设计规范

为了简化这一过程，几乎涵盖所有的最终使用要求的7种不同应力组合，列在2005年国家木结构设计规范（2005NationalDesignSpecificationforWoodConstruction）中。

To simplify the process , seven different stress combinations covering virtually any end-use requirement are tabulated in the2005 National Design Specification for Wood Construction .

表面模型及操作算子技术是实现新一代GPS标准中几何产品功能规范、设计规范及认证规范数字化统一的基础。

Surface model and operator technologies are the foundation for realizing digitized unity of geometrical product function specification , design specification and verification specification .

台湾第一部钢骨钢筋混凝土构造（SRC）设计规范之设计理念与重点内容

The First Taiwan Building Code for Design of Steel Reinforced Concrete ( SRC ) Structures

文中指出，现行抗震设计规范（TJ11&78）所建议的结构影响系数C，没有考虑地震烈度的影响，这是有缺点的。

It is pointed out that the structural effect coefficient C , proposed in the current aseismic design code ( TJ 11-78 ), has the disadvantage of neglecting the effect of seismic intensity .

在设计规范的基础上，利用MATLAB6.5的GUI设计平台完成用于EDFA模拟的模拟器。

Based on the design pattern , we use MATLAB GUI tool to implement the EDFA 's simulator .

最后利用面向Agent的程序设计规范，实现了该设计方案，在模拟环境中实现了一个原型系统，证明了该模型的可行性以及在灵活性和容错性，网络拓扑适应性等方面具有的优势。

Finally , we obey the Agent-Oriented program design standards to implement the prototype model , the model is feasible and has the superiority in the aspects of robustness , flexibility and adaptability .

根据公司和业界IP设计规范和流程实现了AHB总线控制器的IP化。

According to the company and the industry IP design specifications and processes to achieve the AHB bus controller of the IP .

我们把按此法进行描述的设计规范叫作FDP程序。

The design specification described by this me - thod is called FDP program .

根据IEC设计规范，设计了电压波动和闪变检测的各环节。

In this paper , the stages of the voltage fluctuation and flicker are designed based on IEC specification .

参照国内储罐抗震设计规范，针对某大型LNG储罐作地震响应的实例分析。

This paper makes seismic response analysis for a large LNG storage tank , referring to the domestic storage tank design regulations .

在国内目前无相应设计规范的情况下，探讨了LNG汽车加气站的选址、安全间距。

In the absence of the corresponding domestic design code , the site selection and safety distance of LNG vehicle fueling station are discussed .

研究Android设计规范后，对应用分版块进行交互设计，详细设计界面布局与交互流程。

Through studying the Android design specification , do the interaction design for the application sections , which detailed in the interface layout and interaction processes .

本文在DVD标准的基础上，定义RS-PC译码器设计规范；

Based on the DVD specifications , the RS-PC decoder chip specification is defined .

结合一座PC连续刚构桥的徐变分析，对中国《公路钢筋混凝土及预应力混凝土桥涵设计规范》徐变系数的计算和应用进行分析探讨。

In association with structural creep analysis of a PC continuous frame bridge , several aspects on calculation and application of the creep coefficient introduced in China standard of highway PC bridge are analysed .

得出的鉴定等级安全性与设计规范的安全性是一致的，实现了民用结构RC构件鉴定的定量计算。

The appraised safety degrees are consistent with the calculating results using design codes , and the quantitative calculation for safety degrees of civil structural elements can be implemented .

通过对国内外船用柴油机电控系统发展与现状的调查，根据相关船舶设备设计规范要求，提出了MDECS（MarineDieselElectronicControlSystem）设计概念。

Refer to domestic and international marine diesel engine electronic control system development and status of the investigation , according to the relevant marine equipment design specifications , proposed MDECS ( Marine Diesel Electronic Control System ) design concept .

