红外光源

设计并制作了悬膜结构MEMS红外光源。

Hanging film structure MEMS infrared light source was designed and fabricated .

该系统采用了悬膜可电调谐MEMS红外光源和中红外空心光纤作为气体样品吸收腔。

Hanging film by power tuning MEMS infrared light source and mid-infrared hollow optical fiber absorption chamber are used in the system .

MEMS红外光源及应用

MEMS infrared source and application

Si/SiGe量子级联激光器是一种新型的带内跃迁的红外光源，突破了Si基材料间接带隙特性对光跃迁的限制。

The Si / SiGe quantum cascade laser is a new coherent IR source based on intersubband transitions , which overcomes the limitations imposed by the indirect gap .

借助红外光源和摄像头，Kinect会在玩家游戏区域的投射三维成像。

Kinect uses an infrared light and a camera to create a3-D image of your play area .

提出了一种以红外光源照射焊缝，CCD摄取图像，通过计算机对图像进行分析处理，提取焊缝的长度、宽度和偏心距的方法。

A weld detection method composed by the following steps was proposed : the seam was exposed at infrared light supply , the image was shot by CCD and processed by computer , then the length , width and eccentricity of weld seam were reported .

红外光源能够为全暗室环境下提供适合像增强器和CCD组件所需要的辐射，在光电转换、增强、显示作用后，能够提供适合显示器和人眼直接观察的电子及光学图像。

The radiation generated by infrared illuminating source could make the image intensifier and CCD components work properly in the completely dark room . Electro-optical pictures can also be displayed or observed directly by human eyes after the image is electronic-optically conversed , intensified and displayed .

通过对不同数量的光纤束的研究表明在采用光纤腔体内径小于MEMS红外光源的发光面积内以及红外探测器接收面积，光纤腔体越粗，响应越大。

Different quantities of fibers bundles testing results show that the diameter of the chamber is bigger , the response of the gas sensor is larger , while the diameter chamber is smaller than the radiation of MEMS infrared light source and the infrared detecting monitor .

当红外光源通过装在步进电机斩波轮上的滤光片照射到硒化铅（PbSe）检测器上时，就会将气体的浓度变成微弱的电信号，经过相关电路处理，最终得到测量结果。

Through filter set up on Stepping-Motor Chopper Wheel , when infrared source irradiate PbSe detecting implement , a faint electronic signal converted from gas consistency is gotten , then processed by relative circuit , finally detection result is exported .

基于红外光源的驾驶员眼睛特征提取

Driver Eye Feature Extraction Based on Infrared illuminator

主动式汽车夜视系统则是一种自带红外光源的系统。

Vehicle active night vision system is a system with the infrared light source .

本文论述了在反光式棉纤维长度测量中应用红外光源的问题。

In this paper , the application of the infrared ray to fibrograph was investigated .

一种基于脉冲红外光源和折叠光路的微小型红外光谱仪

Development of a Micro-Infrared Spectrometer Based on Pulse Infrared Light Source and Two-Double Light Route

反光式棉纤维长度测量中应用红外光源的研究

A study of the application of infrared ray to measuring cotton fibre length by optical reflectance

红外光源辐射强度测试的初步研究

Study on IR Radiant Intensity Test

新型脉冲式红外光源用于快速光谱测量的全气候脉冲照明光源的稳压控制

The Constant Voltage Control of Pulsed Light Source Applied to Different Climate Used in Fast Spectral Measurement

形核表面面对红外光源时，由于减少表面散射而透射率较高；

The transmission increased due to less surface reflection if the nucleation surface faced the IR rays .

内部照明采用红外光源，其强度由电源前面板控制。

Internal illumination is from infra-red emitters with intensity controlled from the front panel of the power supply .

实验选用了760nm近红外光源，在20℃恒温情况下，对生物量浓度测量进行了实验研究。

Under the constant temperature ( 20 ℃) circumstance , the biomass concentration is tested using a 760 nm lamp-house .

介绍一种采用电调制红外光源的新型非分光红外气体传感器。

A new type of Non ? dispersed Infrared ( NDIR ) gas sensors based on pulsable IR source is introduced .

利用红外光源浮区法生长出大尺寸、高质量的磁失措自旋冰化合物Dy2Ti2O7单晶体。

Large , high quality single crystals of Dy_2Ti_2O_7 have been successfully grown by the floating zone technique in an infrared image furnace .

在这一章中，我们在对提取溶剂、提取时间、固液比等影响因素进行优化之外，还考察了红外光源的功率对提取结果的影响。

Besides the influence factors mentioned in chapter 1 , we also investigated the effect of different infrared power on the extraction results .

另外，本文做了详细的光学成像方面研究，包括多角度红外光源设计，多个摄像机摆放角度的选择等。

Also , there is a detailed researching of optical imaging which includes design of infrared light and choice of multiple angles of camcorders .

系统采用均匀红外光源进行照明，利用光学传感器摄取包含人体静脉信息的红外图像。

The average infrared lighting is adopted , and the infrared vein image containing information of hand vein can be acquired by optical CMOS sensor .

用该方法对实验环境照度下捕捉的图像和红外光源辅助照明的图像进行了分析，并与主动轮廓线方法对比。

The proposed method is applied to the visible-light image and IR-illuminated image in the experimental condition , and contrasted with a method based on active contour .

对中红外光源在军用民需领域的应用做了简单的介绍。介绍了目前常用的适合于中红外波段的非线性晶体材料。

The application introduction of mid-infrared light source in military and livelihood fields , and the nonlinear optical crystal is very useful in the mid-infrared laser have been summarized .

根据产生高强度的超短阿秒脉冲对高功率中红外光源的需求，本论文还开展了产生高功率中红外光源的研究。

Because of the desire for the high-power mid-infrared laser source to generate the intense and ultrashort attosecond pulse , the generation of high-power mid-infrared source is also investigated .

将近红外光源和检测器置于脂肪的表面，由光源发出被两层组织反射的光子的一部分由检测器所接收。

Near-infrared light source and detector were located on the surface of the fat and a part of the photons reflected by the two-layered structure of the tissue were detected .

本文在眼底照相机和眼底电视光学系统的基础上，提出了利用红外光源作检眼设备的眼底红外检测仪。

It is proposed in this paper that a fundus infrared detector with infrared light for light sou-rce base on the systems of the fundus camera and the fundus television .

光路设计：对红外光源、镀膜气室、红外探测器等器件进行选择并分析其功能，完成光路部分的结构。

Optical design : The structure of optical path is designed by choosing and analyzing function of the infrared source , filming gas chamber , infrared detectors and other elements .