铅酸电池

  • 网络Lead Acid Battery;Lead-acid battery;VRLA;SLA
铅酸电池铅酸电池
  1. 以触变性有机硅胶为原料,配成1.325g/cm3的触变性硅凝胶电解液,注入普通的AGM铅酸电池中制得不同型号的胶体蓄电池。

    A colloidal storage battery was prepared by filling a thixotropic organic silica gel electrolyte into AGM type VRLA battery .

  2. 脉冲化成工艺在阀控铅酸电池生产上的应用

    Application of pulse formation in the production of VRLA batteries

  3. UPS用密封铅酸电池开发

    Development of Sealed Lead Acid Battery Used in UPS

  4. HEV用卷式铅酸电池的性能研究

    Study on the performance of spiral-wound lead acid battery for HEV

  5. 锂离子电池软包装用CPP薄膜热封特性的研究封闭式可充电铅酸电池

    Study of Heat-seal Properties on CPP Film for Flexible Packaging of Lithium-ion Battery

  6. 密封铅酸电池中K2SO4的作用

    Action of K_2SO_4 in Sealed Lead Acid Battery

  7. 铅酸电池电解液添加剂GAT研究

    Study on electrolyte additive gat of lead acid battery

  8. 铅酸电池的荷电状态(SOC)的测量和估计,对电动汽车的电池管理系统极为重要。

    It was very importance for the battery management system in electric vehicles to measure and estimate the state of charge ( SOC ) of lead-acid batteries .

  9. 电解液添加剂GAT对铅酸电池自放电性能的影响

    The influences of electrolyte additive GAT on self - discharging characteristic of lead-acid battery

  10. 研究结果表明:卷式铅酸电池具有良好的充放电性能,适用于混合电动汽车(HEV)。

    The research results showed that spiral - wound lead acid battery had fine charge - discharge performance , it was suitable for HEV .

  11. 镍金属电池,特别是MHNi电池,比能量和比功率较高,实现了商品化,目前已经作为铅酸电池的可替代动力电池。

    Nickel metal batteries , especially Ni-MH battery , which have higher specific energy and specific power , have been commercialized and have substituted for lead-acid battery as the power of EVs .

  12. 电动助动车用12V/14Ah管式密封铅酸电池的研究电力机车动车用超导变压器

    Study on the Oval Tubular Sealed Lead-acid Battery Used in Electric Bicycle Super conductive transformers for electrical traction units

  13. 通过粒度分布仪测量、BET孔隙度及比表面积分析、微电极线性扫描及成品电池实验,研究了不同粒径的铅粉对活性物质和阀控铅酸电池性能的影响。

    The influence of particle size distribution of lead powder on the performance of VRLA battery was studied by surface area and porosity measurement , linear potential sweep of powder microelectrode , and finished battery charging and discharging .

  14. PbCO3作为铅酸电池正极铅膏材料

    PbCO_3 as positive paste material of lead acid battery

  15. 采用充放电循环,恒电位极化后续线性电位扫描和循环伏安方法研究了密封铅酸电池中K2SO4的作用。

    The action of K2SO4 in the electrolyte of sealed lead acid battery was studied with charge-discharge cycle , constant potential polarization followed by potential linear sweep and cyclic voltammetry methods .

  16. 通过稳态极化法研究共晶型电解液添加剂GAT对铅酸电池负极阳极氧化过程的影响,并探讨添加剂GAT对电池性能影响的可能作用机理。

    The influences of cocrystallizing type electrolyte additive GAT on the cathode and anode oxidation processes of lead acid battery are investigated by steady state polarization method .

  17. 结果表明:PbCaSnCe合金的耐腐蚀性能优于PbCaSn合金,其阳极腐蚀膜主要由导电性良好的PbO2组成,说明PbCaSnCe合金可以改善铅酸电池的深循环性能。

    The results showed that Pb-Ca-Sn-Ce alloy had better corrosion resistance behavior than that of Pb-Ca-Sn alloy , its anodic corrosion film was mainly composed of PbO_2 , which had better conductivity property and showed the Pb-Ca-Sn-Ce alloy could enhance the deep cycle property of lead acid battery .

  18. 由于UC3906内部的基准电压能够随密封铅酸电池的温度特性而改变,所以在很宽的温度范围内都能够保持最佳充电状态。

    Optimum charging conditions are maintained over an extended temperature range with an internal voltage reference changing with the temperature .

  19. 介绍了超细玻璃纤维(AGM)隔板性能对密封铅酸电池性能的影响,包括基重和厚度的均匀性、回弹性和压缩率、孔率和吸酸量、孔径、电阻、杂质等。

    Effects of the specificity of AGM separators on the performance of sealed lead-acid batteries were introduced , including the uniformity of basis weight and thickness , elasticity and compressibility , porosity and absorption , pore-size , electrical resistance , impurity , etc.

  20. 本文在研究了铅酸电池的充电常识后,描述了一种基于UC3906的充电管理电路,此电路不但能够进行高效率高精度的充电,还能完成备用电源的投入与切断。

    After studied the basic knowledge of Lead-Acid Battery charging course , this paper describes a Lead-Acid battery charger circuit , which not only achieves the high charging effective and accuracy , but also completes the shifting between the power supply and the backup battery .

  21. 电动汽车用铅酸电池放电特性的研究

    A Study of lead-acid Battery Discharging Characteristics for Electrical Motor Vehicle

  22. 铅酸电池的不一致性与均衡充电的研究

    Research on the Inequality of Lead Acid Batteries and Equalizing Charge

  23. 铅酸电池泡沫铅板栅材料的研究进展

    Research progress in lead foam grid materials for lead acid batteries

  24. 深循环用铅酸电池充电模式的探索

    The charge algorithms of the deep - cycle lead acid battery

  25. 铅酸电池干荷电极板水洗工艺改进

    Improvement of Washing Process of Dry-Charged Plate in Lead-Acid Storage Battery

  26. 引信储备式铅酸电池储存性能探讨

    Research on the Storage Performance of Lead-acid Battery Used in Fuze

  27. 电动汽车用动力铅酸电池快速充电技术研究

    Research on the Quick-Charging Technology for Lead-Acid Battery in EV Application

  28. 中国铅酸电池产业存在的问题与展望

    Current problem and perspectives of lead-acid battery industry in China

  29. 钛作铅酸电池正极板栅可能性研究

    Probability Study on Ti Used as Positive Electrode Grids for Lead-acid Battery

  30. 铅布作为铅酸电池板栅的研究

    Study on lead mesh used as grids of lead-acid battery