焙烧温度

焙烧温度对Au/Fe2O3Zr-O2水煤气变换催化剂的影响

Influence of calcination temperature on Au / Fe_2O_3-ZrO_2 water-gas shift catalyst

最佳焙烧温度为550℃，w（粘结剂）为30%；

Optimum calcination temperature is 550 ℃, mass fraction of adhesive is 30 % .

探讨了焙烧温度、焙烧时间、pH值，锂过量系数对溶胶-凝胶法制备磷酸铁锂的电化学性能的影响。

The effects of sintering temperature , sintering time , pH value , Li excess coefficient were studied .

其中主要考察了溶液浓度、pH值、焙烧温度、时间以及气氛等对最终产品物相的影响。

The influences of the solution concentration , pH value , calcination temperature , time and atmosphere were investigated .

优化了合成过程中的工艺条件，包括K过量百分数、焙烧温度等。

Then , the synthesis conditions , such as KOH excess % , calcination temperature , etc. were optimized .

焙烧温度对Au/Fe2O3选择性氧化富氢气体中CO催化性能的影响

Effect of calcination temperature on CO selective oxidation in H_2-rich gas over Au / Fe_2O_3 catalyst

焙烧温度对Al2O3载体及Pd/Al2O3催化剂性能的影响

Effect of calcination temperature of support on performance of Al_2O_3 support and Pd / Al_2O_3 catalyst

焙烧温度对载Ag多孔SiO2抗菌性能的影响

Effects of Sintering Temperature on Antibacterial Performance of Ag-carried by Porous SiO_2

随着焙烧温度的升高，改性TiO2催化剂中锐钛矿相所占比例减少，金红石相比例增加。

As the calcination temperature increment , anatase was reduced and rutile was increased .

考察了沉淀剂、硝酸盐浓度、共沉淀温度、pH值、焙烧温度等对催化性能的影响。

Effects of precipitants , nitrate concentration , coprecipitation temperature , pH value , and calcination temperature on catalytic activity were studied .

焙烧温度对Mg（Al）O复合物结构和表面酸碱性质影响的研究

Exploration on Influence of Calcination Temperature on Structure and Surface Acidity and Basicity of Mg ( Al ) O Composite Oxide

不同焙烧温度对Cu/γ-Al2O3催化剂铜物种结构的影响

The Effect of Different Calcination Temperature on the Structure of Cu / γ - Al_2O_3 Catalysts

制备方法及焙烧温度对Co3O4/CeO2催化剂上CO低温氧化反应的影响

Effect of Preparation Method and Calcination Temperature on Low-Temperature CO Oxidation over Co_3O_4 / CeO_2 Catalyst

以聚氧乙烯十二烷基醚为模板剂，钛酸四丁酯为钛源制备了中孔TiO2，探讨了焙烧温度和掺杂对中孔TiO2结构的影响。

Mesoporous TiO_2 was prepared using polyoxyethylene-dodecyl-ether as a template and tetrabutyl titanate as a titanium source .

在Ti系钙钛矿型混合氧化物催化剂上的甲烷氧化偶联&焙烧温度的影响

Studies on the Perovskite-Type Mixed Catalysts of Titanium System for Oxidative Coupling of Methane ─ The Influence of Calcination Temperature

通过控制PVP／Au的比例和焙烧温度制备出尺寸大小不同的两组催化剂，分别测试其CO催化氧化活性，以此来考察了金的颗粒大小对CO催化氧化活性的影响。

The relationship between particle size and CO catalytic oxidation activity of gold nanoparticle catalysts has been investigated systematically .

焙烧温度对TiO2纳米晶型转变及粒度的影响

Investigation on influence of calcining temperature on crystal structure and sizes of nanometer titania

分析了-γAl2O3的负载量及其焙烧温度对堇青石比表面积的影响。

Influence of γ - Al2O3 content and baking temperature on special surface area is analyzed .

最终确定的最佳焙烧温度为450℃，最佳的Zr／Ti为0.5。

We conclude that the optimal sintering temperature is 450C and the optimal Zr / Ti ratio is 0.5 .

催化剂的用量、焙烧温度以及反应条件对TiO2的降解效率具有很大的影响；

Photocatalysts loading , calcinations temperature and reaction acidity can significantly influence the photodegradation efficiency ;

其中焙烧温度和掺杂物浓度分别是影响TiO2催化剂晶型结构和晶粒尺寸的主要因素。

The calcination temperature and doping concentration of TiO2 catalysts were main factors affecting the crystal structure and grain size .

而且Ru、C的修饰量、焙烧温度及焙烧气氛对催化剂的光催化活性都有一定的影响。

The influences of calcination temperature , calcination atmosphere and contents of C and Ru on the photocatalytic activity of the samples were investigated .

固体超强酸焙烧温度、引入SiO2比例对催化剂的性质以及萘齐聚反应都会产生影响，对萘齐聚物的结构进行了初步分析。

Superacid calcination temperature and the quantity of introduced SiO 2 exhibited effect on catalyst properties and naphthalene oligomerization .

随焙烧温度升高，载银多孔SiO2抗菌性能逐渐降低。

The antibacterial performance of the Ag-carried porous silica is progressively decreased with the increase of the sintering temperature .

氯化镁-乙醇络合物中乙醇的NMR定量研究焙烧温度对镁铝复合氧化物载体性能的影响

QUANTITATIVE DETERMINATION OF ETHANOL IN MgCl_2 / ETHANOL COMPLEX BY NMR SPECTROSCOPY Effect of Calcination Temperature on Performance of Mg-Al Composite Oxide Support

结果表明，稀土离子的掺杂量、降解液的pH、催化剂的添加量和焙烧温度对光催化性能有一定影响。

The results showed impact factors for photocatalytic property were the added amount of catalyst , pH of degradation of the solution , volume of rare-earth-doped and the calcination temperature .

钴负载量和焙烧温度对F-T合成用Co/Al2O3催化剂活性的影响

Effects of Co Loading and Calcination Temperature on Catalytic Activity of Co / Al_2O_3 for F-T Synthesis

用定性和定量的方法系统研究了浸渍液的pH值、焙烧温度、时间、MoO3总含量等因素对MoO3/γ-Al2O3中两种钼物种相对含量的影响。

The effect of pH value of impregnation solution , calcination time , calcination temperature and the total content of MoO_3 etc.

其制备条件为：水浴温度T1、凝胶pH值X3，焙烧温度t3，还原温度T。

Its preparative conditions are as follows : The water bath temperature is T1 , the pH value is X3 , the bake temperature is t3 , and reduction temperature is Tc .

焙烧温度对Fe-Mn催化剂结构和F-T合成性能影响

Effect of calcination temperature on the structure and Fischer-Tropsch performance of Fe-Mn catalyst