statcom

Based on the analysis of its system structure , a detection algorithm of single-phase dynamic reactive current is presented and applied to STATCOM .

通过分析单相动态无功补偿系统结构，提出了一种新型的单相动态无功电流检测算法，并将其应用于静止同步补偿器。

A Hardware Realization and Control of D & STATCOM

D&STATCOM的硬件实现及控制

Static Synchronous Compensator ( STATCOM ) is an important FACTS device .

静止同步补偿器（STATCOM）是一种重要的FACTS装置。

The simulation results show that the Multi-Objective controller is correct and MATLAB model of STATCOM is successful .

仿真结果验证了所设计的多目标控制器的正确性以及本无功发生装置仿真模型的有效性。

The conclusions obtained from the paper provide theoretical references for the extensive application of STATCOM in Jiangxi power system .

所得结论为STATCOM在江西电网的推广应用提供了理论依据。

Study about Static Synchronous Compensator ( STATCOM ) Based on Hybrid Cascaded Multilevel Inverter

基于混合级联多电平逆变技术的静止同步补偿器（STATCOM）的研究

The paper presents a circuit structure and control methods of controller of STATCOM based on SA4828 PWM signal generator .

介绍了一种采用三相PWM脉冲发生器SA4828组成的STATCOM控制器的电路结构和相应的控制策略。

Balancing compensation of3-Ph unbalanced load with cascade inverters based STATCOM ;

该系统可以避免三相不平衡负载对逆变器输出电压的影响。

For design of STATCOM device the different control method and main electric structure can be selected according to different requirements for system and control targets .

在设计STATCOM装置时，可根据系统要求的不同，控制目标的不同，选取不同的控制方法和主电路结构。

Control method is an important factor to have impacts on performance and effect of static synchronous compensators ( STATCOM ) .

控制方法是影响静止同步补偿器（STATCOM）补偿性能和效果的重要因素。

The simulation software PSCAD is used to analysis SPWM control based on three-level diode-clamped voltage source STATCOM .

接着利用PSCAD仿真软件对基于SPWM控制的三电平二极管钳位电压源型STATCOM进行了仿真和分析。

STATCOM mathematical model is set up to derivative the deadbeat STATCOM control model for unbalanced load .

建立了STATCOM的模型，并在此基础上推导出对不平衡负载补偿的STATCOM无差拍控制模型。

Main circuit configuration and integrated voltage-reactive power control scheme for balancing compensation with cascade inverters based STATCOM is proposed .

给出了采用链式STATCOM实现平衡化补偿的主电路结构及电压-无功综合控制方法。

According to the requirement of reactive power compensation , the paper presents a software and hardware design method of the STATCOM based on DSP .

根据配电网无功功率补偿的工程要求，提出了一种基于DSP的静止同步补偿器（STATCOM）软硬件设计方法。

In addition , we study the effect of STATCOM on static voltage stability of one-load infinite-bus power system .

对于包含STATCOM的单负荷-无穷大电力系统，分析了STATCOM对系统电压静态稳定性的作用。

Influences of improved LC output filter on STATCOM are discussed from both reactive power compensation ability and transient current tracking ability .

从无功补偿器能力和瞬态电流跟踪能力两方面讨论了改进的LC输出滤波器对STATCOM装置的影响。

A novel backstepping control technique based neural networks is presented for single machine infinite bus system with STATCOM to design a nonlinear controller .

针对带有STATCOM的单机无穷大总线系统，提出了一种新的神经网络逆推控制方法，设计了STATCOM的非线性控制器。

The SPWM pulse triggers circuit and control circuit applied to diode-clamped three-level STATCOM voltage source is designed .

通过上述分析，设计了应用于三电平二极管钳位电压源型STATCOM的SPWM触发脉冲天生电路和控制电路。

In this paper , by using a method of Fourier decomposition , a mathematical model describing dynamic characteristics of cascade STATCOM devices is presented .

该文通过傅立叶分解的方法，建立了链式STATCOM的数学模型。

This paper presents a control mode of STATCOM , which has a fast dynamic response , zero static error , compensate unsymmetrical load .

提出了一种动态响应快，无静态误差，可用于补偿不对称负载的STATCOM的控制方法。

Due to the low output current harmonic and fast response characteristics , single phase STATCOM is suitable for balancing compensation of three phase unbalanced load .

由于单相STATCOM具有输出无功电流谐波含量低、响应速度快等优点而适用于不平衡负载的平衡化补偿。

The robust stabilization control for one-machine infinite-bus electric power systems with STATCOM ( static synchronous compensator ) is studied .

研究包含静止同步补偿器（STATCOM）的单机-无穷大电力系统鲁棒镇定控制。

It is proved by the simulation results of the proposed compensation method that the single phase STATCOM possesses the ability to carry out fast balancing compensation .

对所给出的补偿方法进行了仿真研究，结果验证了单相STATCOM进行快速平衡化补偿的能力比较强。

In this paper , the2H / 3H hybrid multilevel inverter is proposed as the main circuit topology of STATCOM .

论文将2H桥-3H桥混合级联逆变器作为STATCOM的主电路拓扑结构，对其的工作原理进行了深入研究。

In this dissertation , a new kind of dynamic static var compensator & STATCOM for WPGS has been profoundly studied .

本文针对应用于风力发电系统的动态静止无功补偿装置STATCOM进行了深入的研究。

The region of attraction of one-machine infinite-bus power system with static synchronous compensator ( STATCOM ) was estimated .

研究了包含静止无功发生器（STATCOM）的单机-无穷大电力系统的吸引域。

STATCOM ( STATic synchronous COMpensator ) is mainly to support busbar voltage and maintain the stability of DC - link capacitor voltage .

静止同步补偿器（STATCOM）的主要功能是支撑节点电压，同时直流侧电容电压稳定也是STATCOM装置安全运行的保证。

For the purpose of static synchronous compensator ( STATCOM ) control , an improved PI control method is developed based on fuzzy set and auto-tuning techniques .

为静止同步补偿器设计了基于模糊集和自整定技术的PI控制器。

A static synchronous compensator ( STATCOM ) based on three-phase cascaded voltage source inverter ( TC-VSI ) is proposed .

提出一种三相电压源型逆变器级联的静止同步补偿器。

The model can be used to research the STATCOM behavior to provide theoretical guidance for optimal parameter design and to enhance STATCOM viability for asymmetric power systems .

基于以电容器为直流侧储能元件STATCOM在系统不对称情况下的数学模型，详细分析和解释了STATCOM在系统不对称条件下的运行特点、谐振现象以及参数对STATCOM的性能影响。