首页 / 词典 / good

mises

  • 网络米塞斯;等效应力;屈服准则
misesmises
  1. In both simulation models , the von Mises distribution was used to characterize angle-of-arrival .

    在这两种仿真模型中,冯?米塞斯(VONMISES)分布被用来描述非均匀散射环境下的信号到达角度。

  2. The fourth part introduces the core , revelation and evaluation of economic theories of Mises and Hayek , two representatives in the Austrian school .

    第四部分主要介绍奥地利学派经典人物米塞斯和哈耶克的核心经济理论,以及两人经济理论的评价。

  3. Structural Topology Optimization Based on Level Set Method and von Mises Stress

    基于水平集方法和VONMISES应力的结构拓扑优化

  4. Method on determining Mises yield condition of residual stress for steel pressure vessel

    钢制压力容器残余应力的Mises屈服条件确定法

  5. The Application of Mises Yield Condition in Limit Analyse of Plasticity

    Mises屈服条件在固支圆板塑性极限分析中的应用

  6. Study on the Parameters of Generalized Mises Criterion at Plane-strain Condition

    平面应变状态下广义Mises准则参数特性

  7. Circular locus of Mises yield criterion and its application in sheet forming

    Mises准则的圆形屈服轨迹及其在板料成形中的应用

  8. The Optimal Approximation Parameter of Linearization of Mises Yield Condition

    Mises屈服条件线性化的最佳逼近因子

  9. On the Spreading of the Mises Circular Yield Cylinder Surface and Its Physical Significance

    关于塑性屈服Mises圆柱表面的展开及其物理意义

  10. Mises strength criterion , the bearing capacity of the anchorage system is assessed .

    Mises强度理论,对锚固结构的承载能力做出了评价,得出一些有益的结论。

  11. Simulation results could describe the state of Mises stress and equivalent strain of pure copper accurately .

    模拟结果能准确有效地描述纯铜温变形的应力应变状态。

  12. The Improvement of the Yield-conditon of the Mises Linear Following Strengthening Model

    Mises线性随动强化模型屈服条件的改进

  13. Geometric method for comparison of the Tresca , mises and two shearing stress yield criteria

    Tresca和Mises与双剪应力屈服理论的几何比较

  14. A mixed-mode fracture criterion based on maximum Mises stress on radial plane under three-dimensional stress condition

    考虑三向应力效应的最大Mises应力复合断裂判据

  15. General expression of equivalent generalized Mises transformation formula for Mohr-Coulomb yield criterion under plane strain condition

    平面应变条件下的M-C准则的等效广义Mises变换公式及其应用

  16. Conclusions The skull damping parameter influence the von Mises stress of skull greatly .

    结论颅骨线弹性材料阻尼系数对模型颅骨应力响应有显著影响。

  17. Evaluation of ultimate load of inner-edge-clamped annular plates based on Mises yield criterion

    用Mises屈服条件求内边界固支环板的极限荷载

  18. In this paper , a diagram of circular locus of Mises yield criterion is introduced .

    本文提出了一种Mises准则的圆形屈服轨迹图。

  19. The Variation of β in Mises Yield Criterion

    论Mises屈服准则中β值的变化规律

  20. Mises stress in surface contact center of coating system is not equal to zero , which is different without coating .

    与无涂层的情况不同,涂层体系表面接触中心处的Mises应力不为零;

  21. Analysis of the bearing capacity formula of spherical joints in space trusses by the von Mises theory

    用Von-Mises理论分析网架球节点承载力公式

  22. On load carrying capacities of ring plates under Mises yield condition by using the method of weighted residuals

    用加权残数法求环板在Mises屈服条件下的极限载荷

  23. The Mises stress acting on water-oil wells casing concern bottom hole pressure very nearly .

    油水井套管所受Mises应力与本井的井底压力密切相关。

  24. The resultant expression of critical pressure is similar to the well - known Mises formula of cylinder shell .

    所得到的临界压力表达式和熟知的圆柱壳Mises公式相似。

  25. Investigation of the limit load of circular plate with the method of weighted residuals under Mises yield condition ;

    而后根据极限状态的原始定义,利用有限元法求出极限载荷的精确结果。

  26. The strength evaluation for the flange was carried out by the stress categorization principle and the Mises strength theory .

    根据应力分类原则结合第三强度理论对法兰局部承载能力进行了强度评定,结果表明相关单位的经验尺寸能满足安全要求。

  27. Dental collar had the effect of reducing the peak Von Mises stress in dentin .

    增加牙本质领高度可以降低牙体内VONMISES应力峰值。

  28. The effects of the size , location of contamination particles on the hydrodynamic pressure and Mises stress field were studied .

    的污染物刺破润滑油膜,而较小的污染物在高压区对流体动压力分布与Mises应力场的影响显著,其影响不可忽略。

  29. The limit analysis of the spherical shallow shell of the rectangle base by TTE Mises yield criterion

    用Mises屈服准则对矩形底球扁壳进行极限分析

  30. A new solution of the elastic plastic problem for thick walled cylinders has been found by Mises yield condition .

    利用Mises屈服条件,求出了厚壁圆筒弹塑性问题中的一种新解。