厂用电

chǎng yòng diàn
  • auxiliary power;station service;house supply
厂用电厂用电
厂用电[chǎng yòng diàn]
  1. 厂用电系统中纵联电流差动保护的配置与整定

    Longitudinal Differential Current Relay and Its Setting Calculation in Station Service System

  2. 300MW火电机组仿真机厂用电系统的仿真

    Simulating of Station Service System for 300 MW Electric Power Simulation Unit

  3. 水电站PLC厂用电自动切换控制系统的设计与应用

    Design and application of PLC auto - changeover control system of power supply for hydropower stations

  4. FUR组合保护装置在江垭水电站厂用电系统中的应用

    Application the FUR Assembled Protector to Electricity Consumption System of Jiangya Hydropower Station

  5. 低压厂用电系统零序TA接线方法的选择

    Chosen of Connection Method of Low Voltage Auxiliary Power System Zero Phase-sequence TA

  6. 厂用电系统测控保智能单元及其与DCS融合模式的探讨

    Discussion on the intelligent unit of measurement , control and protection for house-service system and the integration mode with DCS

  7. 皂化渣是化工厂用电石法生产聚氯乙烯(俗称PVC)时生成的副产品,是电石渣参加皂化反应后产生的一种工业废渣,其主要成分为Ca(OH)2等。

    Saponification slag , which main composition is Ca ( OH ) 2 , is a by-product of chemical factories when they produce PVC by calcium-carbide-method .

  8. 300MWCFB机组降低厂用电的方法

    Methods of Reducing Auxiliary Power of 300 MW CFB Units

  9. 智能MCC控制保护管理装置在厂用电系统中的应用

    Application of Intelligent MCC Automatic Controlling Protection Management Apparatus in Auxiliary Power System

  10. 厂用电继电保护系统仿真建模研究DF(4B)型机车辅助发电跳固定发电原因分析

    Relay-protect Modelling of Generating Auxiliary Power System Reason analysis of abnormal changeover from auxiliary generating to fixed generating

  11. 600MW机组高压厂用电接线优化

    Optimization of HV Auxiliary Power Wiring for 600 MW Unit

  12. 浅析300MW循环流化床机组降低厂用电率的措施

    Measurements of Reducing the Auxiliary Power Consumption Rate for 300 MW CFB Boilers

  13. 高压厂用电系统微机综合保护与F-C开关配合问题分析

    Analysis of Co-ordination between HV Station System Microprocessor-based Comprehensive Protection and F-C Breaker

  14. 600MW火电机组厂用电相角差分析与仿真

    Analysis and Simulation of Angle Difference of 600 MW Thermal Unit Auxiliary Supply

  15. 600MW火电机组6kV厂用电接地方式初探

    Grounding of House Servicing Equipments in 600 MW Thermal Power Plant

  16. 影响600MW机组湿法烟气脱硫装置厂用电率主要因素分析

    Main factors affecting the power consumption rate of wet FGD equipment for 600 MW power unit

  17. 煤质和锅炉辅助系统对600MW机组厂用电率的影响

    Effect of Coal and Auxiliary Systems on Station Service Power Consumption Rate of 600 MW Unit

  18. 台山电厂2台国产600MW机组厂用电监测管理系统介绍

    Introduction of Auxiliary Power Supervision and Management System of Two 600 MW Units in Taishan Power Plant

  19. 200MW机组高压厂用电切换问题探讨

    Problem Discussion on High-voltage House Service Switching in 200 MW Unit

  20. 6kV厂用电谐振过电压分析及预防

    Analysis and prevention of resonance over-voltage of 6 kV auxiliary power supply

  21. 600MW级机组继电保护及厂用电控制设计现状及特点

    Status and Characteristic on Relay Protection & Auxiliary Power Control Design for 600 MW Grade Turbine Generator Sets

  22. 6kV厂用电系统操作过电压的危害及其抑制对策

    Impact of switching over voltage of 6 kV auxiliary power system and countermeasures

  23. 1000MW等级火电机组厂用电电压等级的选择

    Selection of Auxiliary Power Voltage Grade for 1 000 MW Thermal Power Units

  24. 1000MW机组高压厂用电电压等级优化

    Optimizing on Voltage Classes of HV Electrical Auxiliary System of 1 000 MW Units

  25. 600MW空冷机组厂用电电压等级选用6kV的讨论

    Discussions on the Selection of 6 kV as Service Power Voltage Class of 600 MW Air Cooling Generating Unit

  26. UPS的交流输入工作电源应接于机组厂用电的保安段,交流输入旁路电源接于机组厂用电的低压工作段。

    The work power source of AC input for UPS should be connected to the security section of the unit auxiliary power and AC input bypass power source connected to the LV work section of the unit auxiliary power .

  27. 200MW机组高压厂用电自动切换存在的问题较多,导致厂用电事故扩大。

    There are problems in automatic power changeover of HV station service that extends the power incident .

  28. 根据近年来多个600MW级以上容量等级的火电机组继电保护及厂用电设计方案,总结机组电气设计方案的特点,并提出了作者的观点。

    Summarized project and particularity of relay protection & auxiliary power control design for600MW grade turbine generator sets recently years and advice of author offered .

  29. 谈6kV配电系统的几种接线方式6kV厂用电切换分析

    Several connection modes of 6 kV distribution systems The Analysis of Shift for 6 kV Auxiliary Power in Power Plant

  30. 经分析计算,6kV高压厂用电系统只能采取中性点经低电阻接地方式,并配置单相接地保护。

    After calculation , neutral grounding through 35 Ω resistance with single phase grounding protection was chosen for the 6 kV HV auxiliary power system .