首页 / 词典 / good

za

  • abbr.扎;South Africa 南非(代号);zero-adjusted 零点调整的
zaza
  1. Material Resistance and Research Status of ZA Alloys Resistance Property

    材料阻尼及ZA合金阻尼性能的研究现状

  2. Study on Management Pattern of Meat Sheep 's Industrialization for Za Group

    ZA集团肉羊产业化经营模式研究

  3. Suitable scale of Za 343 and A 7 could be developed ;

    扎343和阿7可以适当发展;

  4. Wear Resistance Performance of ZA 27 Alloy Reinforced by Rare Earth Compounds

    稀土化合物增强ZA27合金耐磨性的研究

  5. Microstructure and characteristics of soldered joint of high strength ZA alloy

    高强度ZA合金钎焊接头的显微组织及性能

  6. ZA Worm Drive Finite Element Analysis Based on ANSYS

    基于ANSYS的ZA蜗杆传动有限元分析

  7. The Multi - dimensional Study of ZA in Chinese

    汉语零形回指的多视角研究

  8. Influence of Cooling Rate and Alloy Composition on Latent Heat of ZA Alloy

    冷却速度和合金成分对ZA合金结晶潜热的影响

  9. Za means a variety , and Bai means a lot .

    杂谓杂多,百也是形容多;

  10. Influence on ZA 42 Solidification Mode by Electric Current

    电流对ZA42合金凝固方式的影响

  11. Study on Mechanism of Ti and Zr Modification of High Aluminum ZA alloy

    高铝锌合金的钛和锆变质机理研究

  12. Advancement of ZA air jet loom for air leading weft control system

    ZA型喷气织机喷气引纬控制系统的改进

  13. A Study of the Corrosion Resistance of ZA Alloys

    锌铝合金耐腐蚀性研究

  14. The development and preliminary studies on cytoplasmic male sterile soybean line ZA

    大豆细胞质雄性不育系ZA的选育和初步研究

  15. Study on the Effect of Al and Cu Content on the Mechanical Properties of ZA Alloy

    Al,Cu含量对ZA合金性能影响的研究

  16. Microstructure and characteristics of soldering joint interfacial region of ZA alloy

    锌基合金钎焊界面区的微观组织形态及相组成

  17. The Structure and Property of Squeeze Cast ZA 27 Alloy

    挤压铸造ZA-27合金的组织与性能

  18. Dry Material Accumulation and Dynamic Distribution of Xiang za 8th Under Different Density

    不同密度下湘杂棉8号干物质积累及动态分配

  19. ZA Electronic Let-off Device on Air Jet Looms and its Performance Analysis

    ZA型喷气织机电子送经装置及其性能分析

  20. Extruding Work of High Strength Casting Zinc-Based Alloy ZA - 27

    铸造高强锌基合金ZA-27的挤压加工

  21. Defect formation and mechanism of ZA alloy made in continuous casting by heated mold

    热型连铸锌铝合金的缺陷形成与机理

  22. Technique of producing ZA alloys by heated mold continuous casting

    锌铝合金热型连铸的工艺方法

  23. Research on High - strength ZA Alloy Solders

    高强度ZA合金软钎料的研制

  24. Solid modeling method of ZA worm-gear based on bicubic B-spline surface

    基于双三次B样条曲面的ZA蜗轮实体建模方法

  25. This paper introduced the technical parameters of furnace and flame soldering for ZA alloy .

    确定了合适的钎焊工艺。探讨了适合ZA合金的炉中钎焊及火焰钎焊的钎焊工艺参数。

  26. In this study , ZA structural change model and GARCH model for the establishment of a model prediction .

    本文研究采用ZA结构改变模型和GARCH模型建立一个模型预测。

  27. Study on corrosion resistance of Hypereutectic ZA alloy weld

    过共晶ZA合金焊缝的耐腐蚀性

  28. Control of the Segregation of Al in ZA 27 Alloy by Centrifugal Casting

    离心铸造ZA27合金铝偏析的控制

  29. Microstructure and Defects of ZA 27 Alloy by Centrifugal Casting

    ZA27合金离心铸件的组织与缺陷

  30. Breeding of A High Yield and Double-Low Hybrid Rapeseed Za 9522

    高产双低油菜杂交种杂9522的选育