烧结合金

不锈钢/铜基烧结合金材料的磨损机制主要是粘着磨损及氧化磨损。速凝法制备粘结稀土磁致伸缩材料的工艺和性能研究

The wear mechanism of stainless steel against copper based sintered alloy is mainly attributed to adhesion , abrasion and oxidation . Study on Technology and Properties of Bonded Rare Earth Magnetostrictive Materials Prepared by Strip-casting Method

钴镍烧结合金与碳钢的CO2激光焊接的可焊性

CO_2 Laser Weldability between Co + Ni Sintered Alloy and Carbon Steel

Al内氧化形成的氧化物，产生的体积膨胀可增加粉末烧结合金的致密化程度。

Through internal oxidation treatment , the formed internal oxides produced the volume expanding , which improved the densification of Cu-Al powder sintering alloy .

高温退火和添加Si对仿M10铁基烧结合金显微组织的影响

Effects of annealing and adding Si on the microstructure of M10 type sintered steel

随着还原Fe粉添加量的增加，烧结合金的密度先增加后降低，硬度和强度略有降低。

With the increase of quantity of the reduced iron powder , the density of sintered alloy increases and then decreases and the intensity and strength decreases slightly .

并对烧结合金的组织、性能进行了分析，表明亚微米晶粒Ti（C，N）金属陶瓷的性能优良

The microstructure and properties of sintered alloys have also been studied , and it showed that the properties of submicron Ti ( C , N ) based cermets are greatly ameliorated

用高纯氮气体做介质对Cu-0.75%Al粉末烧结合金进行内氧化处理，用X-ray衍射、SEM和TEM等分析技术对其进行研究。

Internal oxidation treatment were carried out in an internal oxidizing apparatus for a Cu-0.75 % Al powder sintering alloy , and microstructure were investigated by means of SEM , TEM and X-ray .

WC-Co烧结合金的硬度在800℃以下和温度呈线性关系，当Co≤20%时，与钴含量也呈显著的线性关系；

For WC-Co sintered alloys , the H-T relation is linear up to 800 ℃, and the relation between H and cobalt content ( Co % ) is also linear when Co20 % .

Fe-Mo-Mn-Sn-Ce-C烧结合金体系与强化烧结工艺研究

Alloy Sintered System and Strengthened Sintering Technology for Fe-Mo-Mn-Sn-Ce-C

对碳纤维增强SiC／酚醛树脂烧结合金的高温耐磨性能及其耐磨机理进行了详细研究.结果表明，适量的酚醛树脂及碳纤维的加入有利于烧结合金耐磨性能的提高。

The high temperature wearability and the mechanism of wearing-resistance of carbon fiber reinforced SiC / phenolic aldehyde sintered alloy were studied and discussed . The results indicate that suitable amount of phenolic aldehyde and carbon fiber is beneficial to the wearability of the sintered alloy .

通过组织和性能分析认为：Y2O3对细化合金粉及烧结合金晶粒度的作用最明显，以W4O（11）为基添加氧化物比以WO3为基的性能优良。

It has been concluded by analyzing structures and properties that Y_2O_3 has the most obvious roles in fining alloyed powder and grain size of sintered alloys . The properties by adding W_4O_ ( 11 ) in matrix are superior than that by adding WO_3 in matrix .

配合发动机高质量气门座的研发，对Fe-Cr-Mo-Ni-Co-C粉末烧结合金致密化过程及其对产品性能的影响进行了实验研究。

For researching and developing a high quality gas-valve seat , the densification processes and its effects on property of a sintered alloy of Fe-Cr-Mo-NiCo-C were studied .

应用粉末冶金烧结合金化及温压成形技术，制备了Fe-Mo-Mn-Cu-W-C烧结硬化钢摩檫材料，研究了该材料的组织结构和性能。

Powder Metallurgy sintered alloying and warm compaction techniques were used to prepare the Fe-Mo-Mn-Cu-W-C sintering-hardened frictional materials , and the microstructure and properties of the materials were also investigated .

无铅汽油发动机高性能烧结合金钢气门座的研制

Development of Sintering Alloy Steel Valve Seat for lead-free Petrol Engine

有机-无机烧结合金型复合材料的重结晶过程及结构

Recrystallization Process of Organic-Inorganic Sintered Composite and Burned Structure of Material

陶瓷刀具硬态车削铁基烧结合金的磨损性能

Wear Characteristics of Ceramic Tools in Hard Turning of Iron-Base Sintered Alloys

烧结合金致密化过程及其对性能的影响

Densification of a sintered alloy and its effects on properties

增强型有机-无机高分子烧结合金形成机理的研究

Studies on the Formation Mechanism of Reinforced Organic & Inorganic Macromolecular Sintered Alloys

在润湿角为0°附近温度烧结合金性能最佳。

The optimum sinter temperature is at which wetting angle is around zero .

铌-钛-镍液相烧结合金及其性能

Liquid phase sintered Nb-Ti-Ni alloy and its properties

酚醛树脂包复石墨对铁基烧结合金材料性能影响的研究

The research of performance effect of phenolic resin covered graphite for sintering iron-base alloy material

铁基烧结合金表面处理技术的研究进展

Surface treatment of sintered iron-based alloys

烧结合金型材料中碳含量及碳、杂质晶体的形态与结构

Carbon content , morphology and construction of carbon , impurity crystal in burned alloy type material

运用扩散方程对Fe－Cu粉末烧结合金化程度与时间的关系作了估算。

The relation between alloying degree of Fe-Cu sintered alloy and sintering time was estimated by diffusion equation .

研究了含铬耐磨铸铁的烧结合金与45钢的组合烧结。

Combined sintering between sintered alloy with the composition of chromium wear-resistant casting iron and 45 steel has been studed .

烧结合金金相组织主要是马氏体组织，但组织中存在大量孔隙，因此表现出强度都很低。

There are a large amount of pores in the sintering alloy tissue having mainly martensitic structure , which explains the very low intensity .

粉末冶金铁基烧结合金在工业中的应用已越来越广泛，但由于孔隙的存在，耐磨性、耐蚀性和抗疲劳性均有待改善。

Sintered iron-based alloys are being used increasingly in industry , but greater hardness and wear-and corrosion-resistances are demanded because of existing open porosity .

碳纤维增强有机一无机高分子烧结合金型新材料的研究&（Ⅲ）有机高分子含量及烧结方法的影响

Study on a New Material-a Carbon Fiber Reinforced Organic-In organic Macromolecule Sintered Alloy (ⅲ) The Effect of Organic Macromolecule Materials Content and the Sintering Methods on Properties of the Sintered Alloy

碳纤维增强有机－无机高分子烧结合金型新材料研究&（Ⅰ）不同有机高分子材料对烧结合金亚微形态及性能的影响

Study on a New Material ── a Carbon Fiber Reinforced organic-Inorganic Macromolecule sintered Alloy ( I ) The Effect of Different Organic Macromolecule Materials on the Sub-microstructure and Properties of the Sintered Alloy

碳纤维增强有机－无机烧结合金型新材料的研究（Ⅳ）有机高分子在无机材料中的热解机理及其表观活化能谱的研究

Study on a New Material-Carbon Fiber Reinforced Organic-In organic Macromolecule Sintered Alloy ( IV ) Study on the Thermal Degradation Mechanism of Organic Macromolecule Materials Surrounded by Inorganic Materials and the Apparent Activation Energy Spectrum