傅里叶红外光谱仪

  • 网络ftir;FTIRS;ALPHA FT-IR
傅里叶红外光谱仪傅里叶红外光谱仪
  1. 并利用傅里叶红外光谱仪(FT&IR)和差示扫描量热仪(DSC)对聚合物的结构和性能进行了研究。

    The polymer structure and property were studied by means of FT-IR and DSC .

  2. 研究了乳化剂配比、功能性单体、引发剂体系对乳液和涂膜的影响,并用傅里叶红外光谱仪(FT-IR)对乳液组成进行表征。

    The influence of emulsifier composition , functional monomers and initiator system on the properties of emulsion and the coatings film is discussed . The emulsion composition is characterized by use of FT-IR .

  3. 采用溶胶&凝胶工艺在常压下制备了SiO2气凝胶薄膜,并用傅里叶红外光谱仪(FTIR)、扫描电子显微镜(SEM)、椭偏光谱仪等表征了薄膜的结构和性能。

    Silica aerogel thin films were prepared at ambient pressure by sol gel technique . Fourier transform infrared spectroscope ( FTIR ), scan electron microscope ( SEM ) and ellipsometer were used to characterize the structure and properties of the films .

  4. 设计了流动气体法实验装置,针对故障诊断中最重要的C2H2,用傅里叶红外光谱仪采集了吸收谱;

    Experiments on the " flow gas method " have been designed . And the FTIR spectrometer is used to collect the infrared spectra of C2 H2 , which is the most important gas for transformer fault diagnosis .

  5. 用傅里叶红外光谱仪,在选定的波数范围内,采用化学计量学法测量乙烯裂解汽油的二烯值。

    Combined with stoichiometric method , the diene value in cracking gasoline was determined by Fourier Transform Infrared Spectroscopy at selected wavenumber region .

  6. 使用傅里叶红外光谱仪、热失重仪、差示扫描量热仪表征它们的结构与性能。

    Fourier IR spectra , Differential scanning calorimetry and Thermal gravimetric analyzer were used to characterize the structure and performance of the polymer .

  7. 本文主要完成了以下几方面的创新性研究工作:1.研制基于傅里叶红外光谱仪的材料光谱发射率测量装置。

    The finished research works are as follows : 1 . A new measurement equipment has been researched based on the Fourier transform spectrometer .

  8. 利用稳态量热计法和傅里叶红外光谱仪分别测定了C/SiC复合材料在90℃时的半球向总发射率和室温法向光谱反射率。

    The total hemisphere emissivity at 90 ℃ and the normal spectral reflectance at room temperature of C / SiC composites were measured by using steady-state calorimeter method and Fourier infrared spectrometer ( FTIR ) respectively .

  9. 所得PANI/GNS复合物用扫描电镜、透射电镜、傅里叶红外光谱仪、X-射线光电子能谱仪、热重分析仪、四探针电阻仪和电化学工作站进行了表征。

    The resulting PANI / GNS composites were characterized by using scanning electron microscopy , transmission electron microscopy , Fourier transform infrared spectroscopy , X-ray photoelectron spectroscopy , thermogravimetry , as well as electrical conductivity and electrochemical methods .

  10. 通过傅里叶红外光谱仪、差热分析仪、拉曼光谱等对玻璃固化体结构进行表征,以电感耦合等离子体质谱测试玻璃固化体的抗浸出性能。

    Fourier transform infrared spectroscopy ( FTIR ), differential thermal analysis ( DTA ), Raman spectroscopy were used to characterize the glass structure . The leaching resistance property of glass was tested by inductively coupled plasma mass spectrometry ( ICP-MS ) .

  11. 因此,本文在国家自然科学基金和航天材料与工艺研究所的资金支持下,在建立基于傅里叶红外光谱仪的光谱发射率测量装置的基础上,对光谱发射率测量技术进行深入的研究。

    The research comes from the project of National Natural Science Foundation of China and Aerospace Research Institute of Materials & Processing Technology . The purpose of this project is to research the spectrum emissivity according the measurement equipment based on Fourier transform spectrometer .

  12. 实验采用透射电子显微镜、原子力显微镜、扫描电子显微镜、傅里叶红外光谱仪等仪器,对纳米材料与传感器的形貌进行表征,利用交流阻抗、循环伏安法对传感器修饰过程进行表征。

    The nano-materials and biosensors were characterized by transmission electron microscopy ( TEM ), scanning electron microscope ( SEM ), atomic force microscope ( AFM ) and Fourier transform infrared spectrometer ( FTIR ) on morphology . And the sensor modification process was characterized with impedance and cyclic voltammetry .

  13. 利用傅里叶变换红外光谱仪(FTIR)和~(13)C核磁共振仪对聚合物的结构进行了研究。

    The structure of the polymer was studied with FTIR and 13C NMR .

  14. 用傅里叶变换红外光谱仪,研究CNX薄膜中C和N的键合情况。

    The study of carbon nitrogen bonds in the CNx film by FTIR .

  15. 表面化学修饰由傅里叶变换红外光谱仪(FTIR)进行确定;

    The surface chemical modification was confirmed by the FTIR spectroscopy studies .