基于《建筑抗震设计规范》（GB50011-2001），设计了三个X型中心支撑钢框架，采用pushover方法，得出了其结构影响系数。

Based on Code for Seismic Design of Building ( GB50011 ), the paper designs three concentrically X-braced steel frames and their structural coefficients are obtained by Push-over analysis .

为了统一国际上闪变测试方法与评价标准，国际电工委员会（IEC）制定了闪变仪的测试功能和设计规范。

For the sake of unifying the international test method and estimation standard of flicker , the IEC established the test function and design criterion of flicker meter .

从设计规范与管材选用方面对电阻焊碳钢直缝钢管（ERW）的特点进行了分析。

The features of electric resistance welded ( ERW ) carbon steel pipe are analyzed from the viewpoint of design code and material selection .

本文针对可信计算平台模块（TPM）的设计规范，设计了一款针对TPM应用的单向散列函数消息验证码生成模块（HMAC/SHA-1IP），并进行了预综合和FPGA验证。

This article mainly presents an Hash Message Authentication Code ( HMAC / SHA-1 ) IP core based on the Trusted Platform Module ( TPM ) architecture with pre-layout synthesis and FPGA verification .

可用《混凝土结构设计规范》（GB50010-2002）的公式估计其裂缝宽度，安全性高。

The formula in Code for design of concrete structures ( GB50010-2002 ) can used to estimate the width of crack .

由于现有《公路路基设计规范》对20m以上的路堤的边坡形式和坡度没有明确规定。

Because the side slope form and slope of the embankment above to 20m of the existing " road bed design specification of the highway " do not have clear regulation .

基于国家标准《建筑抗震设计规范》（GB50011-2001）对底部两层框架砌体结构房屋进行抗震设计分析。

Based on code for seismic design of buildings ( GB50011-2001 ), the analysis of anti-seismic design on double-frame of bottom building structure is made .

软件通信体系结构（SCA）提供了一种标准、开放、可互操作无线电通信软件平台，是联合战术无线电系统（JTRS）的顶层设计规范。

Software communications architecture ( SCA ) provides a standard , open and inter-operational wireless telecommunication platform , and is a top level design specification of joint tactical radio system ( JTRS ) .

计算表明，试件N1的试验值与《钢结构设计规范》（GB50017&2003）公式承载力计算结果的比值为0.73，与有限元计算结果的比值为1.11；

The calculation shows that the ratio of the test value of load-carrying capacity of model N1 to the result obtained from code design formulae is 0.73 , and to the finite-element analysis is 1.11 ;

参照美国API650和日本JISB8501设计规范制订了4种结构设计方案，计算得到各方案中壁板应力与底板应力大小，并进行相互比较。

Four different structural design proposals were made according to design criterions of API 650 and JIS B 8501 , in each proposals stress calculations were done and the results were compared .

随着《建筑抗震设计规范》（GB50011-2001）的颁布与实施，新旧抗震规范的主要差别及新规范对各类结构抗震设计所带来的实际影响倍受关注。

With the publication and application of new Code for Seismic Design for Buildings ( GB50011-2001 ), the difference and influence between the old and the new Code are more and more attended .

同时，对我国新的《水工建筑物抗震设计规范》（DL5073-1997）及其应用作了简要介绍。

Simultaneously , the new 《 Antiseismic Design Norm for Hydraulic Structure 》 in China ( DL5073-1997 ) and its application are briefly introduced .

指出了MBR进一步研究的领域：膜污染的机理和防治，与其他处理工艺的结合和改进，特殊废水的处理研究，设计规范和操作参数的确定，数学模式的研究等。

It is pointed out that the fields deserving further research include the mechanism and control of membrane fouling , the combination with other treatment technology , the treatment for special waste wa-ter , the establishment of design norm and operation parameters , model for MBR , et al .

结合建筑结构设计规范和建筑平法图集（03G101），提出三段工程量计算模型；

Based on current building structure code and standard drawings ( 03G101 ), it is presented a three-part model to calculate the volume of beam .