模拟电路

所提出的检测方法用模拟电路加以实现，可对谐波电流、无功电流以及负序电流进行分别检测或综合检测。

The realized methode is the artificial circuit . It can detect respectively or synthetically the harmonic current , reactive current and negative-sequence current .

Fuzzy数学在分层模拟电路故障定位中的应用

Application of Fuzzy Mathematics in the Fault Locating of Decomposed Analogue Circuits

神经元PID自适应控制方法的模拟电路实现

Realization of Analog Circuit Based on Neuron PID Adaptive Control Approach

采用BP网络建立模拟电路故障诊断交流字典方法

The Establishment of White Noise Analog AC Faulty Dictionary Using BP Network

微波单片模拟电路CAD软件

Microwave Monolithic Analog Circuits CAD Software

针对模拟电路的SET效应进行了晶体管级电路仿真，并建立了基础的器件仿真基础及验证方法。

The circuit simulations in the thesis focus on the analog circuit SET effects , and the preliminary device simulation verified framework and methods are performed .

基于Lyapunov指数的非线性模拟电路故障诊断方法

A Fault Diagnosis Approach for Nonlinear Analog Circuits Based on Lyapunov Exponents

流水线ADC包含两部分，模拟电路与数字电路。

Pipeline ADC consists of two part , analog circuits and digital ones .

部分耗尽型SOICMOS模拟电路设计研究

Research on PD SOI CMOS Analog Circuit Design

基于PSPICE进行模拟电路故障建模的方法

A Technology Based on Pspice for Fault Modeling of Analog Circuit

一个适用于模拟电路的深亚微米SOIMOSFET器件模型

An SOI MOSFET Model for Analog Circuit Design

改型的Hopfield神经网络计算系统模拟电路的硬件实现分析。

The hardware of Hopfield neural network computing system simulation circuit retrofitted realizes analyzing .

基于Volterra频域核的非线性模拟电路故障诊断

Nonlinear analog circuit diagnosis based on Volterra frequency kernels

在PCB设计上，将模拟电路与数字电路分开，以提高可靠性。

In PCB , anolog circuits are divided from digital circuits , which improve the stability of the system .

SOC的发展要求模数转换器、其它模拟电路与DSP集成在一个芯片上。

The development of SOC requires A / D converter , other analog circuits and DSP to be integrated in a chip .

文中就BP神经网络的学习算法进行了分析，使用PSPICE软件对电路进行仿真，在此基础上建立了模拟电路的BP神经网络故障字典库。

The algorithm of BP neural network is analyzed and the analog circuit is simulated by using PSPICE software in this paper .

综合故障注入器采用ARM处理器作为核心控制器；基于数模混合电路，分别通过后驱动技术和电压求和技术实现对数字电路节点和模拟电路节点的故障注入；

The fault injector was based on ARM processor , and injected faults to digital and analog electronic nodes by back-driving and voltage summing technique respectively .

在现有CMOS工艺条件下单靠模拟电路设计，ADC的速度和精度几乎已到极限。

The speed and resolutions of ADC almost have gone to utmost in the CMOS process if only rely on analog circuits design .

本文在现有文献理论研究的基础上实现了采用BP算法前向多层神经网络对直流测试下模拟电路硬故障的诊断方法。

In the paper , based on the existing literature research foundation an analog circuit catastrophic fault location approach by using feedforward networks with back & propagation learning is realized .

介绍了部分耗尽型SOIMOS器件浮体状态下的Kink效应及对模拟电路的影响。

The Kink effect of the partial-depleted SOI MOSFET and the influence on SOI analog circuits design are introduced .

在传统的模拟电路实验中，很少用到示波器的X-Y模式。

In traditional , the students hardly use the X-Y model in doing the analog electronic circuit experiment .

研究分析了TFT-LCD的显示原理，根据大屏幕液晶显示及工艺的特点，进行了SourceDriver的系统设计以及数字电路和模拟电路的功能划分。

The principle of TFT-LCD is analyzed . Based on the large panel LCD display and the target technology , the system design of Source Driver and the functionality partition are described .

随着片上系统（SOC）的迅速发展，越来越多的数字电路、模拟电路和接口电路被集成到一个芯片上。

With the rapid development of System on Chip ( SOC ), A growing number of digital circuits , analog and interface circuits are integrated onto one chip .

基于Hammerstein模型的模拟电路结构级行为建模技术预制混凝土构件模板技术规程

Methodology of the Structural Behavioral Modeling for Analog Circuits Based on Hammerstein Method Technical specification for prefabricated concrete products

本文针对线性模拟电路，提出了一种基于系统状态变量的BIST方法。

For the linear analog circuits , a BIST method based on the system ′ s state variables is presented .

尤其是在亚微米级、深亚微米级和纳米级的CMOS工艺下，可以采用大规模的数字校准技术，使得模拟电路的性能要求和设计难度大大降低。

In submicron , deep submicron and nanometer CMOS technology , the design complexity is moved to digital domain whenever possible , thus relaxing performance requirements and complexity of analog circuitry .

提出了一种N阶导抗元件的OTA-C模拟电路综合法，分别对接地元件和浮地元件两种情况进行讨论。

A kind of OTA-C dummy load synthesis method with N stairs immittance element is proposed . Two circuits with ground element and floating element are discussed separately .

文章在预置相位PWM方法的基础上提出了一种新型实用的PWM控制器的数字化方法，该控制器可由简单的数字模拟电路实现，也可以由微机来控制。

A digital method for a new-type of PWM controller is discussed based on the presetting phase PWM method The controller can be constructed with a simple digital-analog circuit and it can also be controlled by computer .

在现代混合集成电路中极大部分的采用了数字电路，只有极小部分采用了模拟电路，因此，数字CMOS工艺成为工艺设计的必然。

As most of the modern hybrid integrated circuits use the digital circuits , and only few use the analog circuit , so the digital CMOS process is bound to be used for the design process .

提出了判断模拟电路k故障块相容性的一种快速方法和一种基于虚拟故障概念的电路分块诊断方法，它适用于大规模模拟电路故障定位。

A quick method to solve the problem of block independent of multiple faults of large analog circuits is proposed . Based on the concept of virtual faults , a decomposition approach is also proposed for fault location in large analog circuits .