屈强比
- yield ratio
-
热轧低屈强比大线能量焊接建筑钢力学性能与组织研究
Research on the mechanical properties and microstructures of hot-rolled low yield ratio and high heat input welding construction steel
-
去应力退火后材料的冲击吸收能量都可回复到标准要求的韧度;退火后屈强比下降幅度较大,前热处理对屈服强度有明显影响,而抗拉强度基本不受前热处理影响。
The material impact absorption energy can recover to the standard value after stress relief annealing . The yield ratio decreases a lot after annealing . The pre-treatment has great effect on the yield strength , but has little effect on the tensile strength .
-
针状铁素体/马氏体高强度低屈强比双相钢的EBSD研究
The EBSD Study on an Acicular Ferrite / Martensite Dual-Phase Steel with High Strength / Low Yield Ratio
-
双相钢(DP)作为一种先进高强钢,具有强度高、屈强比低、初始加工硬化速率高以及强度和延性匹配好的特点。
As one of advanced high strength steel , dual phase ( DP ) steel is widely used in producing cars nowadays and in the coming future .
-
60kg级低屈强比耐火钢的实验研究
Experimental Study of Low Yield Ratio Fire Resistant Steel of 60kg / mm ~ 2 Grade
-
本文对化学成份相同、屈强比不同的两种高强钢进行了三点弯曲CTOD试验。
Three point bending CTOD tests have been conducted for two kinds of high strength steels with same chemical compositions but different yield ratio .
-
耐火钢中保持10%左右,细小、弥散分布在晶界处的M-A岛,是保持低屈强比和耐火钢良好高温性能的一个主要原因;
The fine distribution of M-A island is a mostly factor of keeping significant high-temperature properties and low yield ratio on fire-resistant steels for building .
-
降低耐大气腐蚀用钢屈强比的研究
Research on Reducing the Yield Ratio of Atmosphere Corrosion Resisting Steel
-
高屈强比管线钢的安全性分析
Analysis on Security of Pipeline Steel with High Yield Ratio
-
起落架用超高强度钢的屈强比问题
A question about yield-to-strength ratio of ultra-high strength steel for landing gear
-
高强度低屈强比建筑用钢板的研究开发
Development of High Strength and Low Yield Ratio Steel Plates for Buildings
-
热轧后停留时间对带钢屈强比影响的研究
Effect of Delay Time After Hot Rolling on Yield Ratio of Strip
-
热轧带钢屈强比研究
Study of the ratio of yield strength and tensile strength of hot - rolled strip
-
免热处理高强度低屈强比铆螺钢的研究
Study of High Strength and Low Yield Ratio Cold Heading Steel not Requiring Heat Treatment
-
但抗拉强度将随卷曲温度的降低而有少量损失,而屈强比提高。
But the tensile strength will be reduced a little , and the yield ratio increased .
-
轧后控冷终冷温度对高强度管线钢屈强比的影响
Effects of finish rolling temperature on ratio of yield to strength in high strength pipeline steel
-
屈强比为0.76;延伸率由原始的44%下降到7.2%,且显微硬度显著增加。
The coefficient of elongation drops from 44 % to 7.2 % and original and micro-hardness increase obviously .
-
本文对高强度低屈强比建筑用钢进行了实验室生产研究。
In this paper , steel plate for buildings with high strength and low yield ratio was studied in laboratory .
-
弹性模量设定对胎圈钢丝破断伸长率和屈强比测试结果的影响
Influence of the range of elastic modulus on the determined elongation at rupture and yield strength ratio of bead wire
-
含氮量为0.06%含钒0.27%的马氏体不锈钢屈强比达到0.85;
Yield ratio of martensitic stainless steel is 0.85 when nitrogen and vanadium contents are 0.06 % and 0.27 % separately .
-
中碳铬-镍-钼钢的超高强度和超低屈强比现象
Phenomenon of Ultra High Strength and Ultra Low Ratio of Yield Strength to Tensile Strength in a Medium Carbon Cr-Ni-Mo Steel
-
管线管的残余应力及控制:高强度管线钢的屈强比问题;
Residual stress and its control of line pipe ; the ratio of yield to tensile strength of high strength steel line pipe ;
-
研究了氮含量对热镀锌双相钢拉伸性能的影响,用定拉伸试验方法模拟了平整伸长率对热镀锌双相钢屈强比的影响。
Using scaling tension test method simulated the effect of leveling elongations on yield strength ratio of hot dip galvanized dual phase steels .
-
研究了变形和冷却参数与钢的屈强比、缺口冲击功、延伸率等的关系。
The effects of deformation and cooling parameters on the yield ratio , Charpy notch impact toughness and elongation of the steel were investigated .
-
而其后的人工时效处理能明显提高合金的屈服强度和屈强比,但也明显降低了延伸率。
, and YS ( yield strength ) and the value of YS / UTS increase through the followed artificial ageing with obvious loss of elongation .
-
应变率增加,材料强度提高,屈强比增大,塑性略有降低,但流变阶段应变率强化系数基本不变。
Raising the testing strain rate , the strength and yield ratio increased the plasticity slightly decreased , but the strain rate hardening index kept constant .
-
对低屈强比建筑用耐火钢进行了实验研究,介绍了实验钢的化学成分、实验工艺、力学性能等;
A fire-resistant steel with low yield rate was tested , and the chemical compositions , experimental parameters , mechanical properties of the steel were presented .
-
管体屈服强度和屈强比有明显变化,其主要影响因素是防腐前的中频加热温度。
There is clearly changed on yield strength and ratio of yield and tensile strength and the main affecting elements is middle frequency heating temperature before coating .
-
抗大变形管线钢就是基于应变设计的方法得到的具有连续屈服、较低的屈强比、较高的加工硬化指数以及均匀塑性变形延伸率等特性的管线钢。
The pipeline steel with strain-based design is usually characterized by high initial work hardening rate , good ductility , and low yield stress to tensile strength ratio .
-
受非马氏体组织的影响及可动位错密度降低的作用,屈服强度、屈强比随退火温度升高而升高。
The yield strength , yield ratio increase with the increase of annealing temperature , due to the impact of non-martensite and the decrease of movable dislocation density .