固相线

较高的F含量使岩浆固相线温度大大降低，有利于岩浆分异演化并形成接近端员组分的钠长石和钾长石；

The increase of fluorine content might have resulted in the decrease of solidus temperature and benefited the evolution of magma and the formation of K feldspar and albite approximately with end member composition .

古老岩石圈橄榄岩的固相线温度受地幔熔/流体的长期交代而降低。

The solidus temperature of the cratonic lithospheric peridotite fell due to the long-term metasomatism of the mantle molten / fluid bodies .

用铁的熔化热校正铁碳相图固相线及H点的研究

Correction of Solid us and Point H in the Fe-C Binary Phase Diagram by Using the Melting Heat of Iron

随着Bi含量的增加，钎焊接头抗拉强度也随着增加，同时钎料的液固相线温度均降低。

With the increase of the Bi content , the solder joint strength rises , but the liquidus temperature and the solidus temperature decrease .

在溶质截留模型中，综合考虑弛豫效应和非线性液固相线的影响，对Aziz模型进行了修正；

The effect of curvature and relaxation were introduced in solute trapping model of Aziz .

交流磁场对Al-11.4%Cu合金液相线、固相线温度的影响

Influence of Alternating Magnetic Field on the Crystal Process of Al-11.4 % Cu Alloy

超固相线液相烧结

Supersolidus Liquid Phase Sintering

作者研究了此系统的有关化学反应和固相线温度以下的矿物共存关系，发现了两个新相区。

In this paper , chemical reactions and subsolidus-phase coexistence relationship in the system are discussed , and two new phases are found .

球磨后的高合金工具钢粉末固相线温度为1161℃，确定烧结温度范围为1100℃左右。

The sintering temperature is selected as about 1100 ℃ because the solidus temperature of the ball-milled high-alloying tool steel powders is 1085 ℃ .

三是从液相线温度冷却至固相线温度时析出的脱氧产物，称为三次脱氧产物。

Another is called thirdly deoxidizing products that appear at the time of cooling the steel from liquid phase line temperature to solid phase line temperature .

测试了合金的浇注温度，液相线温度和固相线温度，得出合金的凝固温度区间为71℃。

From the experimental data , the pouring temperature , liquidus and solidus temperatures of the alloy are obtained , and the solidification range of the alloy is determined as 71 ℃ .

系统包括参数录入、数据更新、数据查询和液固相线温度计算模块，实现了对参数数据的集中有效管理。

This system contains four modules : data input , data update , data search and solidus / liquidus temperature calculation , which can achieve managing the thermal physical parameters expediently and efficiently .

该模型根据糊状区溶质传输和反扩散理论，基于变热物性参数，采用钢中多组元成分的百分含量计算液、固相线温度。

The liquidus and solidus in the mushy zone was calculated based on back diffusion and a database for multi-component steel with the thermal-physical parameters depended on composition , temperature and solid fraction .

通过测试和分析Al-11.4%Cu合金在交流磁场中凝固的电阻，确定了合金液相线和固相线温度以及结晶区间。

The liquidus temperature , solidus temperature and crystal interval of Al-11.4 % Cu alloy are determined by testing and analysing the resistance of Al-11.4 % Cu alloy solidified under an alternating magnetic field .

增厚前岩石圈地幔底部温度高于橄榄岩湿固相线温度，并受闪石和金云母高压脱水作用的影响。

The temperature at the bottom of the lithospheric mantle was higher than the wet solidus temperature of peridotite before the thickening of the lithosphere , and was affected by the thickening-related dehydration of amphibole and phlogopite .

指出，由喷雾转化法生产的纳米WC&Co复合粉是一种预合金粉，它的烧结应该属于超固相线液相烧结范畴。

It is pointed out that the nanophase WC-Co composite powder prepared by SCP is a kind of prealloyed powder , so its sintering should belong to the category of supersolidus liquid phase sintering ( SLPS ) .

结果表明：（AgCu28）80In11Sn9合金具有较低的固相线温度和熔程、简单的物相结构、适中的铺展率。

The results show that ( AgCu_ ( 28 )) _ ( 80 ) In_ ( 11 ) Sn_9 alloy has a low solidus temperature and melting range , a simple phase structure and a moderate spreading ratio .

指出焊接温度是复合材料扩散焊接最重要的工艺参数，焊接温度介于基体合金固相线与液相线之间，接头强度最高值可达到170MPa；

The results indicate that the welding temperature is the most important factor for diffusion welding of composite . When the welding temperature range is between solidus and liquidus , the peak joint strength can reach 170 MPa .

分别使7075铝合金在磁场强度为0.06T的直流磁场或交流磁场作用下凝固，通过在凝固过程中测定电阻温度曲线，确定了合金在不同条件下凝固的液相线和固相线温度。

The 7075 Al alloys were solidified under DC or AC magnetic field with magnetic density 0.06 T respectively . The liquidus and solidus temperatures of the alloy at different conditions were determined by recording resistance-temperature curves during solidification .

气/液/固三相线界面区的性质在金属腐蚀阴极过程中的作用

Effect of gas / liquid / solid three-phase boundary zone on cathodic process of metal corrosion

气/液/固三相线界面区对阴极电化学过程影响的研究进展

Research Progress on effect of gas / liquid / solid three phase boundary area on cathodic processes

GB/T6526-1986自熔合金粉末固-液相线温度区间的测定方法

Self-fluxing alloy powders & Determination of solidus-liquidus temperature range

过渡金属二元连续固溶系液相线、固相线的计算机预报

Computerized prediction of liquidus and solidus curves of binary alloy systems of transition metals with continuous solid solutions

初级金属固溶体的固相线

On the Solidus of Primary Metallic Solid Solutions