四冲程内燃机

四冲程内燃机谐振进气系统的特性分析及其对进气过程的影响

Characteristic Analysis of Tuned Intake Charging Systems for Four-stroke Internal Combustion Engine and Its Influence on Intake Process

内燃机模式的工作原理与普通四冲程内燃机相同，因此不可避免的也会产生有害排放物。

The operating principle of internal-combustion engine mode is similar to the four-stroke internal combustion engine , so it will inevitably produce harmful emissions .

四冲程内燃机气门间隙调整方法的探讨

Study on Adjustment of Valve Clearance on Four-Stroke Internal Combustion Engines

单缸四冲程内燃机的力分析

Force analysis of internal combustion engine with single cylinder-four strokes

四冲程内燃机活塞销轴承轴心轨迹计算

Calculation of Piston Pin Bearing Journal Center Orbit Of Four Stroke I.C.E

四冲程内燃机可调气门的快速确定与简易记忆法

Rapid determination and simple memorizing of adjustable valves in 4 - stroke IC engines

四冲程内燃机配气相位与快速调整气门间隙的研讨

Study on Valve Timing and Fast Adjustment of Valve Clearance of Four-Stroke Internal Combustion Engines

四冲程内燃机进气冲压过程的研究

An investigation of the process of the induction ram on a four stroke internal combustion engine

采用复数法，在不考虑摩擦力的情况下建立了单缸四冲程内燃机的力分析数学模型，确定了计算框图，并编制了专用的计算机程序。

A calculation method for force analysis of the internal combustion engine with four strokes was established , and a flow chart was presented .

本文通过四冲程内燃机凸轮形状、配气相位和作动间隔角的分析，从中得出可调气门的快速确定方法和简易记忆法。

Through an analysis of the cam shape , air supply phasing and interval angle of movement of the 4-stroke IC engine a rapid determination method and a simple memorizing method are obtained .

根据二冲程气动发动机和四冲程内燃机的台架试验对四冲程压缩空气/燃油混合动力发动机两种工作模式的仿真结果进行了试验评估。

According to the test results of two-stroke compressed-air powered engine and four-stroke internal-combustion engine , the simulation results of the two working mode of four-stroke hybrid compressed-air and fuel prototype engine are assessed .

建立了内燃机缸套活塞系统油膜润滑与动力学行为的耦合分析模型，并用数值方法对单缸四冲程内燃机进行了仿真分析。

An analysis model of coupling engine block dynamics behavior to lubrication in cylinder piston system in internal combustion engine was established , and the numerical simulation of the model was processed through linking ANSYS software to FORTRAN code for lubrication .

主要介绍了气门间隙大小的变化及其对内燃机工作性能的影响，探讨了四冲程内燃机气门间隙调整的方法。

The changes of valve clearance and their effects on the working function of internal combustion engine are ( introduced ) in this paper , and the ways to adjust the valve clearance of four-stroke internal combustion engines are studied ( also . )

本文论述四冲程三缸内燃机，五缸内燃机气门间隙的调整原理与方法。

In this article the Valve tappet adjustment for three and five-cylinder of four-Cycle engines is discussed .