uts

Inspiration of Teaching Methods on Course of Initiatory Architectural from UTS

悉尼科技大学建筑初步课教学方法启示

Influence of fibre length on UTS and reliability of mullite / zl109 Composites

纤维长度对M/ZL109复合材料强度及可靠性的影响

The structure homogenization as well as UTS and elongation is related to tempering temperature time , interlayer agent etc.

其组织的均匀程度与抗拉强度、延伸率一样与回火温度、时间及中间层合金的成份有关。

After heat treatment , UTS and YTS of RS bars did not change obviously , the E % improved 5.6 times .

热处理后，快速凝固挤压棒材的抗拉强度和屈服强度均没有明显变化，伸长率却提高了5.6倍。

Conclusion Defining the concept of ulnar tunnel and the knowledge of the complexity and rarity of UTS can effectively guide diagnosis and treatment .

结论明确腕尺管的概念、腕尺管综合征的少见及复杂性，可以有效指导临床诊断和治疗。

In addition , the mechanical properties ( including the UTS value and microhardness ) of the welded joints decreased compared to the welded joint without flux .

涂覆活性剂后，焊接接头的力学性能（包括极限抗拉强度和硬度）降低。

The results show that the addition of Y and Zn improves YTS values but decreases the UTS and elongation values of as-cast alloys .

结果表明：Y、Zn元素提高了合金的屈服强度但降低了抗拉强度和延伸率。

The output parameters of the model are three mechanical properties namely ultimate tensile strength ( UTS ), yield strength ( YS ) and elongation ( ELO ) .

模型的输出为三个力学性能指标，即抗拉强度、屈服强度和延伸率。

It is feasible to forecast the casting UTS by measuring DAS , but the effect of hole ratio on UTS should not be neglected .

通过测定二次枝晶间距来预测铸件的抗拉性能是可行的，但是孔洞率对抗拉强度的影响不可忽视。

, and YS ( yield strength ) and the value of YS / UTS increase through the followed artificial ageing with obvious loss of elongation .

而其后的人工时效处理能明显提高合金的屈服强度和屈强比，但也明显降低了延伸率。

Both DAS and P have effects on UTS of the casting , but that of UTS is the primary effect within the scope of data in this experiment .

DAS和P都影响着铸件的UTS，但在本实验数据范围内，DAS的影响是主要的。

Working in UTS is introduced by my aunt , just no to waste the time of finding a job , and I didn 't sighed to be a formal employee .

UTS公司是因为姑姑介绍，只是进去帮忙，可以有效利用找工作的这段空闲时间，并没有签约正式成为他的员工。

Objective To discuss the concept of ulnar tunnel at the wrist , the types , causes , traits of compression , diagnosis , and clinical significance of ulnar tunnel syndrome ( UTS ) .

目的探讨腕尺管的概念，腕尺管综合征的分型、病因、卡压特点、诊断及其临床意义。

At the same time , the Ultimate Tensile Strength ( UTS ) has increased remarkably , the transcrystalline fracture of tungsten particles is the major fracture form in the SEM fracture photos .

合金强度也显著增加，断口照片上显示钨晶粒的穿晶断裂为主要的断裂方式。

Compared with the steel without adding trace elements , non breach impact toughness , UTS and elongation were increased by 192 % , 16 % and 65 % respectively , but hardness was not obviously changed .

与未加微量元素的试验钢相比，在硬度基本相同的情况下，无缺口冲击韧性和强度分别提高192%和16%，伸长率提高65%。

CW_PA , ceramometal alloy , joined by laser welding machine , was tested by the UTS , SEM and metallographic_examination . The good results show that it can be applied to the clinic .

激光焊接CWPA烤瓷合金，测试其力学性能，作金相，SEM分析，结果表明完全达到临床要求。

It is shown that the ultimate tensile strength ( UTS ) torsion failure life ( TEL ) and reverse bending failure life ( RBFL ) are decreased obviously as the consequences of the zincing .

研究结果表明，热镀锌使双相钢冷拔钢丝的抗拉强度、扭转寿命和弯曲寿命降低。

The Unmanned Turret System ( UTS ) is the developing direction for future fire system . The UTS is relatively secure to the crew members when the tank and armored vehicle turret is hit with a high probability .

无人炮塔系统是未来火力系统发展的方向，在坦克和装甲车辆炮塔部分被命中概率高的现实情况下，无人炮塔对乘员来说相对安全。

Compared with peak aging alloys , the ultimate tensile strength ( UTS ) of two-step aging alloys reduced by about 13 % , but UTS of regression-reaging treated alloys excelled that of peak aging alloys .

同时发现，双级时效合金的抗拉强度比峰时效合金的强度下降了13%左右，而回归再时效合金的强度优于峰时效合金的强度。

High temperature oxidation at 1173 K in simulated combustion gas decreases the elongation (δ), yield strength (σ 0.2 ) and the ultimate tensile strength ( UTS ) tested at 1073 K and the strain rate of 10-4 s-1 notably for this alloy .

研究发现：在1173K模拟燃烧气氛中的高温氧化显著降低了该合金在1073K的总延伸率（δ），屈服强度（σ0.2）和最大拉伸强度（UTS）。

It is suggested that the pressure for solidification mostly affected the early and last dimension of the air holes , and the last dimension of the air hole played an important role for the UTS of the mullite short fibre reinforced Al matrix composites .

结果表明，气孔类残余孔洞初始尺寸和最终尺寸与保压压强有关，并显著影响莫来石短纤维增强铝基复合材料的拉伸强度。

The improvement of YTS is attributed to the grain refinement strengthening of Y and Zn , and to the solid solution strengthening of Zn . The reduction of UTS and elongation are caused by the precipitation of a compound phase along the grain boundary .

Y、Zn元素的细晶强化及Zn元素的固溶强化是屈服强度提高的主要原因；抗拉强度和延伸率的降低是由于化合物相沿晶界析出。