锡青铜

在锌铝合金中加入适量稀土可以明显细化晶粒，根据hall-petch关系式，合金性能也将得到提高，从而扩大合金的应用范围，成为黄铜、锡青铜、铝青铜和铅基巴氏合金的良好替代材料。

Consequently , according to hall - petch formula , the properties of the alloys are improved so that the application range of the alloys will be extended and can be used as a substituent of brass , bronze and leaded babbitts in some cases .

不同润滑状态下炭纤维对锡青铜摩擦磨损性能的影响

On the Friction and Wear Behaviors of Short Carbon Fiber Reinforced Tin - Bronze Composites

Al2O3-40%TiO2涂层/锡青铜的摩擦磨损性能研究

Study on Friction and Wear Properties of Al_2O_3-40 % TiO_2 / Tin Bronze System

用端面摩擦磨损试验机考察了锡青铜镶嵌聚四氟乙烯（PTFE）自润滑轴承材料的摩擦学特性。

The tribological properties of PTFE-embedded tin bronze bearing material were studied using a pin-on-disk friction and wear tester .

通过计算和试验，确定了填充PTFE材料密封填料环的径向和轴向间隙，并分别采用尼龙、锡青铜和铸铁3种材料设计制造出了阻流环和节流环。

Abstract The Packing seal rings filled PTFE ( teflon ) are designed , the suitable radial and axial clearances are determined through calculation and test .

ZA-27合金替代锡青铜制造纺锭锭底的研究

The Study of Spindle Base Made of ZA-27 Alloy Instead of Tin Bronze Alloy

采用等离子弧喷焊技术，在Q235钢表面制成熔敷低磷锡青铜和镍基合金混合粉末的喷焊层。

By using plasma arc method a copper base alloy surfacing weld was formed on steel Q235 , with Sn P bronze powder with nickel base alloy powder .

研究了新型铝基滑动轴承合金（TZS88）的成分和性能，用以取代ZCuSn6Zn6Pb3锡青铜制造整体材质的轴瓦、轴套等机械零件。

The composition and performance of a new aluminum base sliding bearing alloy ( code : TZS88 ), which was used to substitute tin bronze ( ZCuSn6Zn6Pb3 ) to make axle bushing and sleeve , were studied .

结果表明：在FD-7主轴润滑油的条件下，Al2O3-40%TiO2涂层与锡青铜之间发生了明显的涂抹和擦伤现象，涂层摩擦磨损性能优异。

The results indicate that the obvious abrasion and scratch is found between plasma-sprayed Al2O3-40 % TiO2 coating and tin bronze , and plasma-sprayed Al2O3-40 % TiO2 coating has good wear resistance under FD-7 grease frictional condition .

基于连续挤压的锡青铜侧向挤压研究

Study on Lateral Compression Pressing of Tin Bronze for Continuous Extrusion

消除锡青铜中锡汗缺陷的氧化去氢法初探

Oxidation Methods of Eliminating the Defect of Stannic Sweat in Bronze

浇铸型锡青铜镶嵌石墨轴承及其应用

The Foundry Tin Bronze - Inlaid Graphite Bearing and its Application

锡青铜镶嵌固体润滑剂轴承的摩擦学特性

The Tribological Characteristics of Solid Lubricant Embedded Tin Bronze Bearings

应用高温快速熔炼工艺生产耐压锡青铜铸件

Pressure Tight Tin Bronze Casting Produced by High Temperature Rapid Melting Technology

低锡青铜镀层电解退除工艺

Electrolytic Removal Technology of Low-leveled Tin Bronze Coa tin gs

烧结锡青铜过滤元件防氧化处理前后性能测试对比

Performance Test after Prevent Oxidation Treatment for Sintered Tin-bronze Filter

微细锡青铜粉填充聚四氟乙烯的性能及应用

Properties and application of PTFE filled with fine bronze powder

冶金因素对锡青铜机械性能的影响

The Effects of Metallurgical Factors on the Mechanical Properties of Tin Bronze

钼蓝萃取光度法测定乙醇中磷锡青铜中痕量磷的测定&钼蓝萃取光度法

Determination of phosphorus content in alcoholic by molybdenum blue extraction photometric method

提高锡青铜的冶金质量

The Views on Improving the Metallurgy Quality of Tin Bronze

电镀低锡青铜回火胎圈钢丝生产工艺研究

Production Technology Research of Electroplating Low-Sn-bronze for Tempered Bead Wire

游动联系人：锡青铜，镀银。

MOVABLE CONTACT : Tin bronze , silver plated .

高锡青铜的挤压成形研究

Study of the Extrusion Forming of High Tin Bronze

新型锡青铜合金粉及其性能研究

Study on a New Type of Prealloyed Tin Bronze Powder and Its Properties

最后对光亮低锡青铜的适用范围作了正确的评估。

Finally , the limitation of low tin bronze plating applications is evaluated .

利用粉末冶金工艺设计和制备了新型润滑材料&锡青铜梯度自润滑复合材料；

Tin-bronze gradient self-lubricating composites were designed and prepared by powder metallurgy process .

常温锡青铜镶嵌型固体润滑剂材料的研究

Study on the Room-temperature Solid Lubricants Embedded Tin-bronze Materials

锡青铜铸件离心铸造的缺陷分析及预防措施

Analysis and Countermeasure of Defects of Tin Bronze Casting in Centrifugal Casting Process

本法已用于测定锡青铜、磷青铜和铝青铜中的铜。

This method has been applied satisfactorily to determine copper in copper alloys .

镶嵌用固体润滑剂对锡青铜轴承摩擦学性能影响的研究

The Effect of embedded Solid Lubricant on the Tribological Properties of Tin-Bronze Bearings