假塑性

结果表明，PF－Ⅱ尼龙是非牛顿假塑性流体；

The results show that the PF ⅱ nylon is a non Newtonian and pseudoplastic fluid .

在此条件下，所得低DE值麦芽糊精的DE值为2.9。2、大米淀粉和麦芽糊精均属于非牛顿假塑性流体。

Under this condition , the dextrose equivalent of the maltodextrins is 2.9.2 、 Rice starch and maltodextrins are the properties of non-Newtonian pseudoplastic fluid .

PAN基碳纤维针刺毡表明出具有良好的破坏抗性和假塑性。

PAN-based carbon fiber shows good resistance of destruction and pseudoplasticity .

研究结果表明：PP/K树脂合金材料的流变行为同PP一样，仍属于非牛顿型假塑性流体流动行为。

The results showed the rheological behaviour of PP / K-resin was the same with that of PP.

并且接枝产物的流变性能与PP一样为假塑性流体。

The rheological properties of grafted products and PP was still a kind of non-Newtonian pseudoplastic fluid .

假塑性高粘流体垂直管内流动沸腾CHF

Study on CHF of flow boiling heat transfer to a pseudoplastic highly viscous fluid

蜡质玉米淀粉糊属假塑性流体，且糊的表观粘度受淀粉浓度、温度和pH值的影响。

The paste of waxy maize starch was a plasto-fluid , the apparent viscosity of the pastes was affected by the starch concentration , temperature and pH values .

室内实验中观测了CO2泡沫压裂液的形成、动态变化、泡沫结构，测定了CO2泡沫压裂液的流变性，发现其属于假塑性非牛顿流体。

So laboratory measurement and study are made on preparation of CO2-foam fracturing fluid , rheological measurement and friction computation methods in this paper .

结果表明，随PA用量增多，共混物的假塑性变得不明显，呈现出宾汉流体的行为；

The result shows that , with the increase of PA amount , pseudoplastic flow becomes unapparent and Binham flow becomes apparent .

CMC溶液是典型的假塑性流体，溶液的粘度随剪切速率的升高而降低。

CMC aqueous solution shows pseudoplastic behavior . The shear viscosity of CMC solution decreases with increasing the shear rate .

文中尝试利用kε模型计算了假塑性流体羧甲基纤维素钠（CMC）水溶液在搅拌槽内的三维流动场，并与粒子成像测速（PIV）法测得的实验结果进行了比较。

In this paper , the flow field of a shear thinning fluid carboxymethylcellulose ( CMC ) was simulated using standard k ε model .

CMC水溶液一般呈假塑性，其零剪切粘度随CMC分子量、取代度（DS）的升高而增加，但取代度对溶液流变性质的影响较小。

CMC aqueous solution exhibits pseudoplastic behaviour . Zero-shear viscosity increases with the molar mass and degree of substitution ( DS ) .

结果表明：PP/蒙脱土纳米复合材料的流动特性与常规PP相似，为典型的假塑性流动；

The results showed that PP / montmorillonite nano-scale composite had typical pseudoplastic behaviors as normal PP , its non-Newtonian index increased with the increase of the temperature .

对于低浓度PAM水溶液，表现为牛顿性流体，超过一个临界浓度（C）以上，PAM水溶液表现为假塑性流体。

Low concentration PAM aqueous solutions behave as Newtonian fluids , but PAM aqueous solutions with concentrations exceeding critical concentration ( C ) behave as pseudoplastic fluids .

CMc水溶液也呈假塑性，粘度随剪切速率的升高而降低，随浓度的增加而升高。

CMc aqueous solution also showed pseudoplastic behavior . The solution viscosity decreases with increasing shear rate and increases with increasing concentration .

结果表明：CPVC和改性CPVC熔体均为假塑性流体，改性CPVC的假塑性增强，熔体表观粘度低于CPVC的熔体表观粘度。

The results showed that the melts of CPVC and modified CPVC were pseudo-plastic fluids .

