氧化处理

阳离子红X-GRL染料的UV、O3、O3/UV氧化处理研究

Oxidation of Cationic Red X-GRL Dye by UV , Ozone , and Ozone Combined with UV

Fenton氧化处理甲基橙染料模拟废水的动力学研究

Kinetic study on the degradation of methyl orange by Fenton oxidation

氧化处理对C（3D）/MCN复合材料摩擦磨损性能的影响

Effect of oxidization on friction and wear properties of c_ ( 3d ) / mcn Composites

响应面法优化湿式氧化处理阳离子红X-GRL废水

Optimization of wet air oxidation of cationic red X-GRL wastewater by response surface methodology

XPS研究多壁碳纳米管的阳极氧化处理效果

XPS study on MWNTs surface treated by anodic oxidation

此系列LED用于室内室外照明，灯体采用高质量铝材，表面阳极氧化处理。

This series LED is used for indoor and outdoor lighting , the light body using high quality aluminum , surface anodic oxidation process .

采用纳米级TiO2悬浮法光催化氧化处理直接耐晒翠蓝染料溶液，讨论了pH值、催化剂用量、染料浓度、脱色时间等因素对脱色与降解的影响。

Suspension method is adopted in the photocatalytic oxidation treatment of light fast direct turquoise blue solution with nanometer titanium dioxide .

有机废水的TiO2光催化氧化处理技术浅析

A Brief Analysis on the TiO2 Optic Catalysis and Oxidation Treatment of Organic Wastewater

HRT对悬挂链曝气式接触氧化处理污染河水的影响

Effect of HRT on contact oxidation of suspend chain floating aeration treating polluted river

负载型TiO2固定相光催化氧化处理城市污水的试验研究

An Experimental Research on the Treatment of City Waste Water with Immobilized TiO_2 Fixed Phase Photocatalytic Oxidation

常压湿法氧化处理TNT红水的初步研究

Preliminary Study on the Treatment of TNT Redwater by Wet Peroxide Oxidation under Normal Pressure

通过实验优化了Fenton试剂法氧化处理含乌洛托品废水的反应条件。

The reaction condition has been optimized through experiments for the oxidation of wastewater containing urotropine by Fenton reagent .

本硕士学位论文主要就染料类有机污染物在活性炭纤维（Activatedcarbonfiber，ACF）电极上的吸附及高级氧化处理进行了研究。

The absorption and advanced oxidation processes ( AOPs ) treatment of dye , one of the organic pollutants , using activated carbon fiber ( ACF ) electrode were reported in this thesis .

方法采用SDS-PAGE和免疫印迹分析呕吐物的免疫反应性，过碘酸钠氧化处理以鉴定呕吐物的抗原决定簇的性质。

Methods The antigenicity of vomitus was analysed using SDS-PAGE and immunoblotting . Epitopes of specific antigens were identified through oxidation with sodium periodate .

用高纯氮气体做介质对Cu-0.75%Al粉末烧结合金进行内氧化处理，用X-ray衍射、SEM和TEM等分析技术对其进行研究。

Internal oxidation treatment were carried out in an internal oxidizing apparatus for a Cu-0.75 % Al powder sintering alloy , and microstructure were investigated by means of SEM , TEM and X-ray .

UV-H2O2氧化处理饮用水中DMP效果及其降解动力学

Oxidation Performance and Kinetic Model of DMP in Drinking Water by Combination Process of UV-H_2O_2

对市售煤质AC进行液相氧化处理和热处理，可以改变活性炭表面官能团的含量，提高活性炭的离子交换能力。

An oxidization processing in the oxidizing liquid reagents subsequent to heattreatment on the commercial AC changed the content of oxygen functional groups onthe surface of ACs and enhanced the ion exchange capacity of ACs .

针对酸性玫瑰红印染废水的高色度、难以生物降解的特点，采用O3和Fenton试剂进行氧化处理，通过实验确定了最佳运行参数。

Acid rose red dye wastewater is deeply colored and hardly to be bio-degradable . Chemical oxidation by Fenton and O3 was applied .

用FTIR、DSC法对熔体和固相热氧化处理聚苯硫醚的链结构差异及其对结晶度、结晶与熔化行为的影响进行了研究。

The molecular structure of thermal oxidative polyphenylene sulfide both in the molten and solid state and its effect on crystallinity , crystallization and melting behavior were studied by using FTIR and DSC .

