axiality

  • n.同轴度;轴对称性;轴对称的状态
axialityaxiality
  1. A New Non-contact Method for Measuring Axiality Error of Large Parts

    大型机械工件高精度同轴度误差测量的新方法

  2. A New Structure by Hole to Ensure Part 's Axiality

    以孔定位保证工件同轴度的新型结构

  3. Research on a new type instrument of axiality measuring

    一种新型同轴度测量仪的研究

  4. The Method of Applying Inductive Comparative Scale to Test the Axiality between Pump and Motor Shafts

    电感比较仪测量泵轴与电机轴同轴度的方法

  5. A discussion of the axiality gauge design

    同轴度综合量规设计探讨

  6. Measurer Study for Axiality Measuring of Compressor Cylinder

    压缩机气缸同轴度测量仪的研制

  7. The Relation , Substitution and Implement of Radial Run-out Tolerance and Axiality Tolerance

    径向跳动公差与同轴度公差的关系、取代及实施

  8. The rabbet for install the outer must be H7 tolerance , ensure a high axiality .

    工件机壁孔之公差必须为H7,保证内外环较高同轴度。

  9. This article introduces relation , substitution and implement of radial run-out tolerance and axiality tolerance with legend and production process .

    结合图例和生产工艺论述了径向跳动公差与同轴度公差的关系、取代及工艺实施。

  10. Introduces test method of axiality between pump mounted inside the pump collar and motor shaft , micro-adjusting mechanism of test and analyzes the test error .

    介绍了安装在泵套内的油泵轴和电机轴之间同轴度的测量方法和测量装置的微调机构并对测量误差进行了分析。

  11. What 's more , machining first small holes and then taking the machined small holes as the guide when machining large holes can ensure a good axiality .

    另外,先加工小孔,加工大孔时再以小孔作导向,能保证良好的同轴度。

  12. Objective To study the location of rectus pulleys in high myopia by dynamic MRI and the etiopathogenisis of dyskinetic ocular movement of axiality high myopia .

    目的用MRI研究轴性高度近视眼4条直肌pulley的功能位置,探讨轴性高度近视继发性眼球运动障碍的病因。

  13. In the light of the axiality deviation and the parallelism error existing in mounting the lifting system , this paper recommended the mounting technology and the technology equipment of the two cylinders and direct jack-up type lifting system .

    针对自卸车举升机构安装存在同轴度和平行度偏差的问题,介绍了两缸直推式举升机构的装配工艺及工装。

  14. A new non-contact method for measuring axiality error of large parts is presented in the paper , which the operating principle is discussed that standard wire is used as measuring basis and special measuring installation and capacitance micrometer are utilized .

    本文介绍一种以标准钢丝作基准,借助于专用检具和电容测微仪,以非接触方法对大型机械工作进行同轴度误差测量的新方法。