在多数实验条件下，WPC溶液具有假塑性液体性质，可以用幂律模式（powerlawmodule）来表示，在极端条件下，溶液的流动特性则接近牛顿液体或塑性液体。

All WPC solutions exhibited pseudoplastic properties and can be described by the power law module at most experimental conditions . pseudoplastic behaviour of the solution may changed to Newtonian or plastic at extreme conditions .

结果表明：阻燃PS熔体表观黏度（ηn）随剪切速率的增大而减小、随温度的升高而降低，具有假塑性流体的特性；

The result shows that the flame retardant PS possesses the features of pseudo plastic fluid , its apparent viscosity (η _a ) decreases as the shear rate or the temperature rises .

n，且n值小于1，凝胶的起始运动存在一个屈服应力τy，说明这种凝胶是一种假塑性宾汉流体。

~ n and the value of n is less than one . The gel must overcome yield stress τ _y before it begins to move . So the gel is a kind of pseudoplastic Bingham fluid .

结果表明：低熔点聚酯熔体属于非牛顿型假塑性流体；与普通聚酯PET相比，低熔点聚酯熔体粘度对温度的敏感性相对较小；

The result showed that the low melting point polyester melt was non - Newton pseudoplastic fluid , and the viscosity of it was less sensitive to temperature than that of common PET .

PP／PP-R共混物熔体属假塑性流体，熔体粘度随PP-R含量的增加逐渐增大。

PP / PP-R blends are pseudoplastic fluid . Melt viscosity of the melt promptly increased with increasing of the PP-R content .

CMC溶液呈现假塑性，溶液的粘度随剪切速率的升高而降低，溶液的储能模量G？和损耗模量G？？都对频率有很强的依赖性。

CMC aqueous solution shows pseudoplastic behavior . The shear viscosity of CMC solution decreases with increasing the shear rate and the storage modulus G ' and loss modulus G '' are highly dependent on frequency .

文中采用SIMPLER方法，以苯乙烯-聚苯乙烯物系为例，对高粘假塑性流体管内传热进行了仿真计算。

In this article , we adopt SIMPLER method , take styrene-polystyrene as an example and make a simulating calculation of heat transfer of a high viscosity pseudo - plastic fluid in the tube .

FTIR和DSC测试结果表明丙烯酸酯类单体之间发生了自由基共聚反应；乳液的流变性分析说明该乳液具有假塑性，且贮存稳定。

The analyzed results of FTIR and DSC , research of rheological changes respectively show that the radical copolymerization has happened among the monomers , and latexes are pseudoplasticity and have good stability .

研究发现，硅灰石/聚丙烯（PP）体系属非牛顿假塑性流体，熔体流动性接近或优于PP，这有利于加工稳定性的提高；

The studies find out that wollastonite / polypropylene ( PP ) system behaves as non-Newtonian pseudoplastic fluid with melt flowability close to or better than PP ; this property is beneficial to raising stability of processing .

结果表明：精制桃胶溶液的表观粘度受溶液浓度、温度、pH值的影响较大，但同时具有较好的冷冻-解冻稳定性、耐酸性及耐盐性，是一种假塑性流体。

The results showed that the apparent viscosity of the gum solution was greatly influenced by the concentration , temperature and pH. At the same time , it had good frozen-thawing stability , acid-resistance and salt tolerance , it was pseudoplastic fluid .

研究不同单体改性CPVC的流变性能，发现CPVC和氯化接枝改性CPVC熔体均属于假塑性流体。

When study the rheological properties of the modified CPVC , it was turned up that CPVC and the modified CPVC were pseudo-plastic fluids .

添加CMC的南瓜浓缩汁在47°Brix呈现假塑性；当浓缩至55°Brix和63°Brix时，呈现触变性。

47 ° Brix of pumpkin juice concentrate with CMC exhibited pseudoplastic property , while 55 ° Brix and 63 ° Brix exhibited thixotropic property .

结果表明：CM-CMS糊液表现为假塑性流体特征；

The study shows that CM-CMS paste shows a pseudo-plastic behavior .

结果表明SSDS乳化能力强，而且乳化稳定性比较好；SSDS糊符合假塑性流体特征，糊的凝沉性减弱。

The results showed that SSDS had a good emulsion ability and stability and that the SSDS paste accorded with the character of rheological body .