硬件参数

  • 网络hardware parameter
硬件参数硬件参数
  1. en前缀显示了您的驱动器参数,而ent前缀则显示了您的硬件参数。

    The en prefix displays your driver parameters , while the ent prefix displays your hardware parameters .

  2. 根据精密装配系统所使用的导轨与CCD相机的硬件参数以及微小型零件的精密装配技术路线,分析了导致零件装配误差的原因。

    According to the hardware parameters of the guide-ways and CCD cameras as well as the strategy of precision assembly , the reasons for assembly errors were analyzed .

  3. 搭建了三电平系统的实验平台,对系统的硬件参数进行了确定,包括直流侧中点电容的计算,IGBT参数的选取以及钳位二极管的选取等。

    The parameters of hardware have been determined , including DC side capacitors and parameters of IGBT and clamping diodes .

  4. 文章介绍了一个低成本、高性价比的车辆检测器系统的解决方案,即采用PLC作为处理器的车辆检测器系统,并且分析了系统硬件参数设置和软件设计。

    This paper introduces the application of the PLC on the Vehicle Detector System which is a low price and a high quality solution , and analyzes its setting of hardware parameters and software design .

  5. 不同的MCU,其硬件参数、硬件驱动程序和开发工具各不相同,要实现平台的通用性,图形化嵌入式开发平台必须具有可定制功能。

    Different kinds of MCUs have different hardware parameters , drivers and development tools . To realize the universality of different platforms , we must ensure the graphical embedded development platform can be customized .

  6. lsattr(此前使用来查看硬件参数)是您将经常用于显示您的接口的统计数据的另一个命令。

    Lsattr ( used earlier to view the hardware parameters ) is another command you will be using frequently to display statistics on your interfaces .

  7. 图像采集卡硬件参数基于熵的自动优化

    Automatic optimization of image board parameters based on entropy

  8. 依据系统的功能需求,正确地设置了各硬件参数。

    Based on the functional requirements to NC system , parameters of all the hardware modules are configured .

  9. 为降低计算复杂度和系统响应时间,提出了图像采集卡硬件参数自动优化的工程实现算法。

    In order to simplify computation and reduce system response time , an algorithm has been proposed for automatic optimization of image board parameters .

  10. 实验结果表明在单帧时间延迟的条件下,此种方法可以完成对图像采集卡硬件参数的自适应优化。

    Experimental results indicate that under the condition of single-frame time delay , this algorithm can be applied for adaptive optimization of image board parameters .

  11. 由于无线设备的硬件参数和硬件驱动程序都各不相同,所以本文利用通信协议来实现平台的通用性。

    Different kinds of devices have different hardware and software . To realize the universality of different platforms , so the management system takes the protocol .

  12. 实验的结果表明所设计的变频控制系统是正确的,控制方法是可行的,为该抽油机控制系统的硬件参数设计提供了良好的理论依据。

    The simulation result indicates that the model establishment is correct , the control method is feasible , these have offered good theoretical basis for this generator control systematic hardware parameter designs .

  13. 内核引导完成的主要功能是从磁盘上把内核装载至内存,读取系统硬件参数,设置全局描述符表、中断描述符表和页目录表,利用长跳转指令,从实模式切入保护模式。

    Booting module gets information of the computer and configures the global descriptor table , interrupt descriptor table and page directory , after this , it use long jump instruction to go into protected mode .

  14. 也就是将系统可调的硬件参数作为参变量考虑到控制系统的设计中去,基于变分法得到同时能使系统性能指标最优的系统硬件参数与最优的控制律。

    The method considers the adjustable hardware parameter as a variable in the controller design . Based on the calculus of variation , we can obtain the optimal control law and the optimal hardware parameter at the same time based on the calculus of variation .

  15. 人体目标跟踪系统在实际环境中运行时,往往受到环境噪声和硬件参数误差的影响,导致实际跟踪结果与仿真结果误差较大,因此需要校准算法进行调节。

    When the human target tracking system works in the real environment , it is affected by the environmental noise and hardware parameters ' error . It leads to the increase of tracking error in comparison with the simulation situation . So , the calibration algorithm is needed .