吸附-微波催化氧化处理流动态葡萄酒生产废水工艺研究中，考察了废水流量、微波功率、pH以及双氧水用量对废水COD去除率的影响。

Microwave catalytic oxidation combined with absorption was studied for treating wine distillery wastewater . The factors of wastewater flux , microwave power , pH , dose of H2O2 , and their effects on wastewater COD remove rate were studied .

结果表明在几种原丝中如含有衣康酸组分，由于其在DSC谱图中表现出较展宽的环化放热峰，因而较适合于实际的氧化处理工艺。

The results show that for several kinds of precursors those containing units of itaconic acid possess a rather wide cyclization exothermic peak in the DSC thermogram and thus are favorably suitable for the practical oxidation process .

实验研究了LiNbO3∶Ru晶体二波混频条件下光栅记录特性和波长的依赖关系；并且研究了氧化处理对其透射谱和光栅记录特性的影响。

Dependence of recording characteristics of grating on recording wavelength , as well as effect of oxidation treatment on transmission spectra and recording characteristics , has been investigated in LiNbO_3 ∶ Ru crystal .

考察了活性炭和炭化硅两种材料的吸波能力和微波辅助氧化处理p-硝基酚（PNP）溶液的情况。

Microwave-absorbing ability of granular activated carbon ( GAC ) and silicon carbide ( SiC ), and microwave-assisted oxidation of p-nitrophenol ( PNP ) through the fixed beds of GAC and SiC were investigated .

并对试样进行了氧化处理，进一步探索了涡流测量粘结层中热生长氧化物（TGO）厚度变化的可行性。

After the sample was oxidized , researched the feasibility that measure the thickness change of thermal growth oxidation ( TGO ) in bond coat with eddy-current method .

皮革废水经物化和普通接触氧化处理后往往因为氨氮高而难以达标排放，本文探讨了采用曝气生物滤池（BAF）进一步降解经物化和普通接触氧化后出水中氨氮污染物的可行性及处理效果。

In this paper , effluent ammonium of tannery waste can not reach the discharge standard after secondary treatments , its biodegradation possibility and effect of removal by biological aerated filters ( BAF ) were discussed .

以Cu2O为氧源，对Cu-Al合金平板试样进行了内氧化处理，使试样表面获得A12O3弥散强化铜合金层，并进行了不同变形量的冷轧变形；

The Cu-Al alloy plate was firstly treated by internal oxidation with Cu2O as oxidizer , and got a dispersion-strengthened Al2O3 layer on the plate surface , followed by cold deformation with different rate .

经过K2S2O8的稀硫酸溶液氧化处理的粗制单壁碳纳米管样品，在水、DMF和乙醇等极性溶剂中具有非常好的溶解性。

Raw electric-arc-produced single-walled carbon nanotubes ( SWNTs ) treated by K S O oxidation in dilute sulfuric acid solution have very good solubility in water , DMF , ethanol and other polar solvents .

研究了涂层中碳纤维的含量，碳纤维表面氧化处理方法、碳纤维表面含氧基团的多少，呋喃树脂粘均分子量的大小等与TiB2阴极涂层的抗拉强度、粘结强度等性能的关系。

It was explored that the effect of carbon fiber content , surface oxidation treatment of carbon fiber , amount of oxygen radical on carbon fiber surface , and viscosity molecular weight on Tensile Strength and bond strength .

采用恒流电沉积及氧化处理制备Fe3O4先驱体薄膜，再通过400℃下的热硫化退火，使Fe3O4先驱体薄膜在不同硫压下转变成为多晶FeS2薄膜。

The precursive Fe_3O_4 films were sulfurized using constant current electrodepositing and oxidation treating , and Fe_3O_4 films was transformed into FeS_2 thin films after heat sulfur annealing of 400 ℃ at different sulfurizing pressures .

关于抽真空整体铝模的改进①先后经过热处理、微弧氧化处理的ZL101具有优异的综合力学性能，满足作为模具对其力学性能的要求。

Improvement on Vacuum Supply to Complete Aluminum Mold In this experiment the conclusions given hereinafter are obtained : ① Aluminum mold coated with MAO layer has sufficient mechanics performance to satisfy the requirement of being as amold .