首页 / 词典 / good

PHR

  • 网络份数;质量份;健康档案;短语;人力资源专业人员证书
PHRPHR
  1. And the suitable amount of aromatic compounds used in silicone rubber is 6 phr ( weight parts ) .

    这些化合物在硅橡胶中的最佳用量为6份(重量份数)。

  2. Therefore , the existing query auditing methods cannot be applied directly to PHR systems .

    因此,现有查询审计方法不能直接应用于个人健康记录系统中。

  3. It was suitable in the oil loading of 60 ~ 70 phr .

    综合考虑,充油量以60~70份为宜。

  4. The typical gum formulation with 5 phr of zinc oxide was used as a control .

    用含5份氧化镁的典型纯胶配方为对比配方。

  5. Once upon a time phr .

    从前,很早以前。

  6. When the content of plasticizer reached 40 phr , the soft PVC materials had good performance .

    增塑剂含量在40phr时,软质PVC体系有较好的力学性能。

  7. The optimization heat aging properties were obtained when antioxidant 2246 was used and the optimization amount was 2 phr .

    抗氧剂2246对TPE的耐热老化性能最好,其最佳用量为2.0份。

  8. EPDM / PA blend , including 30 phr PA , gained excellent water resistant property .

    尽管共混物含30份的PA,但仍具有优良的耐吸水性;

  9. When nucleating agent content was 2 phr , the apparent density was the smallest .

    当成核剂含量为1.2份时,表观密度最小。

  10. The results showed that the materials could be still formed by hot pressing when wood powder content was90 phr .

    结果表明,木粉含量高达90份时仍可热压成型,但以50份以下为优。

  11. The resistance of adhesion failure rised by adding 0.5-1.0 phr of polyphenol antioxidant .

    加入0.5~1.0份多元酚抗氧剂,可使抗失粘性增强;

  12. The PHR has demanded an official investigation and condemned the CIA 's response .

    PHR已经要求政府进行正式调查并谴责了中情局的反应。

  13. Secondly , the effect of different kinds of and different Phr . low molecular compounds on property of some damping polymer was studied .

    第二,研究不同种类、不同用量的有机小分子促进剂、防老剂对部分高分子阻尼材料性能的影响;

  14. The results indicated that the best properties of composites could be obtained when the content of bagasse was40 phr .

    实验结果表明:当甘蔗渣含量达40份时,复合材料的综合性能较好。

  15. While applied only 20 phr ENR-50 , its tensile strength was the greatest ;

    只加20phrENR-50时拉伸强度最高;

  16. FKM / MVQ blends show superior mechanical properties when DCP content is 1 phr .

    当DCP用量为1份时,共混胶的力学性能良好。

  17. The formula was : EPDM , 100 phr ;

    水封胶料基本配方确定为:EPDM,100;

  18. When the content of carbon black was 10 ~ 20 phr , the PTC intensity reached 3 orders of magnitude .

    结果表明,当炭黑为10~20质量份时,该复合体系PTC强度可达3个数量级;

  19. When the content of amine modifiers was 0.1 phr , the variational degree of relative viscosity and amino end group content decreased ;

    添加01份改性剂后,尼龙6在热加工过程中相对粘度及端氨基含量的变化程度减小;

  20. The HDPE composite materials show the behaviors of brittle tensile break when the dosage of filler is over 70 phr .

    当超细Mg(OH)2填料用量达到70份时,HDPE复合材料表现出明显的脆性拉伸断裂行为。

  21. The results indicated that when the adding amount is 1.5 phr , the material has antibacterial activity and the cost of material is not too high .

    实验结果表明:添加无机抗菌剂FS-ZN的量1.5%,即能满足抗菌需要,又不会使最终制品的成本提高很多。

  22. The suitable content of EMI-2,4 is about 1.2 % ( 4 phr per hundred of epoxy resin ) .

    2-乙基-4-甲基咪唑(EMI2,4)的适宜用量为1.2%(每100份环氧树脂使用4份)。

  23. In the case of adding 8 phr of nano-CaCO_3 , the tensile strength and flexural strength of the composites increase remarkably .

    添加8phr左右的纳米CaCO3,体系的拉伸强度和弯曲强度得到较大提高。

  24. The low loading level of ground rubber ( up to 10 phr ) didn ′ t have significant effect on the physical properties of vulcanizate ;

    添加少量胶粉(10份以下)对硫化胶物理性能无明显影响。

  25. The result of MFR showed that the compounded fire - retardant with 40 phr could meet the needs of processing craftwork .

    熔体流动速率(MFR)的测定表明当复合阻燃剂的添加量为40份时,仍能满足加工工艺的要求。

  26. Reverse Saturable Absorption in ZnTBP / CA / PhR

    有机材料ZnTBP/CA/PhR体系的反饱和吸收特性研究

  27. When the content of CIIR exceeded 50 phr , the heat-oxygen age stability of the blend would be significantly improved .

    当共混物中CIIR用量超过50份时,共混物的耐热氧老化性能明显改善。

  28. The EPDM / PA thermoplastic elastomer with PA 35 phr had good mechanical properties , resistance to solvent and thermal ageing properties .

    PA用量为35份的EPDM/PA热塑性弹性体具有良好的力学性能、耐溶剂性能和耐热老化性能;

  29. The best amount of A2 is 1 phr to 100 phr M-Type Barium Ferrites .

    偶联剂A2的最佳使用量为1phr(相对于100phrM型钡铁氧体)。

  30. When 5 phr MMT and 10 phr starch were added , MMT layers were completely exfoliated .

    当蒙脱土用量为5份、淀粉用量为10份时,蒙脱土几乎呈完全剥离状态;