16mm

Development and Application of Two-strand Split Rolling Technology for Φ 16mm Hot-rolled Ribbed Bar

Φ16mm热轧带肋钢筋两切分技术的开发与应用

Her art practice includes site-specific , spatial installations , 16mm films , digital audio and single-channel , experimental video .

艺术实践包括定位、空间装置、16毫米电影、数字音频和单声道、实验录像等。

PACKAGING : Switches delivered on continuous tape & reels of2000 pieces , 16mm width .

包装：开关连续发表磁带及2000件，16毫米宽卷轴。

Within the mid-latitude belt on the Southern Hemisphere , there may be about 14 ~ 16mm / a expanding change .

南半球中纬度带可能存在14～16mm/a量级的膨胀变化。

When the diameter of roll is comparatively large , for instance φ 16mm , the calculation value and the measured value approach to each other .

当轧辊直径比较大时（大于φ16mm），实测值与理论计算值相接近。

Preparation for ф 16mm and ф 18mm molybdenum bars

Ф16mm、Ф18mm钼棒的研制

Based on the researches of rolling and coiling process of thick strip (≥ 16mm ) in hot tandem rolling , the causes of producing waste products are found .

通过对热连轧厚规格带钢（≥16mm）轧制及卷取工艺的研究，找出了废钢产生的原因。

For this example project , the minimum cross-sectional dimension of the steel columns under seismic action should not be less than370X370 × 16 × 16mm .

对本文实例工程而言，箱型钢柱在地震作用下的最小截面尺寸不宜小于370×370×16×16mm。

The average rising rate of relative SL of the Pacific Ocean is 1 . 16mm / a if anomalous rising and falling rates are not counted .

若不计海平面异常升降值，太平洋相对海平面平均上升率为1.16mm/a。

In the Iron and Steel industry , roll guide equipment is a part in rolling product line . Pass and guide unit design of two-strands slitting rolling for Φ 16mm ribbed bar

在钢铁行业中，滚动导卫装置为轧制生产线上一关键装置。Φ16mm带肋钢筋二线切分轧制孔型与导卫设计

The characteristics of technology scheme , pass design , guide unit and loop of two-strands slitting rolling for Φ 16mm hot rolled ribbed bar were introduced . The output per shift was increased from 600t to 800 t.

介绍了Φ16mm热轧带肋钢筋二线切分轧制的工艺方案、孔型设计、导卫和活套装置的特点，Φ16mm钢筋二线切分轧制后，班产量由600t提高到800t。

Result MRI showed pituitary obvious homogeneous enhanced , upward symmetrically apophysis with shape like a bell , the height of pituitary gland was 9.4 ~ 16mm , the width of the stalk was 1.4 ~ 1.7 mm .

结果10例甲减患者表现为垂体上缘呈对称性隆起，形态呈钟形，垂体明显均匀强化，垂体高9.4~16.0mm，垂体柄横径为1.4~1.7mm。