首页 / 词典 / good

5V

5V5V
  1. Power supply unit provides ± 5V and + 3.3 voltage .

    电源供给单元提供±5V和+3.3电压。

  2. Inference mode study in CAPP expert system for 5v cylinder head

    发动机五汽门缸盖CAPP专家系统的推理模式研究

  3. How to Get + 5V Power Source from RS 232 Interface

    从RS232口获取+5V电源

  4. Research on 5V Active Carbon Based Super Capacitor

    5V型活性炭基超电容器的研制

  5. The design of mixed 3.3V and 5V voltage system with MSP430 family

    MSP430系列单片机在3.3V与5V混合电压系统中的设计

  6. In addition , the optical fiber transmission system needs 5V , which is also provided by the laser power supply system .

    另外,光纤传输系统供电(5V)也是由激光供电系统提供的。

  7. Design of a 5V , 14-bit high speed digital-to-analog converter for telecommunication applications

    一种应用于通信设备的5V14位高速数/模转换器

  8. The Orginal Design of the Direct Current Voltage-Stabilized Power Supply High efficiency , 5V Linear , Regulator

    直流稳压电源初步设计高效5V线性稳压电源

  9. Design bases on a standard 0.6 - μ m N-WELL CMOS process , 5V supply .

    设计基于标准0.6μmN-WELLCMOS工艺,5V供电。

  10. Acceleration Fatigue Life-Span Test to 5V Multibelt of Pumping Unit and Its Reliability Analysis

    抽油机联组5V带疲劳加速寿命试验及可靠性分析

  11. A type of - 12 ~ - 5V / 400mA regulated power supply

    一种-12~-5V/400mA稳压电源

  12. A 5V complementary-SiGe BiCMOS technology on SOI for ultra-high speed precision analog circuits

    超高速高精度模拟电路SOI上的5V互补SiGeBiCMOS技术

  13. Introduce a kind of true single-ship modem - 73M2901C / 5V

    介绍一种真正的单芯片MODEM-73M2901C/5V

  14. This paper introduced the problem of MSP430 family which contracted with 5V system IC . And also analysed it , so provided several solutions .

    本文介绍低电压供电的MSP430系列单片机与5V供电的器件接口时所产生的逻辑电平的不匹配问题,分析了产生原因,并提供了相应的解决方案。

  15. Under 5V dc supply , the sensitivity of the sensing mode is 27.45 mV / g_n theoretically .

    5V条件下,陀螺检测部分的理论灵敏度达到27.45mV/gn。

  16. Considering the larger power consumption of gas sensors array , paper designs the heating control circuits with constant 5V and 15W maximum output power .

    考虑到气体传感器的功耗较大,论文设计了输出电压恒定为5V、最大输出功率为15W的传感器阵列加热控制电路。

  17. The unused inputs are tied to + 5v .

    把空的输入端连接到+5伏。

  18. Especially , both master and slave chips could be realized with 5V standard CMOS process , which makes low voltage processes managing high voltage applications possible .

    特别的是,子片与母片均可用低压5V标准CMOS工艺实现,使低压工艺管理高压应用成为可能。

  19. 5V class spinel LiNi_xMn_ ( 2-x ) O_4 positive film electrodes for all-solid-state lithium battery

    5V类尖晶石LiNixMn(2-x)O4正极薄膜及其在薄膜锂电池中的应用

  20. A 14-bit , 4 MHz sampling precision sample-and-hold circuit with 5V supply for SAR ADCs was designed .

    设计了一个用于SAR结构的模数转换器的采样保持电路,采用5V供电具有14bit的采样精度和4MHz的采样频率。

  21. Finally , experimental results on a12V / 5V / 2.5A prototype are found to be nearly in accordance with the theoretical results .

    最后,文中设计了一台12V/5V/2.5A降压式谐振开关电容变换器样机,实验结果验证了本文的理论分析结果。

  22. The ramp voltage less than 0 . 5V will be displayed after amplification . The circuit can be used as display unit for various electrochemical instruments .

    小于0.5伏的三角波电压经放大后再显示,该电路可作为各种电化学仪器的显示单元。

  23. Result from emulate and testing indicates the meter can measure voltage with a range from 0 to 5V and a resolving power 0.02V .

    仿真及硬件测试表明:数字电压表能测量和显示0~5V电压,测量精度为0.02V。

  24. When there were some impurities in detection area , the voltage comparator would put out 5V voltage , driving follow-up circuits to give sound-light alarm .

    当探测区域内存在杂质时,电压比较器输出5V电压,驱动后续电路发出声光报警。

  25. We fo - und that performance of cells is improved by reverse-biased voltage from 3 to 5V at room temperature for 30 min.

    发现在室温下进行3~5V、30分的反偏压处理能改善电池的性能。

  26. If the absolute value is greater than 0 . 5V but less than 2 . 5V , the ramp voltage will be displayed directly .

    绝对值幅度大于0.5伏小于2.5伏的三角波电压直接显示;

  27. According to the initial position we get a feedback signal which will be transformed to a simulated signal output of 0 ~ 5V or 4 ~ 20mA .

    找到边缘位置后,根据板带的初始位置计算偏移量,系统将计算获得的偏移量转化为0~5V或者4~20mA的模拟信号输出给板带纠偏执行系统。

  28. When the voltage is 5V and the current is 2.2A , the surface quality of magnesium alloy ( AZ31B ) is the best .

    当电压为5V,电流为2.2A时,切割面质量最好。

  29. After simple liquid level sensor signals can be voltage signal , transforming the voltage signal is0 ~ 5V , back to the transducer of the VR1-side .

    经过简单液位传感器信号的转换,便可得到电压信号,转化的电压信号为0~5V,反馈给变频器的VR1端。

  30. The power supply is available in the range of several A to several KA busbar current and provides 5V 、 100mA to the equipment of HV side .

    该电源适用于母线电流数A至数千A的变化范围,为高端设备提供5V、100mA的电源。