  16. 使用傅里叶变换红外光谱仪,原位跟踪了催化及未催化聚氨酯弹性体(PU)的固化反应动力学行为。

    The kinetics of curing reaction of polyurethane elastomers was analysed by in-situ quantitive FTIR .

  17. 方法用HPLC测定芍药苷含量,傅里叶变换红外光谱仪分析FTIR光谱。

    METHODS The PF content was detected by HPLC and FTIR spectra was analyzed with Fourier transform infrared spectrometer .

  18. 用实时傅里叶变换红外光谱仪(FTIR)对乙烯基硅橡胶和含氢硅油的加成聚合过程进行了表征,得到了基团浓度消耗比随反应时间变化的曲线。

    By using real time FTIR , the additive polymerization process of hydrogen silicone with vinyl silicone rubber was monitored in - situ .

  19. 傅立叶红外光谱(ATR)法检验纺织纤维傅里叶变换红外光谱仪

    Identification of Textile Fibers by Level Attenuated Total Reflectance FT-IR Spectroscopy ( ATR ); Fourier transform infrared spectrometer

  20. 本研究利用傅里叶变换红外光谱仪,在中红外至远红外范围测量了GaAs、InP的红外反射光谱,在测量范围内均观察到两个反射极小值。

    Infrared reflectance spectra of n-type InP , GaAs are measured from middle to far infrared regions using a FT-IR spectrometer . Two reflective minima are observed .

  21. 从用傅里叶变换红外光谱仪(FTIR)测量室内高温气体的红外发射光谱出发,对气体辐射源的几何参数进行了优化设计。

    Starting from the infrared emission spectra of the indoor high-temperature gas measured by Fourier-transform infra-red ( FTIR ) spectrometer , the geometric parameters of the gas radiation source were optimized .

  22. 由X射线光电子能谱、傅里叶变换红外光谱仪、X射线衍射、扫描电镜等多种分析测试方法分析了磁性复合物的结构和形态。

    The structure and morphology of the magnetic composites have been characterized by X-ray diffraction ( XRD ), scanning electron microscope ( SEM ), X-ray photoelectron spectroscopy ( XPS ), Fourier transform infrared ( FT-IR ), and Raman spectra .

  23. 利用X射线光电子能谱、X射线衍射和傅里叶变换红外光谱仪检测了载银壳聚糖-羟基磷灰石支架的成分。

    The chitosan / nano-hydroxyapatite scaffold was immersed into silver nitrate solution with different concentration . X-ray photoelectron spectroscopy ( XPS ) measurement , XRD and FTIR spectroscopy were carried out to analyze the composition of the CnHS that is undergone ion-substitution process .

  24. 辐照后的样品用傅里叶变换红外光谱仪进行系统分析。实验结果显示,高能离子辐照在注碳非晶SiO2薄膜中形成了大量的Si-O-C键和Si-C键。

    The obtained results showed that a large amount of Si-O-C and Si-C bonds was formed in the heavy ion irradiated C-doped amorphous SiO2 films .

  25. 首次采用傅里叶变换红外光谱仪(FTIR)及镜面反射附件,对天然宝石材料&黄玉在反应堆辐照致色(成为蓝色)前后的样品进行了近、中红外区的光谱分析,并使用FTRaman光谱进行补充。

    In this paper , the natural gem material & Topaz ( colorless transparent samples and reactor irradiation induced blue color samples ) was studied on the spectroscopic analysis of Fourier transformation infrared spectrum ( FTIR ) and FT Raman spectrum .

  26. 本文用170SX傅里叶变换红外光谱仪,根据K-K关系的积分形式,分析了SiO2的光学常数,得到比较满意的结果。

    The optical constants of SiO_2 are analysed according to the K-K relation in integral form by means of 170 SX-FT-IR Fourier transform infrared spectrometer . The results are satisfactory .

  27. 利用化学分析光电子能谱仪(ESCA)、傅里叶转换红外光谱仪(FTIR)和扫描电子显微镜(SEM),研究了纸在阳光暴露或人造紫外光辐射时其表面性质的变化。

    Electron Spectroscopy for Chemical Analysis ( ESCA ), Fourier Transform-InfraRed Spectroscopy ( FTIR ) and Scanning Electron Microscope ( SEM ) were used to observe the changes in surface characteristics of papers which were exposed under sunlight or artificial ultraviolet light .

  28. 我们首先利用电子顺磁共振波普仪、差热分析、X射线粉晶衍射、傅里叶红外变换光谱仪、透射电镜、XRF等仪器分析手段对矿物原料中铁、钛的赋存状态进行了具体分析与研究。

    Firstly , we make a concrete analysis and research on the occurances of iron and titanium in mineral materials by using instrumental analysis methods such as electron paramagnetic resonance spectrometer , differential thermal analysis , X-ray powder diffraction , fourier transform infrared spectrometer , transmission electron microscopy , XRF .

  29. 傅里叶变换红外光谱仪在烟幕测试中的应用

    The Application of Fourier Transform Infrared Spectrometer to the Smoke Determination

  30. 傅里叶变换红外光谱仪傅立叶变换红外光谱法测定黄姜中皂素含量

    Determination of Saponin in D.Zingiberensis Wright by Fourier Transform Infrared Spectrometry