水温
- water temperature
-
在你跳入之前你应该测试水温。
Test pool 's water temperature before you plunge in .
-
中性水体pH与水温的关系及在环境评价中的应用
Relationship between pH and water temperature in neutral water body and its application in environmental assessment
-
入水之前先试一试水温。
Test the heat of the water before getting in .
-
水温大约40度。
The temperature of the water was about 40 degrees
-
要么用浴用温度计测量水温,要么用手腕试一下。
Either measure the temperature with a bath thermometer or test the water with your wrist
-
这个特殊的盆子可以使水温不变,用它洗脚能让老年人保持温暖、更加健康。
The special basin can keep the water warm . So washing feet with it will help old people become healthier and more relaxed .
-
在大约45℃-50℃的水温下洗一个20分钟的热水澡,不仅可以在一天结束时得到极大的放松,还能使你的体温升高几度。
A twenty-minute warm shower at a temperature of about 45 ℃— 50 ℃ not only is a great relax at day 's end , but also raises your body temperature by several degrees .
-
农田土壤中N2O释放的水温特征研究
Characteristics of N_2O Emissions from Farmland Responding to Water and Temperature
-
水温、pH、沉淀时间等对絮凝沉淀过程的影响。
On the process of flocculation and precipitation .
-
水温和pH对饮用水中铝形态分布的影响
Effects of Temperature and pH on the Distribution of Aluminum Species in Drinking Water
-
在采集水样的同时,检测水样的水温、pH值等指标并收集医院供水系统相关资料。
Meanwhile , the temperature and pH value were tested and associated factors of water distribution systems were collected .
-
反应的最佳pH≤1,最佳水温为40℃。
The optimal pH value range is pH ≤ 1 , and the optimal reaction temperature is 40 ℃ .
-
以一维水温垂直分布数值模型为例,探索Kalman滤波法在海温观测数据同化中的应用。
The Kalman Filter method is explored by assimilating sea temperature observations into one-dimensional numerical temperature model .
-
方法通过实验室检测和现场观察,利用单因素分析和正交实验方法确定水温、pH、粒度、接触时间、再生剂浓度对蛇纹石降氟容量的影响。
Methods Determine the effect of each factor to defluoridation capacity of Serpentine by the methods of single factor analysis and orthogonal experiment .
-
用于汽车水温监测的PTC热敏电阻的性能研究
Performance Study and Design of PTC Thermistors Used in Automobile Water Temperature Detection
-
A/D模块我们用DSP自带的A/D模块,实现水温,油压的测量。
A / D module we use the A / D module in the DSP and measure the temperature of water and pressure of the oil .
-
并针对水温控制过程中的纯滞后问题提出了一种自校正PI控制器的设计方法。
A design of auto-adaptive PI controller is stated , aimed to the pure delay problem in the water temperature control process .
-
电化学测试表明水质中pH值、腐蚀性离子、水温等对无钝化膜铜材料的腐蚀速率均产生影响。
Electrochemical tests showed that the pH value in water , corrosive ions , water temperature had an impact on the corrosion rate of copper without passive film .
-
初步探讨了水温,pH值,氧化时间等因素对高锰酸钾预氧化反应影响,以及高锰酸钾在常规工艺基础上的净化效能。
Effect of water temperature , pH value , oxidation time on potassium permanganate pre-oxidation and oxidation efficacy on the basis of conventional water treatment process were studied by test .
-
NRX(JT)精密数字水温测量台
NRX_ ( JT ) Digital Precise Water Temperature Measurement Platform
-
实验研究了循环时间、苯酚初始浓度、二甲苯初始浓度等因素对降解率的影响以及水温、pH值随循环时间的变化。
Effects of circulation-time , the initial concentration of phenol , the initial concentration of xylene on degradation and effects of circulation-time on water temperature and pH value were experimentally studied .
-
利用NOAA卫星AVHRR图像对渤海表层水温年变化的初步分析
Preliminary Analysis of Annual Variation of Surface Water Temperature in Bohai Sea from NOAA AVHRR
-
本文在三维POM模型的基础上建立了一个用于预测电厂温排水对受纳水体水温分布影响情况的三维热输运数学模型。
The article establishes a mathematic model-3D heat transfer model based on POM model for simulating the impact of heated discharge .
-
结果表明,底泥的性质、水温及pH、溶解氧和藻类的生长,对氮素转化都有一定的影响。
The results demonstrate that the nitrogen conversion in water is affected to a certain extent by the nature of the sediment , temperature , pH , DO and the growth of algae in water .
-
水温低于14℃时胚胎发育停止于高囊胚,12h后受精卵开始变浊死亡;
The embryos development stopped at the stage of blastula below 14 ℃ and the fertilized egg died after 12 hrs ;
-
结果表明:聚天冬氨酸可应用于高钙、高钡离子浓度、较高水温和pH较高的水系统;而且可在水温较高的系统中长时间停留。
A conclusion is drawn that PASP could be used in water system with high Ca2 + and Ba2 + concentration , temperature and high pH , and could stay long time in high temperature water system .
-
pH过高,水温过低,有机物污染严重,均可降低该消毒剂杀灭水中大肠杆菌的效果。生肉的污染情况最为严重,阳性率1296%。
Coli in water would decrease in case of high pH , low water temperature or heavy contamination by organic substances . The most heavy contamination by three food borne pathogens are in raw meat ( 12.96 % ) .
-
实验时,槽内充水,水深20cm,水温(25±2)℃。
There was water of 20 cm wide at ( 25 ± 2 ) ℃ during the experiment .
-
在水温25℃下SOD基因mRNA的表达量逐渐上升,在注射后6小时达到最大值,约为对照组的1.5倍,空白对照组的2.2倍。
The mRNA expression of SOD gene rose gradually in 25 ℃ water temperature and reached maximum in 6 hours after infection , about 1.5 times of blank control and 2.2 times of saline control group .
-
此外,高强度的快速搅拌,常温范围内水温升高均有助于增强CPF对污泥的混凝沉降效果。
High speed and strong agitation and higher temperature than normal are favorable to enhance the precipitation of using CPF .