首页 / 词典 / good

Oximeter

  • 网络血氧计;血氧仪;血氧定量计;脉搏血氧定量计
OximeterOximeter
  1. Compare oximeter pulse rate with client 's radial pulse .

    对比血氧计脉率与病人桡动脉搏动。

  2. This paper describes the software and hardware design of an OEM module-based hand - hold pulse oximeter .

    本文介绍采用OEM模块设计的掌上型脉搏血氧仪的软、硬件设计,该仪器具有结构小巧。

  3. Frequency Domain Analysis of Pulse Oximeter Signal of Hypertension patients

    高血压病人的光电容积脉搏波的频域分析

  4. The design of software system of pulse oximeter

    脉搏式血氧饱和度仪的软件系统的研制

  5. Accuracy Analysis of the Tissue Oximeter Using Simulation

    组织氧检测精度的仿真分析

  6. The Principle and Examination of Measure Performance of Pulse Oximeter

    脉搏血氧饱和度监测仪的原理及计量性能检测

  7. The Development of a Wearable Pulse Oximeter Sensor And Study of the Calibration Method

    可穿戴式血氧传感器的设计和定标方法研究

  8. Conclusion Both motion and low perfusion can influence the performance of pulse oximeter .

    结论体动及低灌注可影响SpO2监测值的准确性。

  9. The Study on the Design of Laser Diode Driver in Near Infrared Tissue Oximeter

    近红外生物组织光谱特性测量仪器中半导体激光器驱动方案的研究

  10. The Application of Modularity Design in the Pulse Oximeter

    模块化设计在脉搏血氧监护仪中的应用

  11. Comparison of transesophageal arterial blood oxygen saturation monitoring and finger pulse oximeter

    手术患者经食道监测血氧饱和度和指端脉搏血氧测定法的比较

  12. It successfully resolves the problems in sensitivity and stability of the oximeter .

    它成功地解决了饱和度监测仪的灵敏度和稳定性的问题;

  13. The Influence of Probe Geometry on the Sensitivity of Tissue Oximeter Using near Infra-red Spectroscopy

    传感器几何结构对近红外组织氧合检测仪灵敏度的影响

  14. Objective To study and consider the value of arterial blood gas analysis and pulse oximeter in medical thoracoscopy .

    目的研究动脉血气及脉搏氧饱和度监测在开放式胸腔镜术中的应用价值。

  15. This paper mainly discussed measuring principle of noninvasive oxygen saturation and the design of a kind of pulse oximeter .

    本文介绍无损伤血氧饱和度测量的原理和实用算法,以及脉搏式血氧饱和度仪的设计。

  16. In order to meet the need of family community , this paper is to design a portable non-invasive pulse oximeter .

    本文旨在设计一种适用于家庭社区的便携式无创脉搏血氧饱和度测量仪。

  17. The Noninvasive Tissue Oximeter Using Near Infrared Spectroscopy ( NIRS ) is First Developed and Clinically Used in China

    我国首次研制出近红外组织血氧参数无损监测仪应用于临床

  18. The development of a noninvasive pulse oximeter

    无创伤脉搏血氧测定仪的研制

  19. Determine client-specific site appropriate to place pulse oximeter probe by measuring capillary refill .

    测定毛细血管再充盈情况,决定特定病人脉氧仪探针放置部位。

  20. Software method for extracting photoplethysmography in pulse oximeter

    脉搏血氧仪中光电容积脉搏波的软件检出方法

  21. Transmission pulse oximeter has been used widely in clinical and family health care which can realize non-invasive oxygen saturation detection .

    脉搏血氧饱和度检测仪可以实现血氧饱和度的无创检测,在临床和家庭保健中广泛使用。

  22. Because maximal total light absorption corresponds to a pulse , the pulse oximeter also provides a figure for pulse rate .

    因为最大的总光吸收与脉搏相对应,因此脉博血氧测定仪也提供了脉率的图形。

  23. Pulse oximeter is a reliable , noninvasive , convenient instrument for continuous monitor of arterial oxygen saturation .

    脉搏血氧仪是一种可连续、无创、方便地检测动脉血氧饱和度的仪器。

  24. Pulse Oximeter Module for Multiparameter Monitor with MSP430 Microprocessor

    基于MSP430超低功耗处理器的监护仪脉搏血氧模块

  25. The study of digital pulse oximeter recorder and its parameters for the diagnosis of sleep apnea syndrome temporal memory recorder

    记忆式脉搏血氧饱和度仪及参量筛选睡眠呼吸暂停综合征的研究数字存储记录器

  26. Method SpO 2 values showed on two kinds of pulse oximeter were recorded when withdrawing arterial blood to make blood gas analysis .

    方法在抽取动脉血作血气分析的同时,读取两种脉搏氧饱和度仪显示的SpO2值。

  27. This paper introduces a kind of pulse oxygen saturation calibrator , which can calibrate the output of oximeter exactly .

    本文介绍了一种脉搏式血氧饱和度仪校准仪的研制,这种校准仪可以检测血氧仪的工作状态是否正常,并能对血氧仪的输出参数进行校准。

  28. The pulse oximeter measuring system was used to do frequency domain analysis for pulse signals of 67 patients with hypertension disease and 66 healthy persons .

    采用光电容积脉搏血氧饱和度检测系统对67例高血压病人采集的脉搏波信号进行了频域分析,并和66例正常人进行对比分析。

  29. The design of an OEM module-based hand-hold pulse oximeter

    基于OEM模块的掌上型脉搏血氧仪

  30. Reflectance detecting system is calibrated when the system design and debugging was finished . The paper uses the pulse oximeter simulators for equipment calibration .

    在完成了系统设计和调试之后,采用脉搏血氧仿真器进行仪器定标。