尼龙纤维

碳纤维－尼龙纤维混杂改性水泥力学性能及显微结构观察

Mechanical properties and microstructure of mixed carbon nylon modified cement

通过人工气候试验和70°C饱和氢氧化钙溶液浸泡试验，对尼龙纤维水泥基复合材料的老化性能进行了研究。

The Weatherability of nylon fiber reinforced cement composites were studied with xenon lamp exposure and immersing in 70 ° C saturated calcium hydroxide .

对尼龙纤维拔出荷载-位移曲线和拔出尼龙纤维表面SEM照片进行的分析表明：低温（40℃）时的尼龙纤维-橡胶界面破坏属粘结破坏；

The load-displacement curves of the pull-out test and the SEM photographs of the fibers ' surfaces were analyzed .

尼龙纤维网增韧MDF水泥材料抗折性能的研究

Study on the Flexural Properties of Nylon Fibre Web Laminated MDF Cement Composite Plates

尼龙纤维增强MDF水泥的力学性能研究

Mechanical Properties of Nylon Fiber Reinforced MDF Cement

制备了以MDF水泥为基体的尼龙纤维增强复合材料并对其力学性能进行了测试。

The preparation and the mechanical properties of nylon fiber reinforced MDF cement composites are reported .

以改性EPS颗粒为保温骨料，石膏-矿渣胶凝材料为胶结材料，辅以尼龙纤维和活性激发剂，可配制保温性能良好的墙体材料。

The wall material made by modified EPS grain as insulation material , gypsum-slag as binding material , nylon and activator had good thermal insulation .

结果表明，添加尼龙纤维和聚丙烯载体显著提高牛粪厌氧发酵的沼气产量（P<0.05）和总COD去除率（P<0.05），玻璃纤维对沼气产量和总COD去除率的影响未达到显著水平。

The results showed that nylon fiber and polypropylene net ball significantly enhanced ( P < 0.05 ) the biogas production and COD removal rate , but fiberglass did not .

结果表明在MDF水泥基体中加入少量尼龙纤维可以有效地提高材料的抗冲击性能。

The results indicate that small volume fraction of nylon fiber in MDF cement matrix could improve impact performance of the composites .

对槽道纤维悬浮流进行染色线流动显示和流场PIV实验测量，实验中选用的是直径为20μm、长径比为20～100的尼龙纤维。

Dye emission techniques and PIV measurements were made to investigate the channel flows of fiber suspensions . In the experiments , the nylon fibers with 20 μ m long and 20 ~ 100 aspect ratio were used .

本文通过原位聚合的方法制备了聚苯胺/玻璃纤维复合材料、聚苯胺/尼龙纤维复合材料，作为天然橡胶的新型增强材料，并利用机械混炼法制备短纤维增强天然橡胶复合材料（SFRC）。

The polyaniline ( PANI ) / short glass fiber composites and the polyaniline / short nylon fiber composites were prepared by in-situ polymerization in this paper . Both of them as a new type of reinforcing agent were mixed with NR by mechanical mixing called SFRC .

碳&尼龙纤维混杂改性水泥基复合材料的力学性能研究

A study of mechanical behaviour of the carbon and nylon fiber mixture modified cement

类似丝绸的尼龙纤维。

Identification of nylon fibers silklike nylon fabric .

尼龙纤维工业及市场动向

Nylon Fibers : Industry and Market Trends

本文介绍了尼龙纤维编织吊带的形式、性能及规格。

This paper introduces the shape , characteristics and specifications of nylon-fiber woven hoisting belt .

尼龙纤维水泥基复合材料的老化性能研究

Weatherability of Nylon Fiber Reinforced Cement Composites

采用单纤维拔出的方法，研究了不同温度下尼龙纤维-橡胶复合材料的界面特性。

The interface properties of nylon fiber-rubber composites were studied by using single fiber pull-out method .

尼龙纤维鉴别试验方法

Identification of nylon fibers

某引起尼龙纤维光亮的外观与羊毛纤维色光比较暗淡的表面形成了鲜明的对比。

The bright , shiny appearance of some nylons contrasts sharply with the relatively dull surface of wool .

同时，通过计算分析了不同温度下尼龙纤维-橡胶复合材料界面粘附剪切力和界面破坏能的变化。

The interface shear stress and fracture energy of nylon fiber-rubber composites at different temperatures were also discussed in the paper .

尼龙纤维需求远低于一年前，而原料成本同时也在下降。

Demand for nylon fibers is much lower than a year ago while raw material costs are also falling at the same time .

对碳纤维&尼龙纤维混杂改性水泥基复合材料研究表明，该方法是提高水泥基复合材料强度和韧性的最有效方法。

A study of the carbon and nylon fibre mixture modified cement has been conducted by the authors , which shows that this way is the most effective method to enhance the strength and toughness of the mixture modified cement .

以塑料为基体，用玻璃纤维、碳纤维、硼纤维、尼龙纤维等增强的复合材料，其强度和刚度都已接近或超过金属材料，进一步扩大了塑料在汽车上的应用范围。

Composite material is matrix with plastics and strengthen use glass fiber , carbon fiber , peng fiber and nylon fiber etc. Its strength and rigidity has been closed or exceeded metal material , and has enlarged scope further that the application of plastics in automobile .

尼龙纤维、聚丙烯球和玻璃纤维使随污泥排出而流失的细菌数量分别降低11.30%（P<0.05）、22.84%（P<0.01）及13.01%（P<0.05）。

In comparison with the control , amount of bacteria in the outflow fermented decreased by 11.30 % ( P < 0.05 ), 22.84 % ( P < 0.01 ) and 13.01 % ( P < 0.05 ) respectively in reactors with nylon fiber , polypropylene net ball and fiberglass .

预处理尼龙短纤维用于V带的性能试验

Pretreatment Nylon Short Fabric Applied to Property Test of " V " Belt

MC尼龙6/Kevlar纤维复合材料的动态流变性能

Dynamic Rheological Properties of MC Nylon 6 / Kevlar Fiber Composites

复合胺改性尼龙6纤维染色性能的研究I.染色工艺及其染色机理

Research on the Dyeability of PA 6 Fiber Modified by Compound Amine I. Dyeing Conditions and Dyeing Mechanism

本研究采用紫外线（UV）对渔网材料尼龙-6纤维辐照，继而进行接枝AA的表面凝胶化改性研究，以制备一种能防止海洋污损生物附着的渔网材料。

Nylon-6 fishnet materials were irradiated by UV , and grafted by AA to prepare a kind of anti-halobios coherence fishnet .

从尼龙6纤维的酸性染料染色机理出发，讨论了影响纤维酸性染料染色性能的因素，包括热处理条件、pH值、温度等；

The factors of influencing the dyeability of nylon 6 fiber including temperature , pH value and heat treatment condition were discussed from its dyeing mechanism with acid dye .

当尼龙66纤维的含量为7%，SiO2的含量为20%时所得聚氨酯泡沫塑料的力学性能增强最佳。

When the contents of nylon 66 fiber and SiO_2 particle are 7 % and 20 % , respectively , the optimized reinforcement effect of the hybrid rigid polyurethane composite foam can be mechanically realized .