激振器

采用分析边界形状法对激振器骨架进行形状优化

Shape Optimization of Electrodynamic Shaker Skeleton with Method of Boundary Shape Analysis

一种实现任意频响的激振器控制的方法

A Vibration Shaker Control Method with Arbitary Frequency Response

面向并行工程的振动机激振器CAD系统的开发

Facing concurrent engineering CAD system development of vibrator

Z（D）DM圆振动筛激振器的改进设计

The improvement design of vibrator of Z ( D ) DM model circle vibrating screen

它采用精密声级计做为声传感器、激振器做为作动器，通过对性能加权函数和鲁棒加权函数的选取，设计了相应的鲁棒H∞控制器。

The robust H_ ∞ controller has been designed through the elections of the performance weighting function and the robust weighting function .

研究结果表明：2D阀控缸电液激振器的频率、幅值和偏置可实现独立解耦控制。

It is concluded that frequency , amplitude and offset can be controlled independently in 2D exciter .

GS型概率分级筛激振器机架的改进

Improvement of GS type probability screen vibration frame

2D阀控缸电液激振器激振波形研究电磁振动排种器振动系统参数的确定

The Excited Waveform Analysis of the Electrohydraulic Vibrator Based on 2D Valve ; Parameters Study on the Vibrant System Electromagnetic Vibrated Seeding Apparatus

为了提高电液激振器的频率，提出一种采用2D阀控制液压缸实现激振的新方案。

A scheme of electrohydraulic vibration exciter using a2D valve to control a hydraulic actuator was proposed to enhance the working frequency to a large scale .

在现场使用实践的基础上分析了SYS型自清振动筛激振器故障的原因。

This paper is based on the practice , which analyzed the cause of the fault of the SYS Self-Cleaning vibrosieve .

CVE-2型混沌激振器运动的数值仿真和混沌识别

Numerical Simulation and Chaotic Identification of the Motion of CVE-2 Type Chaotic Vibration Exciter

XDJ多振动运动激振器的工作特性分析

XDJ Multi - vibration Vibrator

本文研究了一种新的激振器&基于KAM定理设计的三自由度的端面式混沌激振器，即在同一偏心轴上套装两个端面接触的偏心块。

In this paper , a new exciter & three degrees chaos exciter based on KAM theorem , that is to fix two eccentric blocks contacted by end face on the same axis .

建立了使用滑动轴承的CVE-2型混沌激振器所产生的运动的数学模型，并对其进行了数值仿真和混沌识别。

The mathematical model for the motion of CVE 2 type chaotic vibration exciter was set up and its numerical simulation and chaotic identification were carried out .

本文介绍采用国产小型激振器（北京测振仪器厂生产的JX-1型加速度校准仪）校准标准加速度计的互易校准法，给出校准误差，并把校准结果与采用中频激光测振仪校准的结果进行比较。

A reciprocity method for the calibration of standard accelerometer and its error are discussed in detail . A comparison of calibration between the reciprocity method and the method using laser interferometer is given .

当采用大振幅时（60μm），接近超声波激振器耦合点的上部区域（有源（上））热影响区的-20℃冲击值也达到大于27J的水平。

When using a large amplitude ( 60 μ m ), impact value of heat affected zone which close to the upper area of ultrasonic exciter coupling point is greater than 27J too .

自同步振动磨惯性激振器设计

Design to the Inertia Exciter of Self - Synchronous Vibration Mill

一种旋转阀控液压激振器的实验研究

Experimental Research on a Hydraulic Exciter with Rotating Valve Control

激振器偏移式振动筛方向角的确定与电算

Determination and CAC of deflection for a vibrating screen with offset exciter

振动筛减振分析及激振器轴承的选择

Shock - absorbing Analysis and Bearing Selection of Vibrating Screen

激振器支承弹簧板的动态优化设计

Dynamic optimized design of the shaker 's supporting spring plate

振动设备激振器轴承装置的设计

Design of Bearing Set of Vibrator Used in Vibrating Equipment

一次仪表部分包括振动管、激振器和传感器等。

Primary instrument includes vibrating tube , exciter and sensor .

简要叙述液压激振器的基本原理和特点。

The basic principle and characteristic of this unit are described briefly .

共振式电磁激振器振动系统的仿真分析

The Simulation and Analysis of the Vibration System of Resonance Electromagnetism Vibrator

振动给料机由双偏心轴激振器提供直线振动源。

Double eccentric shaft vibration exciter is the source of linear vibration .

激振器是一种激励振动装置。

The vibration exciter is a exciting vibration unit .

电动式激振器的研究及其在工程中的应用

The Research and the Engineering Application of Electrodynamic Vibrators

振动筛激振器轴承的可靠性问题及对策

Reliability of Bearings for Exciters of Vibro - screen

液压激振器振动参数的设计

Design ing the vibration parameters of hydraulic vibration exciter