层解理面缺陷腐蚀坑的观察及初步分析

Defects etching pits observations and analyses on epitaxial silicon cleavage surface

Link-OPAL系统中断口解理面取向的电子背散射衍射测定方法

The Method for Determining Cleavage Facet Orientation by EBSD in Link OPAL System

这两个解理面限定了法布里？珀罗光腔。

The two cleaved facets define the Fabry-Perot Cavity .

裂纹扩展区主要为疲劳条带并存在明显的二次裂纹、撕裂棱、准解理面。

Crack growth area mainly has the fatigue striation , with secondary cracks , torn edges , quasi-cleavage fracture .

工件已加工表面通过2种形式的破裂而形成：沿解理面光滑平整的大块破裂；晶粒断裂引起的层状小块破裂。

Machined surface of the workpiece is formed by cleaving along the cleavage planes of the crystal and intercrystalline fracture .

由激光器自身解理面形成的谐振腔面，反射率仅有32%。

The single face reflectance of the optical resonant cavity which is composed of the mirrors formed from the natural cleavage GaAs face is only 32 % .

低温断裂断口主要由解理面和撕裂棱组成，具有明显的脆性沿晶断裂的特征；

At low temperature , the cleavage surface and tearing ridge , which was taken as typical brittle fracture features , could be seen on fracture surfaces .

由于表面对材料的特性具有重要的影响，而（001）表面是铅盐的天然解理面，所以对铅盐（001）表面的研究具有至关重要的意义。

The surface of material is very important for us to use it , while the ( 001 ) surface of lead salts is a natural surface .

但是由于矿物晶体粉碎过程中表现出沿解理面解理破裂的强烈倾向，使得矿物粉体表面具有平整的解理面及尖锐的棱角。

Mineral powders are good crystalline , and they break along the cleavage plane when they are comminuted , which cause the mineral powders have flat surfaces and sharp edge angles .

磷灰石、方解石具有相同的表面活性质点Ca~（2+），由于解理面上Ca~（2+）密度不同导致矿物可浮性的差异。

Apatite has the same surface active point Ca ~ ( 2 + ), as calcite . The density difference of Ca ~ ( 2 + ) on the cleavage plane between apatite and calcite leads to different floatability .

由于本文用三个低指数面同时调节5个参数，因而，对于一组优选的参数，同样适用于由低指数解理面构成的台阶面的表面吸附问题。

As long as we can reproduce simultaneously the experimental data of three low-index surfaces by 5-MP , the five parameters can then be used to deal with the interaction between atom and stepped surface that is formed by low-index surface .

向轻质碳酸钙中添加重质碳酸钙是目前工业生产采用的降低轻钙吸油量的方法，但由于研磨重钙尖锐的棱角和光滑的晶体解理面降低了轻钙填充制品的力学性能。

Introducing ground calcium carbonate into precipitated calcium carbonate is the universal method which reduces the oil absorption value in industry . But the edge angles and the smooth surfaces of the ground calcium carbonate reduce the mechanics capability of PVC .

这些弱界面是强烈的{100}板织构形成的解理面，其能够缓解三向拉应力状态、纯化裂纹，偏析裂纹扩展路径，抑制裂纹扩展，具有显著的韧化作用。

The weak binding boundaries are the interface of the potential cleavage which formed by intense { 100 } textures . This kind weak interfaces has delamination toughening effect which relaxing triaxial stress , blunting crack , deflecting and bifurcating crack growth path .

探讨高激光损伤阈值腔面处理技术，包括真空解理、腔面钝化处理、高损伤阈值腔面膜，以抑制腔面的氧化，降低腔面表面态密度，减少非辐射复合，提高器件的COD阂值。

Investigate the high laser damage threshold cavity surface processing technology , including vacuum cleavage , cavity surface passivation , high damage threshold coating . To suppress the cavity surface oxidation , reduce the density of surface state , decrease the radiative recombination , in order to improve COD threshold .

分层裂纹表面为解理形貌，解理面较大。

The surface of delamination crack is of cleavage fracture appearance with large cleavage face .

所有试样都是以解理方式断裂的，解理面是{100}。

All samples fracture in a cleavage mode and the cleavage plane is found to be { 100 } .