首页 / 词典 / good

60v

60v60v
  1. Automatic data collection , 0 ~ 60V direct current source and 6 test channels were developed ;

    数据自动采集系统,0~60V直流电源和6个测试通道;

  2. Additionally , cell voltages between 30V and 60V are the optimal voltage for getting high anodization degree PAFs .

    氧化程度较高的多孔氧化铝膜宜在30~60V电压下制备。

  3. In the application of the thermal image system , the optimized operating bias for the detector is at 60V / cm , not at 30V / cm .

    讨论了该探测器在热成像系统中最佳使用偏置应为60V/cm,而不是目前的30V/cm;

  4. At the same withstanding voltage of 60V , The capacitance of aluminum foil with Al-Ti composite oxide film was about 51 % higher than with pure Al_2O_3 film .

    铝电极箔比容随氧化膜耐电压的变化关系曲线表明,60V耐电压下,AlTi复合氧化膜的比容提高率为51%。

  5. Regenerative effect is good and it reaches level of chemical regeneration when regeneration voltage of mixed bed is 60v ; voltage of multiple bed is 90v and regenerative time is 60 minutes .

    动态实验表明:本实验装置混床再生电压60V,复床再生电压90V,再生时间均为60分钟,再生效果良好,达到了酸碱再生的水平。

  6. Since the switch dimension is only several hundred microns and the actuation voltage is 40 ~ 60V , the transient high voltage on the actuation path will couple to the signal line .

    由于开关尺寸为微米量级,而驱动电压高达40~60V,这样的瞬态高压有可能对开关上的信号产生影响。

  7. It can be seen as the optimum amplitude electrical stimulation of 60V . ( 5 ) Design a Orthogonal test of electrical stimulation by considering the waveform , amplitude , stimulation frequency and stimulation time .

    由此可以看出较优的电刺激幅值为60V。(5)综合考虑波形、幅值、刺激频率、刺激时间进行正交试验。

  8. The other circuit , by connecting two normal sillcon epitaxial planar transistors operated in avalanche mode in series , can easily achieve large-amplitude step like pulses with amplitude more than 60V into 50 Ω load and rise time less than Ins .

    另一个电路,通过两个普通硅外延平面开关晶体管在雪崩区的串联运用,很容易得到输出脉冲幅度大于60V、上升时间短于ins的大幅度近似阶跃脉冲。

  9. When the input voltage varies from 40V to 60V and the output side varies from no load to rated resistance load , the output voltage will vary within 1.3 % with the THD of less than 2 % and the highest efficiency of 86.3 % .

    当输入电压变化、输出从空载变化到额定阻性时,输出电压变化量小于1.3%,正弦输出电压波形失真度小于2%,变换效率最高为86.3%,额定阻性负载时效率为84.4%。