后悬

大客车后悬和轴距的合理匹配

Reasonable Matching of the Rear - overhang to the Axle-base for Large Buses

6110后悬置软垫注射模具的设计

Design of 6110 Back Suspended Soft Pad Injection Mold

悬索桥重力式锚碇锚体后悬段挑梁支撑法施工

The Corbel Supported Method for Constructing the Back Suspended Part of the Weight Anchor Block

通过优化前后对比分析，显示优化后悬置系统隔振性能得到明显改善。

The result obtained by contrastive analysis shows that the vibration isolation performance of Optimization Model of power-train mount system is improved .

模板拆除后悬挑结构最大下沉量仅为4.3mm，效果良好。

After formwork is dismantled , the maximum subsidence of the overhanging structure is only 4.3 mm , achieving a good effect .

适当增加洒水车后悬的刚性，以避开车和水箱的共振峰值，将有利于减少水箱的晃动。

If the rigidity of rear suspension is probably increased to avoid the resonance peak value between the car and water tank , it can reduce the shake of water tank .

对于车高控制部分，对前悬两个空气弹簧独立控制，后悬两个空气弹簧一同控制，并对每组控制器分充放气过程进行控制。

For the height control part , two air springs of front suspension are controlled separately and two rear suspension are controlled together . For each single controller the gas charge and exhaust processes are considered too .

同时，本文对架体拆除后悬挑部位的监测结果进行分析，探讨了架体拆除过程中整体结构力的传递过程和受力特点。

At the same time , the monitoring results can be analyzed from the rack on the cantilever parts so as to investigate the overall structural internal force of the transfer process and the mechanical characteristics of the structure during removal of the rack .

对牵引车采用稍小的后悬挂静挠度和较小的后轴轮距，半挂车采用大断面边梁；从而设计了低台面直梁式多用重型半挂列车。

Applying smaller rear - hanging static deformation and smaller distance of rear axles to drawing train , and applying side frame with big section half - hanging train , which can design multi - used heavy half - hang - ing train with low - board straight girder type .