hot water temperature

Simplified formula of hot water temperature adjustment and analysis of its ' errors

热水水温调节公式的简化及误差分析

Also , in the defrosting process , the hot water temperature fluctuates was within 5 ℃ .

除霜过程中系统供热水温度波动在5℃以内。

Fourth , if the required hot water temperature is 55 ℃, the hot recovery system can withdraw a little amount condensation heat rejection ;

在保证要求提供热水温度（例如为55℃）的前提下，热回收系统只能提取到少量的冷凝热。

The hot water temperature , calcinations temperature , holding time on Y2O3 : Eu3 + nano powder which , microscopic structure and the effect on the properties of light .

研究了水热温度、灼烧温度、保温时间对Y2O3：Eu3+纳米粉体物相、显微结构和发光性能的影响。

It is 45 ~ 53 ℃ for the hot water temperature of the layer hot store . Its hot water can be used for presenting warm , medical treatment and hothouse aquiculture .

热储层地热水温度为45~53℃，通过资料分析表明，其热水可用于地热取暖、洗浴、医疗保健及温室养殖等。

All models the same size , length , width and height of different sizes . Used for simulation analysis on the inlet temperature and entry speed to the cold , hot water temperature stratification and the thermal efficiency of the regenerative effect .

所有模型体积相同，长、宽、高的尺寸不同，用于模拟分析入口温度和入口速度对于冷、热水温度分层和蓄热效率的影响。

This paper simulates the change of the hot water temperature and the instantaneous power of the assistant heater of the solar air-conditioning system in a day and after that the COP and FNP of the solar air-conditioning system are also achieved .

模拟了太阳能制冷及供暖综合系统热水系统一天的水温变化、辅助热源逐时变化，并在此基础上给出了太阳能空调系统制冷性能系数COP和供暖性能系数FNP值。

The optimal operating condition of series-wound thermosyphons is the evaporative length of 120 mm , inclination angle of 30 °~ 40 °, hot water temperature of 60 ℃, flow rate of 0.3m ~ 3 / h , and series-wound type of D.

串联热管在倾角为30°~40°、热水温度为60℃、热水流量为0.3m3/h、蒸发段长度为120mm、D型串联的条件下运行最佳。

The main problems to be solved with LiBr absorption chillers for solar energy air-conditioning are to raise their own performance properties and to decrease their manufacture costs , besides the cycle modification suitable for currently realizable hot water temperature at the inlet of the solar energy collectors .

溴化锂吸收式制冷循环用于太阳能空调需要解决的主要问题是循环系统要适合集热器所能提供的热水温度范围，和提高溴冷机本身性能并降低其制造成本。

It can handle hot water , high temperature and pressure steam , heat transfer fluid , hydrogen gas , ammonia , organic solvents and so on .

能用于热水、高温高压、热的变压器油、氢气、氨水、及有机溶等一些常规材料较难适应的介质与场合。

The indoor experimental device of thermal pipeline leakage is established , it is used to test the changes of soil temperature field around and top of the pipeline before and after leakage , the coupling between hot water flowing and temperature field after leakage is researched . 3 .

建立热力管道泄漏的室内实验装置，用来测试埋地热力管道泄漏前、后管道周围和管道正上方土壤的温度场，研究热力管道泄漏后热水的渗流和温度场的耦合。

Influence of Drinking Hot Water on Changing Oral Temperature in Adult Patients

饮用热水后影响口腔温度的干预研究

Hull skin temperature too low , toward hot water ( contain high temperature water ) shallow buried pipe way .

外表面温度太低，对于热水（含高温水）浅埋管道是可行的。

An auxiliary electric heater should be installed on the hot water pipe when higher temperature hot water is needed .

如需更高温度的热水，可在热水管路上设置辅助加热器加热，以满足要求。

In this paper the microstructures and mechanical properties of specimens of 45 steel were studied during hot water cooling in different temperature .

本文研究了45钢试件在不同温度的水中冷却（即热水处理）后的组纲和性能。

In addition to CIP and hot water preparation , mash temperature rise and wort temperature rise and wort boiling consumed most of heat energy in beer brewing .

啤酒生产过程的热能消耗除CIP和热水制备外，主要耗能集中在醪液升温、麦汁升温以及麦汁煮沸等工段。

The results of optimized experiments that summarized by variance analysis show that the most remarkable factor influencing the tensile strength and elongation is the potato starch density while the most evident factor affecting the instant solute ratio in the hot water is the dry temperature of the film .

正交优化试验结果表明，对膜的抗张强度和断裂伸长率影响最显著的因素是淀粉的浓度，对膜的热水速溶率影响最显著的因素是干燥温度。

The presently used oil / gas fired vacuum hot water boilers can only provide heating or domestic hot water at temperature lower than 100 ℃ .

目前使用的一般燃油（气）真空锅炉仅能提供100℃以下的供暖或卫生热水，以溴化锂水溶液为工质的新型真空锅炉，可同时供暖、供生活热水及部分低压蒸汽。