台阶高度

分别使用ISO5436标准中推荐的ISO算法以及美国国家标准与技术研究院（NIST）推荐的Two-sided算法，计算台阶高度。

Then , the step height is calculated with some algorithms : the ISO algorithm adopted by ISO 5436 and the two-sided algorithm used at NIST ( the National Institute of Standards and Technology ) .

将该系统应用于微电子掩模板台阶高度标准的测量，实验表明DICM的测量值与国际比对结果相符合，系统具有良好的复现性，极限偏差小于5nm。

DICM has been successfully utilized to measure the mask standard step height and the experimental results agree well with that of the international calibration . The results also show the system has good repeatability with a maximum deviation of 5 nm .

较高脆弱性出入口的共同特点是多为敞开式出入口，而且出入口处台阶高度均小于30cm。

The common character of entrances which have higher vulnerability rank is that they are the open-style entrance .

贝氏体铁素体台阶高度为6～160nm，相当于｛111｝晶面1000个原子层厚度。Cu－Zn－Al合金台阶高度为几个至几十个纳米。

The heights of the ledges in bainitic ferrite are within 6 ~ 160 nm which correspond to 1000 atomic layers of { 111 } crystal planes while the heights of ledges are several and several tens nm in Cu-Zn-Al alloys .

论深凹露天矿的台阶高度与运输功的关系

On relationship between bench height and transport work in deep open-pits

露天矿台阶高度的优化

The Optimization of the Bench Height of Open - pit Mines

深凹露天矿最佳台阶高度的探讨

An approach to the optimization of bench height in open-pit mines

冀杨石矿台阶高度的确定

The determination of the bench height for Jiyang stone mine

磁场对微波感应台阶高度的影响

Effect of a magnetic field on the height of the microwave-induced step

多目标模糊决策在台阶高度优化中的应用

Application of Multiobject Fuzzy Policy-decision Method in the Optimization of Bench Height

论台阶高度对露天矿经济效益的影响

Effect of Bench Height on Economic Benefit for Open-Pit Mining

台阶高度是微电子产品的一个重要性能参数。

Step height is an important parameter of micro-electronic mask .

台阶高度对矿山生产能力影响初探

Preliminary discussion on the effect of bench height on mine production capacity

增加台阶高度对于降低采矿成本是有益的。

Bench height increasing is beneficial to reducing mining cost .

台阶高度与矿岩运输功含量的关系

The relation of bench height to transport work content of ore and rock

大台阶高度测量的外差共焦方法

Method of Heterodyne Confocal Microscopy Measuring Big Step Height

露天矿台阶高度与开采选别性的经济评价研究

Economic Evaluation of Open-pit Bench Height Through Mining Selectivity

基于反应流的台阶高度对超音速燃烧室性能影响研究

Investigation of Step Height Effect on Supersonic Combustor Performance Based on Reaction Flow

露天矿排土场合理台阶高度的确定

Determination of Rational Bench Height of Open-pit Dump

台阶高度是一个重要的参数。

Step height is an important parameter .

基于矿岩运费的深凹露天矿合理台阶高度探讨

Study of the Rational Bench Height of Deep Open Pit Mines Based on Transportation Cost

台阶高度对露天台阶爆破影响的试验研究

Research of the Influence of Bench Height on Open Mine Bench Blasting with Model Test

可调波长半导体激光测量台阶高度方法研究

Step Height Measurement with Tunable Diode Laser

台阶高度测量是目前新提出的国际计量比对项目之一，当前的趋势是向纳米量级精度发展并尽量扩大测量范围。

Measurement of step height is one of the new international comparisons in nano metrology .

接触式台阶高度测量数据分析及处理系统研究

Research on the Data Analysis and Processing System of Step Height Measurements by Stylus Method

台阶高度测量方法研究现状及进展

Development of step height measurement

显微干涉系统测量微细图形的台阶高度

Step-height Measurement Using Microscopic Interferometry

表面台阶高度测量在表面计量学中有十分重要的作用。

The measurement of step height of surface plays a very important role in the surface metrology .

薄膜沉积法具有精确控制台阶高度及台阶表面较光滑的优点。

The thin film deposition can control precisely the height of the step and can obtain smooth surface .

可测量台阶高度，槽宽，在二维方向确定孔或轴的位置。

Measure the height of STeps , width of grooves , position of bores or shafts in2 co-ordinates .