多孔陶瓷

多孔陶瓷为载体的C3馏分选择加氢催化剂的研究

Study on C_ 3 cut selective hydrogenation catalyst supported on porous ceramics

注浆成型SiC多孔陶瓷的工艺和性能研究

Fabrication and Properties of SiC Porous Ceramics by Slip Casting Process

基于自适应PID控制的多孔陶瓷透气度测试系统的设计

Self-adaption PID control in the Ventilation Degree Inspection System of Multihole Ceramics

热处理温度对金属Al增韧氧化铝多孔陶瓷支撑体断裂韧性的影响

Effects of heating temperature on the fracture toughness of macroporous alumina supports added Al powder

流延成型法制备SiC多孔陶瓷工艺的研究

Study on the fabrication of porous SiC ceramics with tape casting

利用不同造孔剂制备Al2O3多孔陶瓷

Fabrication of Porous Al2O3 Ceramic Using Different Pore-Making Agent

含先驱体聚合物浆料浇注成型制备SiC多孔陶瓷

Fabrication of Porous SiC Ceramics by Precursor Polymer-contained Slurry Slip Casting Method

ZnO多孔陶瓷气敏电导的渗流模型

The percolation model of porous ZnO ceramics gas sensors

高温过滤支撑体用SiC基多孔陶瓷的制备与表征

Fabrication and Characterization of SiC-Based Porous Ceramic Used for High Temperature Filtration Supporter

三维网络SiC多孔陶瓷增强铝基复合材料的制备

The Preparation of 3D-Reticulation SiC Reinforced Al Matrix Composite

α-Al2O3多孔陶瓷无机膜支撑体及涂层研究

Study on the Support and Coating of Porous Al_2O_3 Ceramic Inorganic Membrane

SiC多孔陶瓷的气孔率和强度

Porosity Ratio and Strength of SiC Porous Ceramics

烧成温度对SiC多孔陶瓷的影响

Influence of Sintering Temperature on Porous SiC Ceramics

硅锭线切割回收料制备SiC多孔陶瓷的研究

Study on SiC Porous Ceramics with the preparation of retrieve cut metal silico-spindle wire

工艺因素对α-Al2O3多孔陶瓷载体性能的影响

Effect of Processing Parameter on Property of α - Al_2O_3 Porous Ceramic Matrix

SiC多孔陶瓷预成形坯的制备

The preparation of SiC Porous Ceramic preforms

多孔陶瓷对金属离子的吸附性能受溶液pH值、初始浓度等因素影响。

The metal ion adsorption performance of porous ceramic was influenced by pH value , the initial concentration and other factors .

用Sol-Gel法制备氧化铝多孔陶瓷的研究

Study on porous alumina ceramics prepared by sol-gel

TiO2光触媒担载多孔陶瓷室内空气净化元件的研究

Study on TiO2 Photocatalyst Carrying Porous Ceramics for Gas Purification Indoor

电致发热多孔陶瓷是以SiC为材质，利用反应烧结法制备而得的一种多孔陶瓷材料。

The electron-heating porous ceramic was prepared by reactive sintering which main raw is SiC and petrol coke .

Y2O3对反应烧结制备Si3N4多孔陶瓷的影响

The Effect of Y_2O_3 on the Properties of Porous Si_3N_4 Ceramic Prepared by Reactive Sintering

AlN低温烧结助剂的研究现状锆英石多孔陶瓷烧结助剂的研究

Development of the Low-temperature Sintered Aids for AlN Ceramics

SiO2基复合多孔陶瓷载体的制备

Preparation of sio_2 based composite porous ceramic support

ZrO2－TiO2多孔陶瓷膜的制备研究

On the Preparation of ZrO 2 TiO 2 Porous Ceramic Membranes

SEM分析结果表明：碳化硅-堇青石多孔陶瓷中碳化硅颗粒排列较紧密，断面呈网格状结构；

SEM analysis results revealed that the SiC grains in porous SiC-cordierite ceramics distributed more closely and the section surface appeared as reticular structure .

ZrO2对堇青石多孔陶瓷吸水率和显气孔率的影响

Effects of Water Absorption and Porosity of ZrO_2 on Cordierite Porous Ceramic

骨水泥水化后生成的羟基磷灰石（HAP）与β-TCP构成了双相多孔陶瓷。

HAP from bone cement hydration and β - TCP constructed bi-phase porous ceramic .

以α-Al2O3粉末为骨料，以聚乙烯醇（PVA）作粘接剂和成孔剂，采用塑性挤压成型技术和固态粒子烧结法制备氧化铝多孔陶瓷支撑体。

A porous ceramic support comprising alumina and PVA ( polyvinyl alcohol ) was prepared by extrusion and solid sintering .

500℃处理后得到了结晶程度较低的HA涂层，这种涂层有利于提高多孔陶瓷的表面生物活性。

The HA coating treated at 500 ℃ shows a low degree of crystallinity , which would improve the surface bioactivity of the porous ceramics .

应用XRD、SEM与BET测比表面等手段对蜂窝形多孔陶瓷钯催化剂及其失活状态进行了测试。

The palladium catalysts supported by honeycomb porcelain and its deactivation state have been studied by means of XRD , SEM and BET surface area measurement .