邵氏硬度

  • 网络SHORE;Shore Hardness;hardness;JISA
邵氏硬度邵氏硬度
  1. 采用LCR测试仪、邵氏硬度计和电容法电致伸缩特性测试装置研究了纳米钛酸钡掺杂对PUE的影响。

    LCR test instrument , Shore hardness test instrument and capacitive electrostrictive properties test device are used to test the effect of doped PUE .

  2. 方法:37℃人工唾液浸泡1年及2年后,测定拉伸强度、邵氏硬度及与PMMA的粘接强度。

    Methods : The tensile strength , Shore A hardness and adhesive strength of the three resilient denture liner materials to PMMA were measured after being immersed in artificial saliva for one and two years .

  3. 用Visualc++软件编程,采用单文档/多视图结构以及多线程的编程方式,实现了对仿真材料邵氏硬度的动态检测。

    Realize the dynamic test on bio-anthropomorphic materials , by using of Visual C + + and its technique of Single document / Multi views structure and Multi-thread programming .

  4. 以容栅传感器为主实现邵氏硬度计弹簧测头的位移检测,采用串口通信方式实现了数据的传输和采集,用Matlab和串口精灵程序实现数据的分析和计算。

    Test the displacement of head-pin of Shore hardness tester by using the capacitive gate transducer , implement data collection and transfers by means of the serial communication , and realize the data analysis and process by applications of Matlab and serial communication genius program .

  5. 结果显示:Parylene涂敷后两种硅橡胶的撕裂强度、拉伸强度、扯断伸长率及邵氏硬度高于涂敷前,但数值仍在理想值范围内。

    Results show that the tear strength , tensile strength , elongation and Shore hardness of silicone elastomer increase in ideal value range after Parylene coating .

  6. 国内外邵氏硬度计的分类和校准方法探讨

    Classification and calibration method of domestic and abroad shore hardness testers

  7. 邵氏硬度计示值误差测量结果不确定度评定

    Evaluation of the Measurement Uncertainty of the Indication Error of the Shore Hardness Tester

  8. 邵氏硬度试验误差

    Shore Durometers Test Error

  9. 邵氏硬度、拉伸强度和伸长率是考核橡胶材质力学性能的重要指标。

    Shall hardness , tensile strength and its elongation rate are principal data to indicate the quality of rubber materials .

  10. 本文详细讨论了影响Co~(60)辐照交联聚氯乙烯邵氏硬度、拉伸强度及医用化学性能的因素。

    Factors affecting PVC properties , such as Shore hardness , tensile strength and medical chemical property , were discussed in detail in this article .

  11. 研究还表明了添加脱水剂后,密封胶的断裂伸长率、邵氏硬度、剪切强度等性能受到的影响很小。

    The research also indicated that the performances of PU sealant such as ultimate elongation , Shore-A hardness and shear strength , etc were affected little after adding dehydrating agent .

  12. 发现随CaCO3填充量增加至40份,体系拉伸强度下降,拉断伸长率变化不大,冲击回弹性下降,邵氏硬度上升。

    The results showed that with the content of CaCO_3 increasing to 40 phr , the tensile strength and impact resilience decreased , the elongation at break varied little and the hardness increased .

  13. 结果表明:使用表面处理轻质CaCO3作填料的聚氨酯密封剂与使用未处理轻质CaCO3作填料制备的聚氨酯密封剂相比,其邵氏硬度降低,伸长率提高。

    Comparing to the polyurethane sealant which uses untreated light CaCO_3 as filler , the results showed that polyurethane sealant which uses surface-treated light CaCO_3 as filler has lower Shore A hardenss and higher elongation .

  14. 实验结果表明:随粉煤灰用量的增加,复合材料的冲击强度、拉伸强度、断裂伸长率及熔体指数下降,弯曲强度、邵氏硬度增大;

    The results showed that the impact strength , tensile strength , elongation at break and MFR of the composites decreased while flexural strength and hardness ( shore D ) increased with increasing the fly ash content ;

  15. POE8150/CaCO3的拉伸强度、邵氏硬度比POE8003/CaCO3小,前者的拉断伸长率、冲击回弹性大于后者。

    The tensile strength and Shore A hardness of POE 8150 / CaCO_3 system were lower than that of POE 8003 / CaCO_3 , and the elongation at break and impact resilience of the former were larger than that of the latter .

  16. 与未添加填料的橡胶相比,复合材料的拉伸强度,撕裂强度,300%定伸强度,邵氏硬度分别提高了77.14%,118.18%,242.86%,79.2%;

    By using modified palygorskite , the tensile strength , tear strength , 300 % modulus and shall hardness of the composites increased by 77.14 % , 118.18 % , 242.86 % and 79.2 % respectively comparing with the rubber having not adding any stuffing .

  17. 方法测定由HR1型柔性牙龈赝复材料制备的试样在浸入人工唾液1年及2年后试样的扯断强度和邵氏A硬度的变形情况。

    Methods The tensile strength and Shore A hardness of samples made from HR 1 flexible gingival veneer material after being immersed in artificial saliva of 37 ℃ for 1 year and 2 years were tested .

  18. 力学性能测试表明:复合材料拉伸强度、扯断伸长率、300%定伸强度、邵氏A硬度、撕裂强度得到明显的改善。

    The mechanical tests show the performances of nanocomposites , such as tensile strength , elongation at break , stress at 300 % elongation , tear strength and hardness ( Shore A ) are improved prominently .

  19. 在香港建构中国:邵氏电影的大中华视野邵氏硬度计示值误差测量结果不确定度评定

    The Shaw Brothers Pan-Chinese Cinema ; Evaluation of the Measurement Uncertainty of the Indication Error of the Shore Hardness Tester