100c

The temperature reaching 100C , the water boils .

温度达到摄氏100度，水就沸腾。

Liquid water is still hydrogen bonded at 100C as indicated by its high heat of vaporization and dielectric constant .

由于蒸发比热及绝缘系数较高，液态水在100℃时仍然存在着氢键。

The flash point was above 100C and the density was higher than 0 # diesel by 10 % in physical characteristics ;

在物理特性方面，其闪点在100℃以上，密度比0~柴油高10%左右；

The solidification microstructure is refined and well distributed when Al-12 % Si alloy is superheated in the temperature range of 750-1 100C .

共晶Al-12%Si合金在750-1100℃温度范围的熔体温度处理实验结果表明：凝固组织随过热温度的升高总体上呈现出细化、均匀的趋势；

When crystallization temperature is 80C , the gel keep amorphous , however when it is 100C , some NaY would turns to P zeolite .

当晶化温度为80℃时，反应凝胶依然保持无定形。

The iPhone 6 and 6S models are similar to Shenzhen Baili 's little-known 100C phone , the authority ruled .

当局裁定，iPhone6和6S型号与深圳百利公司鲜为人知的100C手机相似。

According to a statement from the Beijing Intellectual Property Office , Apple infringed on a design patent used in a phone called the 100C , made by the Chinese phone maker Baili .

北京市知识产权局发布的一则通告称，苹果侵犯了中国手机生产商佰利生产的100C手机使用的一项设计专利。

The results indicated that the excellent factors and levels are added 12 . 5 % alum , 100C , 4 h and need not rinse with water . The temperature is the key factor ;

实验结果表明天南星的最佳炮制条件为：加白矾12.5%、加热100C、不水漂、加热4h，其中加热时间为关键因子；

By using these methods the static error and phase shift at 100c / s can be reduced to 0.1 V ( for input and Output ranges between ± 100 V ) and 2 ° respectively .

这些方法的实现，可将乘法器的静态误差电压减小到0.1伏（满刻度变化为±100伏），并将两个乘量通道的频率特性在100周时的相移减小到2°。

Gas cylinders are protected from rupture due to fire by a frangible disc sometimes backed by a fusible metal with a melting temperature of about212F ( 100C ) .

用破裂盘，有时后候后面还有一个熔化温度为212F（100C）易熔金属，来保护气体钢瓶，防止由于起火而破裂。

The experiment results show that the effect of superheating temperature on secondary dendrite spacing is unnoticeable when Al-7 % Si alloy is superheated in the temperature range of 750-1 100C . Dendrite morphologies become well distributed with the increase of superheating temperature .

实验结果表明：亚共晶Al-7%Si合金在750-1100℃进行熔体温度处理时，过热温度对二次枝晶的细化作用不明显，而组织的均匀性随着过热温度的升高而变好；