  16. 所谓控制系统的一体化设计方法,就是将系统控制律的设计与系统的硬件参数(例如摆杆的长度、滑快的初始位置等)的设计结合在一起的设计方法。

    The " integral " design is a method that we use to design the control law of the system and the hardware parameters ( such as the length of the swing stem , initial setting of a slide block etc. ) of the system model at the same time .

  17. 详细论证了监测系统振动信号、车轮轴位信号和车号信息等的信息采集方案,给出了用于监测系统的各硬件系统参数指标。

    The information acquisition schemes for vibration signals , wheel axle signals and vehicle numbers were given in detail .

  18. 三维LDV/APV系统测量大尺度雾场的硬件布局参数及应用

    The Hardware Lay-out Parameters to Measure the Large Scale Spray Field by the 3D LDV / APV System and Its Application

  19. 同时介绍了配套的可视化报文设计、硬件接口参数配置设计和报文调试工具。

    This article also introduces belongings such tools as visual message designer , hardware interface configuration designer and message debug tool .

  20. 模拟信号调理部分加入限幅滤波电路,解决传感器信号强度变化大、需要调整硬件电路参数的问题。

    An amplitude-limited filter was designed in the analog cir - cuit , which eliminates the need of adjusting hardware circuit parameters for large amplitude variation of the sensor signal .

  21. 首先针对系统的光源,烟气预处理装置,气体分析室等部件做了详细介绍,对仪器气路结构做了改进,硬件各参数达到了紫外烟气分析仪的使用技术指标。

    Firstly the system light source , fume pretreatment device , gas analysis chamber and other components are introduced in detail , improve the instrument structure , meet the technical index of ultraviolet gas analyzer .

  22. 通过大量的实验,对不同软件、硬件和参数设置下数据库系统的能耗有效性进行了测试和分析,为设计能耗有效的算法奠定了基础。(2)提出了一种能耗有效的查询优化方法。

    We conduct extensive experiments to test and analyze the energy efficiency of database systems with different configures , and summarize the results , which forms the foundation for designing energy-efficient database algorithms . ( 2 ) We propose a method for energy-efficient query optimization .

  23. 完成硬件选择及参数的确定,设计控制柜整体布局并完成PLC、仪表、开关量的接线。

    The hardware selection and parameter identification , design the overall layout of the control cabinet and complete PLC , meters , switch wiring .

  24. 通过分析TIG熔敷堆焊视觉传感器系统的传感环境,选择了CCD熔池图像视觉传感系统的组成及各硬件的位置参数,并对熔池图像视觉传感系统进行了定标。

    Through analyzing the sensor environment , the composing of CCD welding pool vision sensor and hardware position parameters is chosen . The scale of CCD welding pool vision sensor is ensured .

  25. 阐述了OPC技术术语,网络数据通讯的硬件连接、参数设置以及OPC客户机VB应用程序的编程等技术要点。

    From OPC concept to the hardware connection of network data transfer , setting of parameters and the programming of OPC client program using VB , all technical skills were described on this paper .

  26. 本文介绍SIEMENS公司的PROFIBUS-DP总线在广钢连轧厂自动化控制系统中的应用,并对其网络的硬件构成和参数的配置做了说明。

    This paper introduces the application of Siemens ProfiBus-DP in the automation control system of The Continuous Rolling Mill Plant , and explains its hardware structure and parameter configuration in the network .

  27. 本文是基于VISUALBASIC.Net开发了CDW-60综采工作面顶板安全在线监测系统软件部分,同时对系统硬件的技术参数和功能简要说明,并介绍了系统总体结构设计。

    This disquisition is based on Visual Basic . Net has developed CDW-60 fully mechanized coal face roof on-line monitoring system security software , at the same time , the technical parameters and functions of hardware systems is brief showed , and the systems architecture design is introduced .

  28. 本文介绍了电力参数检测装置的硬件结构以及参数的计算。

    Hardware frame and calculating all parameters are mainly discussed in the article .

  29. 本文分析了机器视觉系统的组成,研究了各个硬件的性能参数和选择方法。

    The performance parameters of the machine vision hardware are analyzed . parameters alternatively .

  30. 设计了红外视觉测量的总体方案,根据实际测量条件确定了方案中各硬件的型号参数。

    An overall scheme for the infrared vision measurement is presented , and the hardware parameters in the scheme are provides .