凝固时间

而且随着肝功Child分级的加重血液凝固时间愈长（P<0.05）。

The more severe hepatic disfunction for Child Grade , the longer the coagulation time ( P < 0.05 ) .

测定颈总动脉血栓形成后的大鼠全血凝固时间（CT）、血浆凝血酶原时间（PT）和活化部分凝血活酶时间（APTT），观察海带胞壁多糖对血液凝固的影响。

Blood coagulation time ( CT ), plasma prothrombin time ( PT ) and partial thromboplastin time ( APTT ) were measured to observe the effect of CWP on blood coagulation .

观察全血激活凝固时间（ACT）和术后24h渗血量。

Changes in blood active clotting time ( ACT ) and post operative bleeding were studied .

结果：①凝固时间为16.25分（7.5∶1，常温），粉液比减小凝固时间延长（P＜0.01）。

Results : The setting time was 16.25 minutes ( 7.5 / 1 ), and the lower the powder liquid ratio , the longer the setting time .

延长磁场中BiMn合金的凝固时间不能有效提高材料的剩磁性能。

The remanence of Bi-Mn alloys can hardly be enhanced by prolongating solidified time in a magnetic field .

研究者利用了肝素（一种多糖）和血液中的抗凝血酶III（一种多肽片断）之间的相互作用来控制凝固时间。

Researchers have used the interaction between a polysaccharide called heparin and a peptide fragment of a protein called antithrombin III , which is contained in the bloodstream to control clotting .

最初24h内，凝固时间与抗压强度和弹性模量成正相关，凝固2h后抗压强度达到极限强度的50%以上。

The crystallizing time evidently affected the strength and fragility in the first 24 h. The strength was still more than half of the ultimate strength within 2 h.

最后采用热凝固时间法（HCT）测定不同泌乳期、温度、pH值及相关助剂对山羊乳热稳定性的影响。

The effects of lactation period , heating temperature , pH and additives on the heat stability of goat milk were studied by analyzing the heat coagulation time ( HCT ) of the milk .

测试了HX－I型耐火代型材料的凝固时间、凝固膨胀率及与3种印模材料的相容性。

The setting time , the setting expansion ratio and the compatibility with impression materials of the HX I refractory die material were determined .

结果表明，对于AlCu合金，固相扩散主要由溶质扩散速率控制，而非局部凝固时间。显微偏析参数不仅取决于局部凝固时间，还要考虑凝固路径的影响。

The simulation indicates that solid-state diffusion is controlled mainly by the solute diffusing velocity but not the local solidification time for Al-Cu system studied , and the microsegregation parameters are affected not only by local solidification time but also by solidification path .

方法：以HDS为对照，测试CDS与氧化铝的热膨胀匹配性，并测试HDS和CDS的凝固时间及凝固膨胀率。

The setting time and setting expansion rate of CDS were measured with routine technique . Results : CDS showed much smaller thermal expansion with Al 2O 3 base coping than HDS .

根据材料的抗压强度和凝固时间选择50%wtCSH的BCP/CSH复合物组进入下一步实验。

Based on the compressive strength data and the solidification time , the BCP / CSH compound with 50 wt % CSH is chosen for the next experiment .

结果：LMWH在体小肠和十二指肠循环溶液及乳剂循环一定时间后，药量显著减少，血液凝固时间明显延长。

Results : The doses of LMWH in the circulated solutions and emulsions through the intestine or different parts of the intestine for some time decreased significantly and the blood coagulation time was prolonged .

实验表明，对于常规密度或高密度水泥浆体系，PQ均能有效控制水泥浆凝固时间，无早凝、过缓凝现象；

Laboratory indicated that PQ can effectively control the cement slurry setting time in the general density and high density cement slurry systems and there are no phenomena of premature hardening and excess slow hardening .

灌注后的凝固时间需40h以上，有效阻塞过水通道，钻孔的严重漏失可得到彻底封堵。

It should take 40 h or more for the solidifying to block the water passageway efficiently and stop the serious leaking from borehole completely .

目的探讨正常妊娠妇女和妊高征患者凝血酶原时间（PT）、部分凝血活酶时间（APTT）、凝血酶凝固时间（TT）及血浆纤维蛋白原（Fbg）等反映凝血功能4项指标的检测及临床意义。

Objective To evaluate the clinical signification of coagulation indexes prothrombin time ( PT ), activated partial thromboplastin time ( APTT ), plasma thrombin time ( TT ), fibrinogen ( Fbg ) in normal pregnancy women and in patients with pregnancy induced hypertension .

结果：骨水门汀的凝固时间满足临床操作的要求，在37℃、PBS液中浸泡5天后最高压缩强度达287MPa，溶解率增大，提高了表面生物反应性。

Results : The setting time of cement could meet the expectation of clinical operation . The compressive strength of cement was enhanced up to 28 7 MPa after immerging in the PBS at 37 ℃ for 5 days and the rate of dissolution and biological reactivity increased .

检测483例血小板捐献者的CPG诱导的血小板聚集率，并对聚集功能不良者进行活化血浆凝固时间（APCT）测定。

The platelet aggregation of 483 platelet donors was detected and the activated plasma clotting time ( APCT ) of donors who have deficiency in platelet aggregation was examined for investigating the incidence of defective platelet function among donors .

讨论了不同浓度NH4H2PO4促凝剂对α－Ca3（PO4）2（α－TCP）水化和硬化的影响，测试了相应的硬化物凝固时间和机械强度。

The authors discussed the effect of the set accelerator ( NH4H2PO4 ) on the hydration and hardening of α - Ca ( PO4 ) 2 ( ie α - TCP ), and tested the setting time and mechanical strength of the appropriate hardening products .

距板坯窄面的距离由50mm变为110mm时，铸坯的凝固时间不一致，裂纹表面的硫、磷含量逐渐增大，裂纹断口形貌由塑性断口变为凝固收缩断口。

From 50 mm to 110 mm away from the narrow side of slab , the contents of sulphur and phosphorous at the crack surfaces increase and the morphology changes from the plastic to shrinkage type due to different solidifying time .

本文所做的工作和主要结论如下：（1）导风叶轮低压铸造充型时间为82s，充型完成后铸件凝固时间约为248s。

The main research work and conclusions are presented as follows . 1 . The whole filling time of the impeller inducer under low-pressure casting is 82s , and the freezing time 248s when the filling process was finished . 2 .

粘度稳定剂延长了鲜胶乳的凝固时间。

The viscidity stabilizers lengthened the solidified time of the fresh latex .

我在测量人死后唾液的凝固时间。

I 'm measuring the coagulation of saliva after death .

活化血浆凝固时间对血小板输注疗效评价的研究

Test of Activated Plasma Clotting Time to Assess Efficacy of Platelet Transfusion

利用全血凝固时间测定组织因子活性的研究

Study on the Determination of Tissue Factor Activity with Whole Blood Clotting Time

根据不同AT-Ⅲ活性与相应凝固时间制作标准曲线；

The standard curve was established between AT-III activity and respective clotting time .

液态模锻的凝固时间及其方程

Solidification Time and Its Equation in Squeezing Casting

铸钢件冒口离开热节凝固时间的试验研究

A Study on Solidification Time of Steel Casting With Riser Away from Hot Spot

方法体外采用试管法测定家兔全血凝固时间；

Methods The clotting time of rabbit was tested by tube model in vitro .

抗组织因子途径抑制物单克隆抗体对血浆凝固时间的影响

Effect of monoclonal antibody against human tissue factor pathway inhibitor on plasma coagulation time