V-belts

美 [viː belts]英 [viː belts]
  • 网络V带;三角皮带
V-beltsV-belts
  1. Special design of the rear bearing allows for exchange V-belts without the necessary of removing the spindle .

    由于后轴承的设计特别,更换三角皮带,无需取下主轴。

  2. Determination of design power of wide V-belts stepless variable speed mechanism

    宽V带无级变速器的设计功率的确定

  3. An Investigation in the Fatigue Life Test of V-Belts

    传动V带强化疲劳寿命试验的探讨

  4. V-belts & Tensile strength and elongation test method

    GB/T3686-1998V带拉伸强度和伸长率试验方法

  5. A new type complex V-belt was proposed , considering deficiencies of the existing V-belts .

    针对现存各种V带的不足,提出了一种新型结构的复合V带,进行了组合理论及强度计算方法研究,对样品传动滑差性能和寿命进行了的试验。

  6. Fatigue test methods for classical V-belts and narrow V-belts

    GB/T14562-1993普通V带和窄V带疲劳试验方法

  7. In addition , varied dimensions of motocycle variable speed V-belts are available .

    除表中所列产品外,可提供各种规格尺寸的摩托车变速带。

  8. Classical V-belts & Fatigue test ( non-loading method )

    GB/T15328-1994普通V带疲劳试验方法(无扭矩法)

  9. Applications of Joined Narrow V-Belts on Rigs and Pumping Units

    联组窄型V带在钻机和抽油机上的应用

  10. Study on Demestic Technology of Cut-edged V-belts and their Application in Cars

    切边式V带国产化技术研究及其在轿车上的应用

  11. Selection Chart for Regular Quality V-Belts

    普通材质V带传动的胶带选型图

  12. Variable-speed ( half wide ) V-belts for agricultural machinery

    GB/T14829-1993农业机械用变速(半宽)V带

  13. V-and ribbed belt drives Dynamic test to determine pitch zone location Part 1 : V-belts

    GB/T17516.1-1998V带和多楔带传动测定节面位置的动态试验方法第1部分:V带

  14. Classical V-belts for general use

    GB/T1171-1996一般用普通V带

  15. V-belts electrical conductivity characteristic test

    V带静电特性检测

  16. Use of this type of sheave can lengthen durability of the V-belts and increase transmitted power .

    使用这种带轮能延长V带寿命并增加传递的功率。

  17. Belt drives Pulleys for classical and narrow V-belts drives ( system based on datum width ) Geometrical inspection of grooves

    GB/T11356.1-1997带传动普通及窄V带传动用带轮(基准宽度制)槽形检验

  18. Follow-np statistics on site shows that the actual service lives of V-belts are very close to the appraised value by tests .

    经现场跟踪统计,V带实际使用寿命与试验估算寿命十分接近。

  19. Development of Automatical Edger for Measurement of Cut-edged V-belts

    全自动切边V带测量研磨机的研制

  20. Through theoretical analysis following results are reached : this type of sheave structure can make the initial tension of particular V-belts equally distributed and always keep the equal condition .

    通过理论分析得出下述结论:该带轮能实现各带初拉力均匀并始终保持均匀状态。

  21. This may be profiles of tire surfaces and technical products of the rubber industry such as the profile of single or multiple V-belts or toothed belts .

    外形可以是轮胎表面或者橡胶工业的技术产品,比如单层或多层V-形带、齿形带等。

  22. Size-Speed-changers wide V-belts for industry

    GB/T12733-1994工业用变速宽V带尺寸

  23. Ring V-belt is a wide-used product . When V-belts are used in groups together , the difference of the length of each belt will cause the difference of the tension .

    V带成品是无接头的环形,V带成组使用时,由于带长度的差异,每根带所承受的张紧力数值不同。