clearance fit

In rolling piston compressors , clearance fit is adopted between rotor and cylinder . Its leakage passages are pressurized by oil films .

在转子压缩机内转子和气缸之间采用间隙配合，其泄漏通道通过油膜来密封的。

Also it has , with the method of 3D FEA , through use clearance fit in the higher load hole and interference fit in the lower load hole to proportion load distribution .

采用三维有限元法，利用在大载荷孔上使用间隙配合、在小载荷孔上施加干涉配合的方法，使各钉载荷分配均匀化。

The influence of thermal deformation on clearance fit and interference fit are discussed . A new tolerance design method that compensates thermal deformation is presented .

本文重点分析热变形对孔、轴类配合的影响，提出了通过修正公差设计补偿热变形误差的理论方法和具体措施，为全面提出热公差配合理论奠定了良好的基础；

Can counterclockwise unscrewing the grip the lock nut and adjust control again , until the nut spin twist clearance fit .

可以逆时针拧松握把根部的锁紧螺母，再左右旋拧调整螺母，直到间隙合适为止。

The programming button ( 1 ) is positioned in the button hole ( 2 ), and is in clearance fit with the button hole ( 2 );

所述编程按钮（1）位于按钮孔（2）中，并与按钮孔（2）间隙配合；

This chapter introduces a way by which interference fit or clearance fit probability needed in transition fit can be exactly designed , when selecting transition fit and applying probability statistic theory .

介绍设计过程中选用过渡配合时，应用概率统计理论，精确设计过渡配合中需要出现过盈、间隙配合概率的方法。

The relation between the outer diameter of free upsetting blank and the inner diameter of cold extrusion die can be comprehended as clearance fit , to confirm the basic tolerance and tolerance band of the blank .

将自由镦粗毛坯外径与冷挤压凹模的关系理解为间隙配合，确定了毛坯的基本偏差和公差带。

Among refrigerant leakages are caused by clearance fit in rolling piston compressors , the maximal amount of leakage is occurred in the radial clearance , which is mainly processed by the mode that the refrigerant dissolves into the lubricant .

在滚动转子式压缩机内由于间隙配合造成的制冷剂泄漏中，转子径向间隙的泄漏量最大，它主要是以溶于润滑油的形式泄漏的。

With the analysis of clearance fit between piston and cylinder lin-er and the measurement of static deformation of engine block and cylinder liner , an improvement was proposed to strengthen the rigidity of 490 engine block in or-der to eliminate the early scuffing of cylinder bore .

本文针对490型柴油机出现的早期拉缸现象，通过对活塞与气缸套配合间隙的分析试验及对机体、缸套静变形的测量分析，着重提出了加强机体刚度的改进措施。

The laws of Change in Material Strength of Structural Parts and Change in Clearance of Shrink Fit of The Shaft-through for The Explosion-proof Motor used in Low Temperature Ambience

低温防爆电动机结构件材质强度及轴贯通配合间隙冷缩变规律