Tungsten Wire

美 [ˈtʌŋstən ˈwaɪər]英 [ˈtʌŋstən ˈwaɪə(r)]
  • 网络钨丝
Tungsten WireTungsten Wire
  1. Study on In-situ Synthesis WC Between Tungsten Wire and High Carbon Iron

    高碳铁与金属钨丝原位合成WC的研究

  2. Determination method for secondary recrystallization temperature of tungsten wire

    GB/T4106-1983钨丝二次再结晶温度测量方法

  3. The Characteristic and Developing Trend of Shock Resistance Tungsten Wire of our Country

    我国耐震钨丝的特性与发展趋势耐震钨丝特性及应用

  4. A Way of Enhancing the Quality and the Beneficial Result of Tungsten Wire

    提高钨丝质量和经济效益的途径

  5. Discussion on the Development Trend of Tungsten Wire from the Changes of Light Bulbs

    从灯泡发展看钨丝发展趋势

  6. Influence Factors and Improvement of Low-temperature Ductility of Doped Tungsten Wire

    掺杂钨丝低温延性的影响因素及改进措施

  7. Microcomputer Group Control System for Electric Tungsten Wire Drawbench

    钨电拉丝机微机群控系统

  8. Treatment of Tungsten Wire of Surface Ionization Detector

    表面电离探测器钨丝的处理

  9. The filaments of light bulbs are made from tungsten wire .

    灯泡的细丝是由乌丝制成的。

  10. Effect of heating temperture on mechanical properties and recrystallization of doped tungsten wire

    加热温度对掺杂钨丝再结晶组织和性能的影响

  11. Investigation of unusual behaviour in recrystallization of the tungsten wire

    掺杂钨丝再结晶反常行为的研究

  12. Recrystallization structure features of doped tungsten wire

    掺杂钨丝的再结晶组织特征

  13. Effects of Heat Treatment on Mechanical Properties and Microstructure of Tungsten Wire Reinforced Gray Cast Iron Matrix Composites

    热处理对钨丝增强灰铸铁基复合材料力学性能和组织的影响

  14. A tungsten wire electrode with the diameter of five micrometers was prepared by using the method .

    最后,利用此方法制备出直径5μm的钨线电极。

  15. The Development of Aquadag Used on Multi - Die Drawing Machine for Drawing Fine Tungsten Wire

    多模拉丝机拉制细钨丝用石墨乳的研制

  16. Electricity that passed through the thin tungsten wire inside the bulb makes the wire very hot .

    当电流通过电灯泡里的细钨丝时,会使钨丝很热。

  17. Manufacture of ultrathin tungsten wire by electrolyze - polished method

    电解抛光法生产超细钨丝

  18. Recently , the price of raw material increases continually , which brings tungsten wire manufacturers under big cost pressure .

    近年来由于原材料的连续涨价,给钨丝生产企业带来了巨大的成本压力。

  19. The vital part of the incandescent electric lamp is the tungsten wire inside the bulb .

    白炽电灯的关键部分是灯泡里的钨丝。

  20. The paper describes a microcomputer group control system for the electric tungsten wire drawbench and the structures of its hardware and software .

    本文介绍了一个钨电拉丝机微机群控系统及其硬件、软件结构。

  21. Aluminum , chromium , or gold are put into a vacuum tank and heated by a tungsten wire .

    铝、铬或金放在真空罐内用钨丝加热就一下子变成了蒸气,使整个真空罐充满了金属气体。

  22. On the Re-crystallization Properties of Tungsten Wire Used in Manifolder Halogen Lamp by Press Processing

    压力加工过程对复印机卤素灯用钨丝二次再结晶性能的影响

  23. Synthesis and Characterization of MCM-41 Doped with Bimetallic Tin and Zinc THE RECRYSTALLIZATION OF DOPED TUNGSTEN WIRE

    锌锡双金属掺杂MCM-41的合成及表征

  24. And the anode is mad by gild tungsten wire of 0 . 025 mm diameter .

    阳极丝是0.025mm镀金钨丝。

  25. The method of repairing hot-wire probes with a home bare tungsten wire instead of an imported platinum-plated tungsten one

    用国产无镀层钨丝代替进口丝修复热线探头的方法

  26. The Multi-trademarks Technique of Doped Tungsten Wire

    浅谈掺杂钨丝的多牌号技术

  27. The results show that with effective P content at ( 50 ~ 80 )× 10 ~ ( - 6 ), the tungsten wire has good sag resistance .

    结果表明:钨条中有效钾含量在(50~80)×10-6之间时,钨丝具有良好的抗下垂性能;

  28. Suitable electrolyte and equipments for electrolyze - polished technology , ultrathin tungsten wire of 5 ~ 3 are continuously produced .

    经选用合适的电解液配方和电解抛光工艺设备,连续生产出5~3等规格的超细钨灯丝。

  29. The influences of different annealing conditions on recovery and recrystallization of doped tungsten wire were studied . The influencing factor contains annealing atmosphere , temperature and time .

    研究了不同退火工艺对掺杂钨带回复再结晶的影响,包括退火气氛、温度、时间等。

  30. The preparation , characteristic and development of shock resistant tungsten wire , nano tungsten alloy , tungsten electrode , and tungsten-base composite were also introduced .

    并对当前研究较多的钨合金材料,主要是耐震钨丝、纳米钨合金、钨电极材料、钨基复合材料等的制备工艺、合金性能及应用开发现状进行了阐述。