光泽度

能显著提高产品的光泽度、附着力、丰满度、耐老化性。

Considerably increase the glossiness , adhesive force , fullness and aging resistance of theproducts .

CT能显著降低聚丙烯雾度（≤15%），提高光泽度（≥130%）。

The transparent agent cold notably reduce the haze of PP ( < 15 % ), and improve the glossiness of PP ( > 13 % ) .

涂料pH值升高，油墨吸收性略有提高，但对印刷光泽度影响不大。

Higher pH value brings about higher K & N value , but print gloss is hardly influenced ;

使ABS产品外观颜色、光泽度有很大程度的提高。

Both the color and the luster of ABS products are improved .

但未经改性PP制品的光泽度、透明性等理化性能差限制了它的应用。

The development and application of unmodified PP was restricted because of its poor transparency and glossiness .

一种新的高光泽度的ISO测定方法

New ISO Test Method for High-gloss Papers

基于DOE的注射零件表面颜色和光泽度的控制

Color and Gloss Control of Surface of Molded Part Based on DOE

利用FTIR红外光谱法对氯化聚丙烯与短油度醇酸树脂共混物的相容性进行了研究，并用涂膜光泽度进行对比。

The miscibility of CPP with alkyd resin in the specified mixing ratios has been studied by FTIR spectra .

ABS具有极高的光泽度，优良的流动性以及均匀的颜色，并能提供中等至较高冲击强度的各种品级。

ABS has superior gloss consistent color base whiteness with excellent flow and offers a range of medium to high impact grades .

聚丙烯（PP）是五大通用树脂中增长速度较快的品种之一，但因其光泽度和透明性较差而限制了发展和应用。

Polypropylene has been one of the fastest growing general plastics for decades . The developments and application of PP were recently limited due to its transparency and glossiness .

光泽度检测到5个QTL，分别位于第2、5、7和12染色体上。

Five QTLs for gloss were located on chr . 2 , chr . 5 , chr . 7 and chr . 12 , respectively .

随着MgO的加入量增多，制品的表面光泽度并非一直增加，而是有一个最佳值；

With the weight fraction of MgO increasing , the surface finish of product continuously increases by no means , but MgO has a best weight fraction .

少量Al2O3则可以降低釉熔体高温粘度，抑制析晶，改善釉面白度和光泽度。

A little Al 2O 3 would decrease high temperature viscosity of glaze flux , depress its devitrification and accordingly improve the whiteness and glossiness of glaze surface .

产品具有较好的表面光泽度和透明度，并获SGS环保认证及SGS物性指标检测。

They possess fair surface polish and transparency , have SGS certificate for environment protection and pass the SGS test .

采用高温熔融法制备了适用精陶的低温无铅熔块，并应用热膨胀分析仪、SEM等方法研究了精陶釉的光泽度、热稳定性、热膨胀系数等性能。

Lead-free frit suitable for fine pottery was first prepared by the melting method . The performances of glaze , such as glossiness , thermal stability , match of thermal expansion coefficient and bond of body and glaze , etc.

本文论述了采用高速纺丝拉伸一步法（FDY法）生产细旦异形涤纶长丝的工艺特点和关键技术，并对其织物的光泽度以及弯曲、压缩，摩擦和抗起球起毛等性能进行分析评价。

The producing technology of PET filaments with fine denier and profiled cross-section made by the high speed spin-draw process ( FDY process ) is discussed .

研究了齐聚物、消光剂、光引发剂和活性稀释剂的种类及含量，对紫外光（UV）固化竹木亚光涂料的固化速度、光泽度和硬度的影响。

The article mainly researched the kinds of oligomer , flatting agent , photo initiators , monomer and the contents to the influence of ultraviolet cure speed , polish degree and rigidity of the second light UV-curing Coating for bamboo wood .

结果表明PUA基水墨具有优良的附着牢度及耐湿磨性，讨论影响水性油墨粘度和光泽度的因素。

The results show that the PUA-based ink has excellent adhesion and moisture fastness wear resistance , and discuss the impact of water-based ink viscosity and gloss factor .

铜金粉印金光泽度影响因素的正交试验结果表明，不同的表面处理试剂对印金光泽度作用不同，其中以硬脂酸及硬脂酸盐与高聚物SA复配试剂效果最佳。

The results of orthogonal experiments showed that the different surface modifiers had the different effect on gloss of the powder , besides the mixed surfactants stearic acid : SA and stearate : SA could give higher gloss value .

结果表明，加入无机填料可有效解决GMT制品露毡问题，减小了表面收缩凹斑，提高了制品表面光泽度。

The results have shown that addition of non - organic filling might effectively solve the problems of felt disclosure , decrease the surface shrinkage cave spots and improve the product smoothness .

对比各代HPU掺杂涂膜发现，随代数的增加，光泽度和硬度明显提高。

Comparing with the different generation HPUs with LPU mixed films , the gloss and hardness improve significantly .

并由ISO2813标准定义延伸，扩展其光泽度的测量范围。

And based on the gloss definition of ISO2813 the measuring range is extended .

染料浓度（owf）相同时，分散蓝E-4R对不同组织织物的光泽度影响是一致的；

The luster of polyester fabric of being dyed with disperse bule E-4R has the same change to the different weaves .

该胶固含量46%～50%，pH值5～6，残存单体≤0.1%，成膜光泽度≥90%，耐黄变等级A，Tg为23℃。

The lacquer has solid content of ( 48 ± 2 ) % , pH value of 5 - 6 and residual monomer of under 0.1 % , and the resulted film has glossiness of over 90 % , anti-yellowing of grade A and Tg of 23 ℃ .

使用涂布滑石粉能较好地解决无光泽涂布纸生产过程中为降低光泽度而大量使用微细GCC却导致印刷对比度和油墨耐摩擦性过低的问题。

Using talc in the coating formula can solve the problems of too low printing contrast and too high ink scuffing of matte paper which are caused by using vast amount of fine GCC in coating color with the intention of decreasing paper gloss .

综合考虑合金镀层组成、镀层的光泽度及镀液的稳定性，确定了电镀光亮sn-Pb合金的最佳镀液组成及工艺条件。

The optimum bath composition and technological conditions for obtaining bright Sn . Pb alloy coating were determined after comprehensive considering the composition and lustre degree of the alloy coating , and the stability of the plating bath .

最后将各代HPU与LPU按一定比例混合，对比考查涂膜性能测试发现：超支化结构的引入可明显提高涂膜的光泽度和硬度，而其抗冲击力和柔韧性则有所下降。

The results showed that the gloss and the hardness increased obviously by the mixing of the hyperbranched structure , while the flexibility and the impact resistance declined .

BOPP-D1产品的加工试验表明：双向拉伸薄膜具有光泽度好、强度高、制品的外观、鱼眼等指标均达到了用户的质量要求。

The test processing of BOPP-D1 products shows : BOPP-D1 products have good glossiness , intensity high , fish-eyes which have reached quality requirement of users .

结果表明，DEP与糖精的协同作用会使镀镍层的光泽度与整平性能得到大幅提高，但对镀液分散能力影响较复杂。

The results show that the cooperative effects of DEP and saccharin can greatly improve the brightness and leveling of the deposits , but have a complicated effect on the throwing power of the Ni electroplating bath .

采用该交联体系，可显著提高涂膜的耐水性、耐溶剂性、光泽度及硬度，DAAM的用量以占总单体质量的6.5%为好。

Adoption of this crosslinking mode could markedly improve water resistance , solvent resistance , glossiness and hardness of the film . 6.5w % DAAM out of total monomer mass was preferred .