spinneret

An automatic inspection system was presented according to the characteristics of the circular spinneret .

根据圆形喷丝板的特点，设计了喷丝板自动检测系统。

Self-Correcting Position Control System by Machine Vision in Spinneret 's Auto Inspection

喷丝板自动检测中基于机器视觉的自动纠偏

A study on feature based modeling method of spinneret

一种基于特征的纺丝元件建模方法研究

Design of Spinneret Used for Preparation of Yarn with Different Shrinkage

同板异收缩纤维用喷丝板的设计

A new spinneret combined a gas jet orifice was designed .

主要改进是在标准静电纺丝机的喷丝头上增加了气流喷射系统。对喷丝头重新设计。

Structure and properties of polyester blended yarn produced by one spinneret

同板涤纶混纤丝结构与性能的研究

Study on flat fiber formation ⅱ . Spinneret design and development of flat PET fiber

扁平纤维纺丝成形研究Ⅱ.扁平PET纤维喷丝板的设计及产品开发

A spinneret is the critical part which influences the yarn formation directly .

化纤喷丝板是直接影响纺丝成型的关键零件。

The experimental process and results verify the spinneret and spinning pack design is reasonable .

根据实验过程和结果，验证喷丝板和纺丝组件设计的合理性。

The structures and properties of the blended yarn made by one spinneret are studied .

研究了同板多异涤纶混纤纱的结构和性能。

The dimension of shaped spinneret was designed and calculated by equivalent diameter analysis .

采用当量直径法对异形喷丝板的尺寸进行设计、计算。

Discussion on spin process for round hollow fibers with spinneret of 250 holes

用250孔板纺圆中空纤维的生产技术

Many tiny tubes connect each silk gland with a spinneret .

许多极细小的导管把每个造丝腺体与吐丝器相连。

Mechanics designing of spinneret orifice clearance space for hollow fiber

中空纤维喷丝孔开口间隙机械设计

Deviation auto-rectifying system of spinneret based on double CCD camera

采用双CCD的喷丝板自动纠偏系统

Recovery of monomer smoke at strand spinneret from nylon 6 production

尼龙6生产中注带处单体烟的回收

Study on forming technology of bright polyester FDY extruded from spinneret slit

有光涤纶FDY狭缝挤出成型生产技术研究

Discussion on Wiping Spinneret Period of PET Filament Production

涤纶长丝生产中铲板周期的优化探讨

Development of Electrochemical Process of Tantalum Spinneret

钽喷丝头电化学处理工艺研究

Study on surface modification of tantalum spinneret

钽喷丝头表面改性技术的研究

Study on the spinning of hollow fiber RO membrane with irregular shaped porous spinneret

异型板纺制中空纤维反渗透膜

Effect of diameter of spinneret hole on diameter and birefringence of PET filament

喷丝孔孔径对涤纶单丝直径与双折射的影响

And also effect of spinneret draw-ratio on fibre aggregated structure and the properties was discussed .

分析喷丝头拉伸比对纤维的聚集态结构及性能的影响。

Her next step was to run it through the spinneret , a machine that would produce the fibers .

下一步就是用能够产生纤维的吐丝器对它进行处理。

PET POY with different linear density and orientation can be produced with the same spinneret .

利用具有不同孔径的同一喷丝板生产不同线密度和取向度的涤纶POY。

Spinneret selected for spinning 0.56 dtex fine denier PET staple fiber

纺制0.56dtex涤纶短纤维的喷丝板选用

As the distance from the spinneret increases , T decreases and approaches to the room temperature quickly .

随着与喷丝板距离的加大，T＊迅速下降并趋近于室温，即相当于吸进冷风。

Usually the number of holes in the spinneret determines the number of filament in the yarn .

一般喷丝头细孔的数量决定了纱中长丝的根数。

The tantalum spinneret is a key part in chemical fibre silk spinning_machine .

喷丝头是化纤纺织机上的关键部件。

The practical experiments showed that fiber spinnability was optimized when spinneret negative draw ratio was - 73 % .

工业化试验表明：当喷丝头负拉伸率为-73%时，纤维可纺性达到最佳状态。