工作容积

最大设计车速不超过50KM／h、发动机气缸总工作容积不超过50ml的两轮机动车。

The maximum designed speed is not morethan 50 km / hr , the total work capacity of the engine cylinder is not exceeding 50 ml two-wheeled motor vehicle .

工作容积的计算是泵&蓄能器系统设计中的重要问题。

The calculation of working volume is an important problem in the design of pump-accumulator systems .

本论文以化纤废水为原料，研究了工作容积为25L气升环流反应器对生化处理化纤废水的影响，并对该系统的最优工艺条件做了探讨。

In this paper , a 25L airlift loop reactor was applied to treat chemical fiber wastewater .

蓄能器工作容积的计算探讨

Inquiry into calculating work volume of hydraulic accumulator

引擎种属和工作容积

Engine family and displacement

引擎种属和工作容积一个命名属或亚属的真名模式，亦即其命名种。

Engine family and displacement The nominal species that is the name-bearing type of a nominal genus or subgenus .

经大量的计算和例证说明，由极值法确定的工作容积更加合理。

A lot of calulations and examples show that the working volume-calculated by the extremum method is more available .

本文介绍了一种新型的工作容积为0.2升的数字显示式小籽粒谷物容重器，以解决品种资源和育种研究工作中样品量少的需要。

The paper introduces a new type digital display test weight apparatus with working volume of 0.2 liter to adapt small quantity of sample in the field of crop germplasm resources research and crop breeding .

通过对旋叶式压缩机中背压腔、工作容积和压缩机内油路之间的泄露、和能量的转化研究，得出了一种背压腔压力的计算方法。

Considering the leakage and mass transfer between back - pressure cavity , compression chamber and oil system , the thermodynamic model of the back - pressure cavity for rotary vane compressor has been developed .

比较了上述两种工况下压缩机、冷却水泵、冷却塔风机、冷水泵和乙二醇泵的功耗差别，并进一步推出系统总能耗的差别和压缩机总工作容积的差别。

Compares energy consumption of the compressor , all pumps and cooling tower fans under the two different working conditions , deduces the total energy consumption difference and the compressor working volume difference between the two systems .

仿真分析了系统在不同输入控制量下的静、动态输出特性，并分别研究了摩擦力、负载、气源压力和工作容积4个主要因素对系统特性的影响。

The system static and dynamic output characteristics under different control inputs were simulated and analyzed . The influences of four major factors including friction , load , supply pressure and working volume on system characteristics were studied .

在单缸摩托车汽油机上进行试验，结果显示，发动机输出的最大功率和最大扭矩提高了6%-8%，并且随着谐振器工作容积的变化，功率和扭矩的变化也呈现一定的规律性。

Results showed that , in a certain velocity interval , resonance of gas intake can improve the maximum power and torque of motorcycle engine about 6 to 8 percent , and with the changes of resonator 's cubage , the power and torque of engine are changed regularly .

一种涡旋机械工作腔容积的简化算法

A Simplified Method of Calculating Working Chamber Volumes for Scroll Machinery

内啮合转子压缩机工作腔容积和转角变化的关系是进行压缩机热力计算的基础，目前还缺乏相应的计算公式。

The relationship between the volume of working chambers and rotating angles is the basis to do the thermodynamic calculation for the internal-meshing rotary compressor .

以往流量计算多以容积的变化量计算为基础，这势必忽略了齿轮泵工作腔容积对齿轮泵工作性能的影响。

The flow rate calculation is usually based on the variable of cubic content , which will ignore the influence of the cubic content in working capability of gear pump .

详细分析了整数圈数双头涡旋齿涡旋盘所受的切向力气体力、法向气体力、轴向气体力，提出了在任意曲轴转角下的各种气体力及各个工作腔容积的计算公式。

On the basis of the analysis of each gas force in the twin - scroll compressors , the calculation formulae of working volume and each gas force at all different crankshaft angles were derived .

根据所选马达的耗气量与潜艇续航时间计算满足要求的高压气瓶的工作压力和容积。

Working pressure and volume of the required high-pressure air bottle were calculated according to air consumption of the selected air motor and the cruise duration of submarine .

对工作压力0.6MPa、容积10m3氢气储罐在生产运行使用过程中发生爆炸的严重事故作了叙述和分析，同时由事故得出了防范和改进措施。

The serious explosion accident of 10 m3 hydrogen-holder ( with work pressure 0.6 MPa ) in operation is presented and analyzed , and the precautionary measures and improving measure are given .

这种新型压缩机有Z2个工作腔，工作腔容积变化周期为Z2πZ1，容积变化规律对压缩机的工作过程很有利。

Theoretical analysis for the new rotary compressor shows that it has Z2 working chambers and their volumes are varied during Z2 π / Z1 periodically .

如果一年中球罐的工作压力变化幅度不大，则可取平均工作压力来计算容积的增大值。

If the variation of operation pressure of spherical tank is negligible in one year , the mean operation pressure must be taken to calculate the increment of volume .

目前，有关教材及手册对齿轮泵的工作原理几乎一致认为：当泵的齿轮旋转时，随着啮合点变化，吸油腔工作容积增大，形成部分真空，产生吸油作用；

At present , a common viewpoint on working principle of gear pump is that : the working volume increases and a vacuum is generated inside the oil drawing cavity as meshing points change during rotating of the gear ;